(ii) Find the unknown currents, i1, iz, iz and i, in the given circuit. A = 3 A, lg = 11 A, Ic = 26 A, Ip = 17 A and Ie = 12 A %3D lot let 12 le

Q: Ex2:-Two infinite line current 2ãy A at x = z = 4 and I2 = 4äx at y=3, z =-6. Calculate %3D H at…

A: By using the formula we can easily find the value of H. Magnitude of H = I/2πd I is the current…

Q: Question 29 Region 1 (z 0) is characterized by ɛr2 = 4. Let E2 = -30ax + 50ay + 70az V/m, then…

A:

Q: H.w. using Branch curren b method Determine II,, Ío, Iz in Fig CI) i 30 (o I,

A: The solution is as follows.

Q: Pls help ASAP. The subject is Electric Networks

A: Given:  Brief description: In the above question they have mentioned an electrical circuit which is…

Q: A) Check whether the following systems are: 1. Static or dynamic 2. Lincar or non-linear 3. Causal…

A: Dear student as per our guidelines we are supposed to solve only one question in which it should…

Q: او QlDcx 2 wire, Gads of loo, 150, 200, and So A- situated Soo, 1000, 1600- 2000m, from the supply.…

A: In this question we need to find a voltage at each segment of the given distribution system.

Q: 5 A Moving to another question will save this Pes Question 1 4 points Save Answer For the circuit…

A:

Q: 2 3.) Find the resistance 16 of the diameter the conductor ys 30 fransmission line it 0.8 cm. the…

A: The diameter of the 3-ϕ transmission has given as,d=0.8cm,d=0.008m,Rediusr=0.004m,Length of the…

Q: + Is Iz iven Vs = 25 V, Rs = 227 Q, Vz = 15 V, Pzmax = 405 mw Solve for IL, Iz, Is when RL = 385 Q…

A:

Q: The ohms per 1000 feet measurements for conductors can be found in _____. Select one: a. article…

A: The obstruction offered to the smooth flow of current is called resistance. The electrical element…

Q: The maximum safe currents for insulated wires of various diameters are given below. Which wire gauge…

A:

Q: Find the current I1, I2, 13. 18 2 b 3 I:1 6. 9V. I 3 V a d.

A:

Q: Using MESH ANALYSIS or Maxwell Method, find the power consumed by each of resistances and determine…

A:

Q: 8.) The ampacity of a 38 mm2 THW, Aluminum, 75 ⁰C rated conductor supplying a motor circuit at a 50…

A: Given: Conductor size, A=38 mm2 Rated conductor temperature is 75⁰ C. Temperature of location is…

Q: Q IV: is this expression standard? if not write the standard one BC AB + ABC + ABCD + ABCD + ABCD…

A:

Q: 8. If a load is a 23KW 10, 240Vac, and you have THHN 90°C Copper conductors, what size will they…

A: Calculate the current flowing through the load,

Q: ): (a) Long-distance, electric- 4. Conceptual Part (Under WW) [Chapter 25 - Ohm's Law] power,…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: 1. A copper wire 100 m long must experience a voltage drop of less than 1.5 V when a current of 2.5…

A:

Q: 3- Let ur1 = 2 in region 1, defined by 2r+3y-4z > 1, while µ2 = 5 in region 2 where 2r+3y-4z < 1. In…

A:

Q: 3. Using MAXWELL'S MESH ANALYSIS, determine the following mesh currents: a) I1 Also, determine the…

A:

Q: QUESTION 2 SOALAN 2 a) Calculate the current IT using Delta Star Transformation for the circuit in…

A:

Q: 2. SOLVE (A)It (B)I2 USING MAXWELLS METHOD 102 ww 20V 30V 土 II GOV 等20 4. 著30 ww 122 ASSUME LOOPI…

A:

Q: EXAMPLE 2 For the network shown in the Figure determine: a) Determine re. b) Determine Z¡, Zo and A,…

A:

Q: I am needing assistance calculating VT, VR1, VR2, VR3, IT, and RT for the attached AC circuit.

A: Given data: 3Vrms=Vm2R1=1 kΩR2=3 kΩR3=4 kΩ Vm=2×3=4.24 V VT=Vm The expression for the voltage across…

Q: 2. (a) Find the equivalent resistance across terminal AB, Rab 30 Ω 25 2 10 2 20Ω 15 Ω b- (b) i.…

A: a) to find the equivalent resistance across terminal AB, Rab b) i) three pure resistances of value…

Q: 1 (a) Using Townsend's second ionization criterion, consider I, = 4 × 10-7 A. Consider a = 2.28/cm.…

A: Given Io=4×10-7 Aα=2.28 cm-1γ=0.0075 As per Townsend's second ionization criterion, the gap spacing…

Q: Q2: Draw the single line diagram of a substation having the following equipments: (1) Incoming…

A: To design the High voltage substaion, ultra fast protecting device should be used. Isolation between…

Q: determine current I_1 (use Mesh (method

A:

Q: With solution please.

A: This question be solved as shown below.

Q: Q3: Determine whether the system beie w (ai memoryless, (b) causal, (c) linea (d) time-invariant,…

A: Given system : y(t)=x(t) sin (ωt) a) Here system output does not depends on past value . Therefore…

Q: Using Maxwell’s (mesh) Loop method, determine the mesh currents I1, I2, I3.

A: Using mesh loop method we have to find the current I1,I2 and I3 for the given circuit

Q: ing Portal Courses Reports Vices www A A=A mmeter V = Vo Itmeter R= Resistor B = Battery K= Key 上二…

A: For verification of ohms law we use a experimental setup as used in this question

Q: Question 16 1.25 points Save Answer Region 1 (z 0) is characterized by ɛr2 = 4. Let E2 = -30ax +…

A:

Q: A 300 V (line) 3 - phase supply feeds a star – connected load consisting of non - inductive…

A: In the given question the source is balanced with line voltage magnitude given as 300V.The voltage…

Q: For the circuit shown, calculate the magnitude of line current at line Aa. TAG EAB = 208 V 0° ECA =…

A:

Q: 5. Solve for V using Maxwell's Mesh method. R2 3 1kQ R1 1 12 R3 1A 1A 1k2 1k2

A: Find voltage across resistors using mesh method ?

Q: 1.62 Determine the currents I,, I2, I, and I.

A: When elements are connected in parallel then the voltage across these elements is the same.

Q: 3. a. Calculate the total impedance of the following circuit, and hence calculate ir b. Using…

A: It is given that: L1=2H=2ΩC1=3F=3ΩR1=6 ΩV=4 volt

Q: Using Maxwell's (mesh) Loop method, solve for the following. Show neat, logical and systematic…

A:

Q: 1. A 2-wire d.c. distributor A B is fed at both ends at the same voltage of 230 V. The length of the…

A: I have explained in detail

Q: W 5.00 X 13 10.0V, 0.500 6.0V, 0.100 4.00 5.00 N 8.0V, 0.300 ||² Z

A:

Q: 3.4 Del Operator 69 FIGURE 3.12 For Practice Exercise 3.2, L is a closed path. L 60 PRACTICE…

A: Circulation of vector A around edge L =∮A.dl  So calculate line integration for three sides and than…

Q: Q1:- Practice Problem a. Write the nodal equations for the circuit shown; and solue for the nodal…

A:

Q: R1 R1 Et R2 3R3 igure Altermative Link:…

A:

Q: 1.a. Line voltage usually differs from control voltage because A. line voltage is usually lower. B.…

A: Line voltage- up to the point of transformation or utilisation, the voltage of a power transmission…

Q: Person comes into contact with the incoming and return conductors of a GFCI-protected circuit, as…

A: Vs=124VHere, 20kΩ and 30kΩ are in parallel

Q: -1 3. Question 4 Let A = psinø a,+p' as. Evaluate pA dl given that L is the path shown in the…

A: given A= psinϕap + p3 aϕ To verify answer using stoke's theorem

Q: Using Maxwell's (mesh) Loop method, solve for the following. Show neat, logical and systematic…

A:

Q: ا مجير طال 01. Select the correct answer 1 The thickness of the layer of insulation on the…

A: Since you have posted the questions with multiple subpart so we are supposed to answer 3 subpart.