If a 1300 kg car can accelerate from 35 km/h to 60 km/h in 3.6 s, how long will it take to accelerate from 60 km/h to 95 km/h ? Assume the power stays the same, and neglect frictional losses. Express your answer to two significant figures and include the appropriate units. t₂ = Value Submit Request Answer ? Units

If a 1300 kg car can accelerate from 35 km/h to 60 km/h in 3.6 s, how long will it take to accelerate from 60 km/h to 95 km/h ? Assume the power stays the same, and neglect frictional losses. Express your answer to two significant figures and include the appropriate units. t₂ = Value Submit Request Answer ? Units

College Physics

1st Edition

ISBN:9781938168000

Author:Paul Peter Urone, Roger Hinrichs

Publisher:Paul Peter Urone, Roger Hinrichs

Chapter7: Work, Energy, And Energy Resources

Section: Chapter Questions

Problem 41PE: (a) How long would it takea 1.50105 -kg airplane with engines that produce 100 MW of power to reach...

See similar textbooks

Similar questions

(a) How long will it take an 850-kg car with a useful power output of 40.0 hp (1hp=746W) to reach a speed of 15.0 m/s, neglecting friction? (b) How long will this acceleration take if the car also climbs a 3.00-m-high hill in the process?
Give an example of a situation in which there is a force and a displacement, but the force does no work. Explain why it does no work.
A person in good physical condition can put out 100 W of useful power for several hours at a stretch, perhaps by pedaling a mechanism that drives an electric generator. Neglecting any problems of generator efficiency and practical considerations such as resting time: (a) How many people ‘would it take to nm a 4.O0-kW electric clothes dryer? (b) How many people would it take to replace a large electric power plant that generates 800 MW?
(a) What is the average useful power output of a person who does 6.00106J of useful work in 8.00 h? (b) Working at this rate, how long will it take this person to lift 2000 kg of bricks 1.50 m to a platform? (Work done to lift his body can be omitted because it is not considered useful output here.)
A 100 — kg man is skiing across level ground at a speed of 8.0 m/s when he comes to the small slope 1.8 m higher than ground level shown in the following figure. (a) If the skier coasts up the bill, what is his speed when he reaches the top plateau? Assume friction between the snow and skis is negligible. (b) What is his speed when he reaches the upper level if an 80 — N frictional force acts on the skis?
Integrated Concepts (a) What force must be supplied by an elevator cable to produce an acceleration of 0.800 m/s2 against a 200-N frictional force, if the mass of the loaded elevator is 1500 kg? (b) How much work is done by the cable in lifting the elevator 20.0 m? (c) What is the final speed of the elevator if it starts from rest? (d) How much work went into thermal energy?
(a) How long would it takea 1.50105 -kg airplane with engines that produce 100 MW of power to reach a speed of 250 m,/s and an altitude of 12.0 km if air resistance were negligible? (b) If it actually takes 900 s, what is the power? (c) Given this power, what is the average force of air resistance if the airplane takes 1200 s? (Hint: You must find the distance the plane travels in 1200 s assuming constant acceleration.)
(a) Find the useful power output of an elevator motor that lifts a 2500-kg load a height of 35.0 m in 12.0 s, if it also increases the speed from rest to 4.00 m/s. Note that the total mass of the counterbalanced system is 10,000 kg—so that only 2500 kg is raised in height, but the full 10,000 kg is accelerated. (b) What does it cost, if electricity is $0.0900 per kW h?
A sled of mass 70 kg starts from rest and slides down a 10 incline 80 m long. It then travels for 20 m horizontally before starting back up an 8° incline. It travels 80 m along this incline before coming to rest. What is the magnitude of the net work done on the sled by friction?
Integrated Concepts (a) Calculate the force the woman in Figure 7.46 exerts to do a push-up at constant speed, taking all data to be known to three digits. (b) How much work does she do if her center of mass rises 0.240 m? (c) What is her useful power output if she does 25 push-ups in 1 min? (Should work done lowering her body be included? See the discussion of useful work in Work, Energy, and Power in Humans. Figure 7.46 Forces involved in doing push-ups. The woman's weight acts as a force exerted downward on her center of gravity (CG).
(a) What is the power output in watts and horsepower of a 70.0-kg sprinter who accelerates from rest to 10.0 m/s in 3.00 s? (b) Considering the amount of power generated, do you think a well-trained athlete could do this repetitively for long periods of time?
Which of the following is a unit of work? (4.1) (a) W (b) J s (c) N/s (d) N m