A.OYou added 10.0 M HCl solution instead of the 6.0 M HCl solution. Note: the amount of acidic solutionadded is the same.BOA little bit of zinc solid was stuck on the side of the test tube and did not react with the acid.Co A big chunk of zinc of the same mass was used instead of granular zinc. Note: the amount of time todissolve the big chunk of zinc was much longer, but it did completely dissolve. How would the following sources of error effect the value of R you determined in your experiment? High/Low/No Effect. Clearly explain your choice!

R value can be calculated using the volume of H2 gas produced at a given temperature and pressure.…

Answered: How would the following sources of…

How would the following sources of error effect the value of R you determined in your experiment? High/Low/ No Effect. Clearly explain your choice!

Fundamentals Of Analytical Chemistry

9th Edition

ISBN:9781285640686

Author:Skoog

Publisher:Skoog

Chapter27: Molecular Fluorescence Spectroscopy

Section: Chapter Questions

Problem 27.9QAP

See similar textbooks

Related questions

Q: The fuel used in many disposable lighter is liquid butane, C4H10. How many carbons atoms (C) are in…

Q: 1. Compute for the Molecular Weight, Eq. Wt, GEW, mEq and GmEq for every 200 grams c. Phosphoric…

A: Molecular weight: Molecular weight is the sum of the atomic masses of all atoms in a molecule.…

Q: 6. Identify each of the following compounds as aromatic, antiaromatic, or nonaromatic, assuming…

A: 6. We have to identify the given molecules as aromatic, anti-aromatic, or non-aromatic.…

Q: Synthetic polymers are produced via two primary reaction schemes: addition (or chain-growth)…

A: Given information is synthetic polymers are produced via two primary reaction scheme: addition (or…

Q: 8. It is sometimes said, "A noble gas configuration is especially stable so atoms or ions with such…

A: Noble gas configuration is more stable due to completely filled orbital. In case of Na+ = 1s2 2s2…

Q: Determine the initial volume. 12.0 L of 0.45 m solution from 2.9 m solution.

A: Given, Final volume, V2 = 12.0 L Final concentration, S2 = 0.45 m Initial concentration, S1 = 2.9…

Q: OCl, 0.0114 g of NO, and 0.0533 g of Cl2. (a) Calculate KP for this reaction at this…

A: NOCl decomposes as below 2 NOCl(g) -------------> 2 NO(g) + 1 Cl2(g) Given at equilibrium , 5-L…

Q: Describe at least one affordance and one limitation of the representations below. In other words,…

A: An organic compound has one chemical formula. However, structurally it can be represented in many…

Q: Rank the following compounds in order of decreasing strength of intermolecular forces, starting with…

A: 1. Intermolecular forces is force that exist in a molecule. 2. Intermolecular force are hydrogen…

Q: The length of a pencil is measured with two rulers. Report the length of the pencil from each ruler…

Q: Draw the Line Bond Structure for carbon disulfide (CS₂) Step 1: Count the total number of valence…

A: In this question, we have to answer for all the steps.

Q: When 224. mg of a certain molecular compound X are dissolved in 30. g of benzonitrile (CH-CN), the…

A: When 224 mg of compound dissolved in 30 g of benzonitrile, we need to calculate molar mass of that…

Q: What is the energy change when the temperature of 12.9 grams of solid tungsten is decreased from…

A: Specific heat capacity: Amount of heat or energy needs to be added to a material in per unit mass to…

Q: If a compound has a log Kow value of 6.5, what would be its predicted concentration (in ppm) in the…

A: The octanol-water coefficient (Kow) is defined as the ratio of chemical concentration in the octanol…

Q: Consider the reaction R P. Check all of the following that are true when a catalyst is added to the…

Q: Draw the Newman projection as shown below. Only rotating the front carbon clockwise (120 degrees at…

Q: #1 In the oil/water system shown below, there are two fluids of density 0.7 g/cm³ for oil and 1.0…

A: A question based on properties of liquids that is to be accomplished.

Q: How many grams of H2 are needed to prodeuce 12.64g of NH3? Express your answer numerically in grams

Q: Identify the modes of catalysis and when / why they occur • Acid-base • Covalent • Transition state…

A: As per the rules, only the first three sub-parts can be answered. Please re-submit the question for…

Q: Arrange the following bonds in order of increasing polarity using the periodic trends in…

A: The given bonds are C-F, C-C, C-Cl, and C-I. The electronegativity table is: Element…

Q: How many grams of NH3 can be produced from 2.73 mol of N2 and excess H2. Express your answer…

Q: ¹CI₁ ¹CI₁

A: The given organic structure is

Q: As Hagrid (Harry Potter fans, rejoice!) says, wizard money is very easy to understand. There are…

A: Given -> Three coins -> knuts , sickles,galleons -> 1 sickle = 29 knuts -> 1 galleon =…

Q: HOOC NH₂ NO₂ i) SOCI₂/MeOH ii) NaBH4/EtOH OH NH₂ NO₂

A: Acid chloride are strongly electrophilic in nature due to the presence of strongly electron…

Q: KCIO; decomposes to KCI and Oz as shown below. In one experiment 0.312 g of Oz was formed. Assuming…

Q: Which of the following descriptions of a sigma bond (according to valence bond theory) is NOT…

A: Sigma bond:- It is formed when two adjacent hybrid orbitals do a head-on overlapping. There can be…

Q: a. If the hydrogen ion concentration in a solution is 8.63 x 10 mol/L, the pH is b. If the pH of a…

A: pH = - log [H+] and [H+] = 10-pH

Q: Instructions: Compute for the following problems stated below. Express your final answer into 4…

A: Molecular weight is calculated by adding the atomic masses of all the atoms present in the molecule.…

Q: 31) A woman receives 1280 g of type A blood. If the blood has a density of 1.06 g/mL, how many…

Q: The choices are A, B, C, D, and E. Consider the three compounds shown below and then answer the…

Q: A flask contains 0.200 mol of liquid bromine. Br2. Determine the number of bromine molecules present…

Q: 6.8 g H2O Express your answer in molecules to two sinificant figures

Q: Why is organic chemistry considered the chemistry of carbon compounds?

A: Chemistry is branch of science that involves study of chemical composition of substances. There are…

Q: How many moles are there in 17.2 g of FeF 3 : Answer to 2 decimal places and include the unit .

Q: Consider this initial rate data at a certain temperature in the table for the reaction OCI (aq) +…

A: For the first question, we have to find the rate law and the rate constant from the given data. For…

Q: Hydrocarbon Structure Activity Part I: Hydrocarbon Structures and Names. INSTRUCTIONS: For each row…

A: Given is hydrocarbon molecules.

Q: Determine the most likely charge on an ion from an element in group 15 (the group headed by…

A: We are required to determine the charge on an ion from an element in group 15

Q: Write a short notes on trans effect and its heories.

Q: How Many total are in the Molecule бума (0) and pi (1) Boods How Many sp³ hybridized carbon atoms…

A: In this question, we have to answer total number of Sigma and pi bonds are present in the given…

Q: Part III. Preparation of 50 mL 0.2M CuSO4 solution Materials: CuSO4-5H₂20, weighting paper, spatula,…

Q: Part I: Line Bond Structures Instructions: After looking at the examples on page 2 and 3, complete…

Q: Predict what would happen to salt water if you boil it for a long period of time. Include in your…

A: Salt water is a homogenous solution of salt and water where the solute and solvent do not react with…

Q: 1. Calculate the heat of combustion of propanol (C3H8 O) and the percent error in the following…

A: mass of water = density * volume = 1.00 g/ml = 100.0 ml = 100.0g specific heat of water = 4.184 J/g…

Q: Carbon and graphite are allotropes of Carbon. Between graphite and diamond, which one is a good…

Q: A mixture of 0.08069 mol of C2H4, 0.04804 mol of N2, 0.06868 mol of NH3, and 0.1210 mol of C6H6 is…

A: The given data is as follows, the mol of C2H4 = 0.08069 mol the mol of N2 = 0.04804 mol the mol of…

Q: H Gitt H H H I -N. N H

Q: 5. For the reaction below: ? CH3CH2OH + H₂O = : a. Draw the products of the reaction assuming the…

A: A question based on equilibrium concept that is to be accomplished.

Q: In order of the electronegativity, why why F > O > Cl > N > Br > I > S > C > H > metals?

A: It is defined as the ability of atoms to attract a pair of electrons towards themselves in a shared…

Q: Several conformations of this molecule are shown below. Which of the following Newman projections is…

A: The concept used in this question is from stereochemistry chapter of organic chemistry. Stability…

Q: What is the mass of (5.00x10) number of calcium atom? Report your answer to 3 significant figures…

A: Given -> Number of Ca atom = 5.00 × 10 = 50.0 atoms

Question

A.O
You added 10.0 M HCl solution instead of the 6.0 M HCl solution. Note: the amount of acidic solution
added is the same.
BOA little bit of zinc solid was stuck on the side of the test tube and did not react with the acid.
Co A big chunk of zinc of the same mass was used instead of granular zinc. Note: the amount of time to
dissolve the big chunk of zinc was much longer, but it did completely dissolve.

How would the following sources of error effect the value of R you determined in your experiment? High/Low/
No Effect. Clearly explain your choice!

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Step 5

Step by step

Solved in 5 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Sample Preparation in Analytical Chemistry

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, chemistry and related others by exploring similar questions and additional content below.

Similar questions

What impact would using a much smaller sample have on the accuracy of your results
based on the data from the experiment, how do i calculate the percentage of error? also, how do i explain about the observation.
What are the differences between systematic and random errors and how do they effect accuracy and precision? In what circumstances would you use standard addition (versus a normal calibration curve) to determine the amount of an analyte in a sample? A urine sample, containing analyte Z is analysed by the standard addition method where 5 mL of the original sample was mixed with increasing amounts of a Z standard and each solution diluted to a volume of 50 mL prior to analysis. A plot of the final concentration of the standard in each of the 50 mL samples (x axis) versus The measured signal from the analysis of each 50 mL sample (on y axis) produced a straight line with the general equation: y = 44.72x + 4.06 what was the final concentration of Z in the 50 mL standard addition sample? what was the initial concentration of Z in the original urine sample?
In a particular trial, a student got a value for R of 0.083. Calculate the percent deviation of this result. Enter a number without the % sign. The percent deviation should be reported as a positive value.
Please confirm if my answer is correct or not. Due to the need for this to be correct I would like you to provide me with a confidence score in you answer on a scale from 1 to 10 how confident are you in your answer. Please be sure to double check your answer
7. A piper delivers 10.4 mL , 10.2 mL, 10.8 mL , and 10,6 mL consecutive trials . Find the mean volume and average deviation from the mean.
Student A determines the percent acetic acid in their sample to be 4.31% and they report a standard deviation of 0.57. Student B also reports a value of 4.31 % acetic acid, with a standard deviation of 1.2. Which student (A or B) has the more reliable determination? Briefly, 1 - 2 sentences,
The spectroscopic data in the table is generated with five solutions of known concentration. Concentration (M) 0.0133 m= 0.0266 0.0532 0.106 0.213 Absorbance 0.1271 What is the intercept of the linear regression line? 0.08531 0.5388 1.069 Use a spreadsheet program, such as Microsoft Excel, to graph the data points and determine the equation of the best-fit line. 1.954 What is the slope of the linear regression line formed by these points? M-1
For items 7-8 choose the letter of the best answer. No need to write the explanations.
Need help with number 4. Theses are pre lab questions and not homework. Was rejected once and unsure why. Pre lab means before the actually lab we do (which that part is graded) Thanks
Please answer 8 and 9 both.
Assuming that an experiment's results are 10.1, 10.4 and 10.6, find the mean, the average deviation from the mean and the standard deviation. You can use Excel to verify your calculation. Use the editor to format your answer