H.W: suppose that a team of three parachutists are connected by a weightless cord while free falling at a velocity of 5 m/s. Using Gauss Elimination Method calculate the tension in each section of cord and the acceleration of the team, given the following information: 3 Parachutist Mass Kg(m) Drag Coefficient Kg/s (c) a 1 70 10 2 60 14 3 40 17 1 Hint: The equation of motion can be determine from Newton's Second Law (F= ma). mig-T-c₁v=m₁a m₂g+T-R-C₂v = m₂a m3g+ R-C3v = m²a R T 2

H.W: suppose that a team of three parachutists are connected by a weightless cord while free falling at a velocity of 5 m/s. Using Gauss Elimination Method calculate the tension in each section of cord and the acceleration of the team, given the following information: 3 Parachutist Mass Kg(m) Drag Coefficient Kg/s (c) a 1 70 10 2 60 14 3 40 17 1 Hint: The equation of motion can be determine from Newton's Second Law (F= ma). mig-T-c₁v=m₁a m₂g+T-R-C₂v = m₂a m3g+ R-C3v = m²a R T 2

Principles of Heat Transfer (Activate Learning with these NEW titles from Engineering!)

8th Edition

ISBN:9781305387102

Author:Kreith, Frank; Manglik, Raj M.

Publisher:Kreith, Frank; Manglik, Raj M.

Chapter5: Analysis Of Convection Heat Transfer

Section: Chapter Questions

Problem 5.19P: 5.19 Suppose that the graph below shows measured values of for air in forced convection over a...

See similar textbooks

Similar questions

Given: The plane accelerates in its current trajectory with a= 100 m/s^2 Farag Angle theta= 5° W=105 kips F_drag= 80 kips m= 1000 lbs Find: F_thrust, F_lift Please include the KD. Fthrust Futel t Fueight 000 BY NC SA 2013 Michael Swanbom
3. In the study of aerodynamic drag on a stationary body, an appropriate non-dimensional grouping has been found to be: QAU3 where, P is the power lost, p is the density of the fluid, A is a typical area, and U is the velocity of the fluid. In laboratory tests with a 1:10 scale model (ratio of the length) at 25°C, the power lost was measured as 5 w when the air velocity was 0.5 m/s. Calculate the power lost in the prototype (kW) at 25°C when the air velocity is 1 m/s.
L. y X VA A VB PLANE OF CONTACT BY UBC Engineering On an air hockey table, two pucks of identical mass collide in the middle of the rink. Puck A had an initial m velocity vA 1.9? and puck B had an initial velocity vB = 3.2j The plane of contact can be thought of as a line angled 0 = 34° above the x-axis. If the coefficient of 0.5 between the pucks, what are the velocities of the pucks after the impact? || m according to the x-y axis shown. restitution is e =
During a bicep curl on a bicep curl machine, I'm curling a weight stack of 100 pounds (single arm...I'm jacked like that). At this very moment, the weight stack has a moment arm of 0.12m, my elbow has an angle of 63deg, my muscle force vector has an angle of 23deg, and it attaches 3cm below my elbow joint on my radius. How much force must my bicep create right at this moment to hold the weight stack in place?
A forensic scientist test-fires a projectile (mass mP) at a cubic block (volume V), made from wood (density D), resting on a rough surface (static = kinetic coefficient uS). The bullet enters the block with an initial velocity vo and exits the block with a velocity v1. The friction forces on the bullet as it passes through the length of the block are unknown and are assumed to be constant. Solve these problems algebraically first: a) What is the deceleration of the bullet inside the block? How many "g" is that? b) How much time does it take the projectile to pass through the block? c) What is the velocity of the block as the bullet exits? d) How long (time) and how far (distance) does the block slide after the bullet has exited? e) Solve the above numerically for the following parameters (g =9.81m/s^2): mP = 10g, V = 0.1m^3, D = 500kg/m^3, µS = 0.8, v0 = 500m/s, v1 = 100m/s
H.W 03: A truck driver was driving at night at 60 Kph on a 1% uphill highway when suddenly a deer jumped in front of his truck. The distance between the vehicle and the deer when the driver started applying the brakes was about 30m. Assume deceleration rate is 3.6 m/s2, (1) will the driver success in stopping before hitting the deer? (2) If not, at which speed the collision will happen?
The figure shows a plot of potential energy U versus position x of a 0.270 kg particle that can travel only along an x axis under the Influence of a conservative force. The graph has these values: UA9.00 ). Uc 20.0 J and Ug 24.0J. The particle is released at the point where Uforms a "potential hill" of "height" Ua 12.0J. with kinetic energy 7.50 J.What is the speed of the particle at la) -3.50m and (b)x - 6.50 m? What is the position of the turning paint on (c) the right side and (d) the left side?
An exuberant 30 lb beagle awaiting dinner jumps to a height of 2.5 feet once every 4 seconds. The beagle continues this for 5 minutes. If the beagle is 20% efficient at converting kibble calories into motion, how many grams of kibble will it need to fuel this activity? Dry canine fare, for the most part, contains roughly 97 Calories for each 1 ounce. From the waste heat, how much (degC) will the beagle's temperature increase (all else equal and no heat loss to the surroundings)? Remember a food Calorie is actually a kcal.
FIRST ORDER LINEAR EQUATIONS TO DYNAMICS A rocket that starts from rest is propelled by a constant thrust of 3000 pounds in a straight horizontal path for 40 seconds. Suppose that, as the propellant is burned, the mass of the rocket varies with time in accordance with m = 50 – t slugs, and that the drag force is numerically equal to four times the velocity. Please answer both parts: a) Find the velocity equation of the rocket (which includes finding C) b) What is the velocity of the rocket when t = 30 seconds?
An object is shot upward from the ground with an initial velocity of 640 ft/sec, and experiencés a constant deceleration of 32 ft/sec² due to gravity as well as a deceleration of (v(t) / 10) ft/sec due to air resistance, where v(t) is the object's velocity in ft/sec. (a) Set up and solve an initial-value problem to determine the object's velocity v(t) at time t. (b) At what time does the object reach its highest point?
1) The first man who studied and partially understood the kinematics of a particle falling in the earth's gravitational field was Leonardo da Vinci (1452-1519). He constructed an apparatus consisting of two vertical boards, hinged together on one side and covered with blotting paper on the inside faces. A leaking water tap lets drops fall down between the boards at presumably equal intervals of time. When a string is suddenly pulled, the boards are clapped together and the positions of the drops on the blotters can be inspected. Suppose that the vertical boards are 3 feet long and the leaking faucet is at such height and the rate of dropping is so regulated that when a drop is just coming out of the faucet, the next or second drop is just at the top of the boards and the sixth drop is at the bottom of the boards, while drops 3, 4 and 5 are between the boards. Calculate the number of drops leaving the faucet per second. ANS. 11.35 drops/sec
The 2nd order ODE given below models the vertical fall of on Object under the influence of gravity and air friction md²y acceleration -mg + (1/2 Co A Pair) (dy) ² Forcing due logranty Forcing due to air friction