Given: VS1 = 14 volts | R1 = 5 kohm | R2 = 7 kohm | R3 = 1 kohm | R4 = 7 kohm What is the voltage at points A to B? A voltmeter is connected at points A&B, with the positive probe at A and the negative probe at B. The answer must be in 2 decimal places. Do not include the unit. Add your answer

Q: An RTD is connected to a quarter bridge circuit with 1200 matched resistors and 10V power supply and…

A: To find the bridge voltage, we first need to calculate the resistance of the RTD at 55°C using the…

Q: 2. Complete the truth table for the following sequential circuit: X JQ KQ D Q C Q OA OB A 0 0 0 0 1…

A:

Q: (a) Determine the value of the voltage VO for Vi = 5 [V]. Obtain the currents and voltages for each…

A: The diode circuit , we need to find the output voltage , current & voltage across diode for…

Q: Implement the logic circuit using only NOR gates.

A: According to the question, for the given circuit as shown below, We need to implement the above…

Q: Assume a flat start and calculate one iteration of Gauss-Seidel. SD₁ = 0.5+ j0.5 SD3 = 0.5+j0.5…

A: Considering bus 2 as a slack bus The given values are – SD1=0.5+j0.5=P1-jQ1SD3=0.5+j0.5=P3-jQ3…

Q: Exercise: Use superposition to find i in the circuit below. 12V 24 V 4Ω 8 Ω 3 Ω 4Ω 3A Answer: i = 2A

A:

Q: VS1 A 3R1 -R2 R3 B R4

A: it is asked to find the voltage VR3 in given circuit

Q: A 6 pole, 50 Hz, 1-phase Induction Motor runs at a speed of 900 rpm. The frequency of currents in…

A: We need to find out cage current frequency for given motor

Q: Problem A: If C1 is reduced, will that improve frequency response of the first stage? Problem B: In…

A: According to the question, for the given digital guitar tuner circuit as shown below We need to…

Q: 3. Problem 7.5 (a), (b) and (d) only (assuming u=μ).

A:

Q: 1. Write a Verilog program for a 3-to8 decoder based on the Truth Table 1. You are not allowed to…

A: Given truth table-

Q: The bases of the system are 66 kV and 20 MVA, the transformers will be treated as impedances in…

A:

Q: Q4) Use source transformation to find i in the following circuit: 2A www 5Ω Μ 5Ω 10 Ω www 4Ω 20 V

A:

Q: Draw the impulse response of the data hold with the input and output shown below. Is this data hold…

A: According to the question, we need to draw the impulse response for the given response of the data…

Q: Source of 115VAC when aircraft is parked in the hangar. Choose all the correct answers. Gen 2 GPU…

A: Given- 115 VAC, Aircraft is parked in the hangar, To Find- The source of 115VAC.

Q: given the circuit below 10 Ω ww 20sin100t V (~) vs (t) мее 30 Ω ww 30 Ω what is the magnitude of the…

A:

Q: A 55000 kW thermal plant of National Power Corporation delivers an annual output of 238000000 kw-hr…

A: Given that  Plant capacity= 55000kW, Annual energy consume = 238000000kW-hr.   Average demand =…

Q: Q3) For the following circuit, find i, iz, and is using Mesh analysis. 12 V Vo 2Ω 4 Ω 12 3A 13 + 8Ω…

A:

Q: 18. If the current flowing in an operating circuit must be approximately measured without…

A: the answer is option C, split-core-type.

Q: given the circuit below 20sin100t V 10 Q2 ww vs(t) мее 30 Ω www 30 Ω what is the magnitude of the…

A:

Q: Use a decoder and external gates to design a combinational circuit with three inputs and three…

A: The given function should be converted into canonical form to get the minterms and then the…

Q: #2) What is the power generated by the source in the circuit and V/5 Pvs 5K Pvs +12V R₁ 6K. XR₁ чк ✓…

A: In this question We need to determine the power generated by source and voltage V5  as shown the…

Q: Problem #2 Calculate current Ic through the capacitor given: v₁(t)=12 cos (4t) Volt and V₂ (t) = 6…

A: In this question we need to find the current Ic by using mesh analysis

Q: 1- Write the truth table and draw the logical circuit for the following logical expressions: a. X =…

A:

Q: 3. A 3-phase, 16 pole alternator has a star connected winding with 144 slots and 10 conductors per…

A: Given  Slots = 144  Conductors per Slot = 10  Total conductors = 1440 Flux/pole = 0.04 Wb NS Speed=…

Q: Dose antenna 4g or 5g have heatlh effect on people? How much does this effect goes does it depend on…

A: We all know that 4G and 5G network technology has the high speed network with the help of it we can…

Q: given the circuit below with Vin = 15V 15 V 1 kHz 2.2 k2 ww 500 mH A B 0.047μF what is the magnitude…

A: Capacitive reactance is given by: Xc= 1/(jwC).. Freq of source is given  so we can find  w=2pi f C…

Q: Given: VS1 = 14 volts | R1 = 7 kohm | R2 = 7 kohm | R3 = 6 kohm | R4 = 5 kohm What is VR2? The…

A: In this question We need to determine the voltage across the resistance R2   We are solving this…

Q: Find the trigonometric Fourier series

A:

Q: 2. Using the Laplace transform theorems Multiplying t and t" and First shift, derive the Laplace…

A:

Q: A 3-phase, 60 Hz, 35 km long overhead line supplies 550 kW at 22 kV, 0.9 p.f. lagging. The line…

A:

Q: For the system below, G(s) = 1.05 x 107 s² + 1600s +1.05 x 107 The settling time is equal to ms.…

A:

Q: inputs Clock and D. The initial value of the clock and Q is 1. When the clock is 1, the…

A:

Q: When do we use Thevenin’s and Norton’s Theorem?  answer asap in paragraph form ty

A: Use of thevenin's and Norton's theorem. Any linear two terminal circuit can be indicated by a…

Q: positive on the anode relative to the cathode, and the required amount of current must flow into the…

A: We need to select correct option for diac and SCR .

Q: Given the unity feedback system of Figure with G(s) 8 - s(s6 - 2s5s4 + 2s³ + 4s² − 8s - 4) C(s) R(s)…

A:

Q: I: An incoming sine wave results in a gain of -5db. The output sine wave has a peak value of 1V.…

A: Given Data: An RC High Pass Filter has, Peak Output voltage Vb=1 V Voltage gain AV=-5 dB To Find:…

Q: A load of 12 MVA, 0.8 pf lagging, 22 kV is served by a transmission line which has a line resistance…

A: In this question We need to determine the value of sending end voltage.  We know Apparent power S=…

Q: V1 Voltage (volts) V4 V2 t4 Voltage vs Time Time (seconds) Figure 565 t3

A:

Q: uestion 3 A US transducer is driven by a pulser programmed to produce 2 cycles of sine waves within…

A:

Q: Additional problem AP1: A continuous-time LTI system has a frequency response H(w). The magnitude…

A: Given plot is Fourier transform of h(t) ..both angle and magnitude is given.. X(t) is sum of 3…

Q: v(t) +1 1Η oooo 1Ω 1Ω 1Η oooo VL(0)

A: We need to find out transfer function of given circuit .

Q: A parallel-plate waveguide has plate separation d = 1 cm and is filled with Teflon having dielectric…

A: Waveguides-Waveguides are nothing but a guided medium to transmit electromagnetic energy from one…

Q: What will be the negative peak output voltage (in V) of the circuit below if the diode VTH is 0.7 V…

A: In this question We need to determine the negative peak output voltage of the given circuit.  We…

Q: ISA Here 102 w 220V Z = R+JXL 14.666 $ |2| = = = = = ₁ = XL = XL = m = 220 15 Power Factor = cos √…

A: Answer:  given that a RL circuit  voltage source V = 220 V  current I = 15 A Resistance R = 10 ohms

Q: Problem3. An electric motor can be modeled as a series combination of 200-mH inductor. If a current…

A: Given: R=12Ω, L=200mH and i(t) = 2te-10t. Need to calculate the total voltage. The total voltage can…

Q: Use the Routh-Hurwitz criterion to find the range of K for which the system of Figure is stable.…

A: The given system is shown below,

Q: Problem 7 For the given circuit below, find the impedance Zr. -j16 Ω 8Ω -j12Ω ΜΗ ZI 20 Ω j15 Ω 10 Ω…

A: As per Bartleby expert policy, only first individual question is to be answered. Kindly repost the…

Q: 7. Find the transfer function X (s)/F (s) for the block diagram shown below. F(s) 3 + 1 4 [₁] S X(s)…

A:

Q: 1. Calculate the thermal noise power for a certain communication system with an IF bandwidth of 10.7…

A:

Dielectric Breakdown

A dielectric is a material with low electrical conductivity and so is classified as an insulator. Dielectric materials are used to block the flow of electricity through them, allowing them to behave as an insulators. They can also be used to store electric charge or improve capacitance.Dielectrics have no free electrons for conduction because electrons are tightly bound to the nucleus. Because dielectrics contain a small number of electrons for electrical conductivity, they have a dipole. The two primary roles of dielectrics in electrical devices are insulation and electrical energy storage. An electric field polarizes the dielectric, and the polarization of the molecules allows dielectric materials to store charge.