for the following circuit find a. Ip b. VDS c. VD d. Vs 20 V ' 2.2 ΚΩ + Vps 0.68 ΚΩ Ipss=4.5 m Vp = -5 V

Q: use the ideal model to analyze the given circuit and determine the Q-Point 3k 2K M IMA lov VI D₁ K…

A:

Q: 1.2 kΩ R3 is parallel to 1.8 kΩ R2 . This parallel connection is in series with 200 Ω R1 , 680 Ω R4…

A:

Q: Find all currents and powers in the shown circuit using superposition method. Vs1= 120v .. R1=60 M…

A:

Q: 22 ΚΩ R₁ Αλλά 150 ΚΩ (b) (c) Refer to Figure (c). The closed-loop gain, Act, is φα ww R 19 582 ΚΩ R₁…

A:

Q: 6. A delta - connected alternator is connected a wye-connected resistive load, the alternator…

A: It is given that:

Q: Problem 3. For the following op-amp circuit obtain: R₁ ww ei R₁ www C HI A B R₂ + lo • The dynamical…

A: it is asked to find the dynamic equation, state equation, state space form

Q: If the load reduces to 400 MW, how will it be shared among the generators and what will the system…

A:

Q: A 400 V, 3 phase, 50 Hz, Induction motor gives out an mechanical output of 13.586 HP (Metric). It…

A:

Q: The upper critical frequency of a particular op-amp is 100 Hz. What is its open-loop 3 dB bandwidth?

A: Given data, Upper critical frequency fu=100 Hz.

Q: Desgin 2 imput Look up table for 3input AND gate.

A: A lookup table for a 3-input AND gate would consist of a table with 8 rows, one for each possible…

Q: 2. Given a discrete-time signal: X[n] = {0, 1, -3, 4, 2, -4, -3, 2, 1} ↑ Prove that x[n] = x₂[n] +…

A:

Q: four resistors having a value of 100 ohms each are connected parallel. what is the total resistance…

A: The resistances of the given circuit are:  R1=100 ΩR2=100 ΩR3=100 ΩR4=100 Ω Since the resistances…

Q: 2. Find 1₁, 12 and 13. 1522 M 30V + 52 SI₁ W 12 30 W 12.2 13 دل 18 302 M 2012 2012

A:

Q: At terminals a-b, find Thevenin and Norton equivalent circuits for the network depicted in the…

A: Network theorem The Electric circuit theory is the fundamental theory upon which many branches of…

Q: Consider the sinusoidal voltage (t) = 48 cos(32t+10°) V. NOTE: This is a multi-part question. Once…

A: Given: Sinusoidal voltage, v(t)=48 cos(32t+100) V, To find: The period T of the sinusoidal signal.

Q: The transfer function of a system is given as 100 s² + 20s + 100 The system is

A: Given- The transfer function of a system, Gs=100s2+20s+100   To find- System characteristics.

Q: A single crystal silicon bar with (111) orientation is 100 um long, 5um, wide, and 1 um thick and is…

A: Step 1 Answer  ACI code states that the round column or regular polygon shaped column may be…

Q: A source of 199.2 kV (line to neutral) is connected to the primary of a step-down transformer…

A:

Q: Problem 09.033 - Voltage across a series combination of R and L A series RL circuit is connected to…

A:

Q: FInd the current flowing across the 7K resistor.only typing

A: Given: In this question, the given details are, Here, the given figure is, To find the current…

Q: Determine the values of Av, Ai, Zin and Zout

A: The required parameters can be obtained by using the DC analysis and AC analysis of the amplifier…

Q: 15. When the three-phase balance load having a pure resistive load the current is a) leading to the…

A: 15)Given;When the 3-phase balance load having a pure resistive load the current is--?Let as know…

Q: H.w.2: For the circuit shown, determine the feedback topology & determine Ave, Rif, Rof

A:

Q: 80 dB is 40 10 100 80 20 OL

A:

Q: Determine R₁ to R₁0, V₁ to V₁0, l₁ to l₁0, total resistance, and total current from the circuit…

A:

Q: What is the correct voltage divider formula? Please help thank you so much

A:

Q: For this circuit a) Calculate 1₂ b) Calculate V₁ c) Calculate V

A: Given:

Q: Find the Fourier Transform for each of the following signals • f₁(t) = 3cos(2t) f2(t) = 5[u(t)-…

A: NOTE : As per our company guidelines we are supposed to answer first three sub-parts only. Kindly…

Q: 6. A digital signal is sent using a Hamming code for error detection and correction. The signal…

A: The parity code is checked as shown below.

Q: The received signals can be modeled by x(t)=s(t)+w(t), where s(t) is the desirable signals modeled…

A:

Q: A circuit with series and parallel connection has, VSupply = 24 Volt, resistors, R₁= 600 S, and two…

A: Given: R1=600Ω, R2=4 kΩ, R3=6 kΩ, R4=3 kΩ. Vsupply = 24 V, To find: Total resistance of the…

Q: Calculate values of asked physical quantities of the circuit: I need resistance when voltage is 36V…

A: The voltage in the circuit is 36 Volts The current flowing through the circuit is 3.4 A The…

Q: Find the ratio V.(s)/V/(s) for the electrical network shown in below V(s) 1,(s) 1/s 1,(s) 1/s+1) in…

A:

Q: 6.1; Find the closed loop transfer function. Indicate any ope loop poles and zeros, along with the…

A: Given: Second-order control system With PI controller  a = 2  time constant (τ)= 1 sec  Km = 2 1)…

Q: Determine the output current io in the circuit given below using the superposition theorem, where v=…

A: Superposition theorem The superposition theorem is one of those brilliant ideas that takes a…

Q: ο ο ο Which of the following metal is a least conductor for electricity? Aluminum silver gold copper

A: To find: Which of the given materials is a least conductor for electricity?

Q: I (t) = est cos (150nt)u (-t) Using the definition of the Laplace transform, L(g(t)) = G(s) = g(t)e…

A: Given: xt=e6tcos150πtu-t

Q: Listen +5.0 V- Vin OV -5.0 V- (b) (c) (d) none are correct www (a) 10 ΚΩ 3.3 V V -V out out(max)…

A: It is asked to find the output of given op amp circuit for given input

Q: The series circuit has Vsupply= 12Volts, R1 =1ΚΩ, R2 =2 ΚΩ R3 = 3 ΚΩ ; • What is the Ryotal for this…

A:

Q: 1A ΣΩΤ 202 ΙΩ 24 b ΙΩ

A:

Q: Circuit connected in parallel with given values of Vsupply=120V; R₁ = 2 kſ, R₂ = 4KS, R3 =6KQ; R4 =…

A:

Q: Question One A dynamic system is represented by the following transfer function representation:…

A:

Q: What is the closed-loop bandwidth of the amplifier shown in Fig. R₁ own Vin AOL = 150,000 fc(OL) =…

A:

Q: 2. Find the static error constants and the steady-state error for the digital system shown in Figure…

A:

Q: Problem 09.030 - Find current when a resistor and capacitor are in parallel A voltage (t) = 100…

A:

Q: A three-phase, four wire, ABC system with a line voltage of 380 Volt, has three impedances of Z =10…

A:

Q: iv. V. vi. How much power is the generator now supplying? How much power is supplied to the…

A: The phrase "power generation" refers to the process of producing electricity utilizing various forms…

Q: grey-white-yellow-gold = 89Μ Ω ± 10% 89k Ω ± 5% 9k Ω ± 5% 890k Ω + 5% ±

A: The resistor's values can be assigned based on the standard resistor color coding techniques. The…

Q: 20 10 V 30 ***= 6A 8 3ոչ 40 -** 64 է wwx 6n> ) 12 V v

A: The question is about Thevenin equivalent circuit.

Q: Using the superposition principle, find ix in the circuit given below, where R=9 . Please report…

A: Given:

Z parameter

The Z-parameters that are the impedance parameters of a two-port network are defined by expressing the two-port voltages V1 and V2 in terms of two-port currents I1 and I2. The Z-parameters are calculated by open circuiting one of the two ports at a time henceforth they are called open-circuit impedance parameters.