For a parallel RLC circuit, which one of the following statements is NOT correct? 1. 2. 3. 4. The bandwidth of the circuit decreases if R is increased The bandwidth of the circuit remains same if L is increased At resonance, input impedance is a real quantity At resonance, the magnitude of input impedance attains its minimum value

For a parallel RLC circuit, which one of the following statements is NOT correct? 1. 2. 3. 4. The bandwidth of the circuit decreases if R is increased The bandwidth of the circuit remains same if L is increased At resonance, input impedance is a real quantity At resonance, the magnitude of input impedance attains its minimum value

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter24: Resistive-inductive-capacitive Parallel Circuits

Section: Chapter Questions

Problem 4RQ: A tank circuit contains a capacitor and an inductor that produce 30 of reactance at the resonant...

See similar textbooks

Similar questions

Eill in the blank with corect answers B Frequency Series Resonance - Impedance vs. Frequency. The graph of impedance against frequency for an RLC series resonance circuit is shown in the picture. At which point the current will be maximum At point A At point C At point B At point D The inner most layer of an optical fhotI Is cantu Impedance
In the circuit of Figure, the magnitudes of V₁ and V at the resonance are twice L C that of VD. The inductance of the coil for R* 50 Hz is 520⁰ VR www. 502 Vc ell V₁
Question 02: A) How do you use Kirchhoff's law? What are the limitations of Kirchhoff's law? B) What is resonance in RLC circuit? Define the Q-factor in RLC series circuit.
Find I, VR, V, and Vc at the resonance in the next figure, with VS-50mV, R-220 hms, X100 ohms , and Xc100 ohms
Draw the Bode Plots and calculate the gain margin and the phase margin for the following transfer functions:
semi-log facsimile and draw asymptotic Bode plots (magnitude & phase).
9) Amoving coil voltmeter has a uniform scale with 100 divisions, the full scalereading is 200 Vand 1/10 of a scale division can be estimated with a fair degree of certainty. Determine the resolution of the instrument in volt. 10) Eight different students tuned in the circuit for resonance and the values ofresonant frequency in kHz were recorded as: 412, 428, 423, 415, 426, 411, 423, 416 Calculate the following: (a) Arithmetic mean (b) Average deviation (c) Standard deviation (d) Variance.
What is resonance? Explain how the condition of resonance is obtained in a series RLC circuit. Determine impedance, current, and power factor of RLC circuit at resonance.
Calculate Resonance Frequency, Cutoff Frequencies, Bandwidth, and Quality Factor for the RLC Circuit. R3 470 R4 L3 C3 V1 2700 470uH 10NF
1. For the series circuit below find frequency that would create resonance (fs), the Quality Factor (Qs), the Cutoff Frequencies (f1 & f2), and the Bandwidth (BW). 000 R=20 L= 275mH E = 120V Z0° C = 80uF
All of the following statements are correct except: : Resonance frequency happens when the frequency is changing. The bandwidth is defined as the ratio between W0 and Q The selectivity in resonance frequency is an important factor in determining Xl. The voltage across the L and C elements is zero but maximum in R
A tank circuit contains a capacitor and an inductor that produce 30 2 of reactance at the resonant frequency. The inductor has a Q of 15. The voltage of 277V is connected to the circuit. What is the total circuit current of the resonant frequency? Show your work. a) IT= 0.615 A b) IT= 0.423 A c) IT = 0.846 A d) IT= 0.321 A