Find the optimal Solution of following transportation system formulated below by1. Simplex methodMAX Z = 19x1 + 9x2 -4x3subject to3x1 + 13x2 + x3 = 1427x1 + 2x2 + 15x3 <= 1315x1 + 9x2 + 2x3 <= 104and x1,x2,x3 >= 0

Given: Solve by using Simplex method

Answered: Find the optimal Solution of following…

Engineering

Civil Engineering

Find the optimal Solution of following transportation system

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: A drilled shaft without bell is 10m long. It has a diameter of 1m. Es =30000 kPa, poisons ratio…

Q: Q2. For a specific spring where the load applied is 100 N, coil diameter is 4 mm, spring diameter is…

Q: Two samples of the same soil is subjected to pH analysis using a pH meter, the first is analysed…

Q: For the beam shown, solve the following: 100kN 80KN 21 1.5I to 2m 5m 4m 1.The deflection at 2m from…

Q: A glulam beam with a manufactured depth of 12 in. at 14% moisture content. Assuming common values…

Q: Consider the mechanism shown. Members AB and BC are joined by a hinge at B. End A of member AB is…

Q: 3-6. Determine the force in each member of the truss. Indicate if the members are in tension or…

A: Determine the force in each member of the truss. Indicate if the members are in tension or…

Q: Cummulative Percent SIEVE ANALYSIS GRAPH Weight Retained (g) Retained (%) Sieve Size Percent Percent…

A: Soils are broadly classified as Coarse grained soils and fine grained soils. If more the 50% of soil…

Q: Points 1 3. 4 A 113.7 113.2 113.5 112.15 112.3 112.7 B 112.2 110.6 109.3 109.9 110.7 112.8 C 112.7…

Q: List all required code of practice in designing reinforced concrete structural members based on :…

A: For the design of reinforced structural members, certain codal provisions are applied.

Q: The road-base layer which consists of limestone aggregate has been completely constructed. Propose…

A: Tack Coat is the layer that sits between the Asphalt Base Course (ABC) and the Asphalt Wearing…

Q: What is the common steel used in building construction?

A: Steel is an important part of modern day construction. It is used extensively because of its high…

Q: What errors can occur when the grading curve is extrapolated into the clay zone?

A: Brief concept introduction- Error- It is the difference between the measured and the actual value.…

Q: Question 2 It is desired to design pavement layers of a 6. lanes principal arterial in a rural area…

A: Given data:- Thickness of HMA surface, D1 = 8 in Principle arterial in a rural area, R = 90% Design…

Q: Define index of wetness.

A: Index of wetness

Q: Describe Approach zone in airport.

A: To describe: Approach zone

Q: Medium lubricating oil (SG = 0.860) is pumped through 1000 ft of horizontal 2-in pipe at the rate of…

Q: SHow complete solution and include necessary figure. At a point, the normal and shear stresses…

Q: What are the active earth pressure coefficient and passive earth pressure coefficient of soil, if…

Q: How does Limestone affects the performance of concrete?

A: Its chemical effect promotes the appearance of third hydration peak, forms carboaluminate and…

Q: A double cantilever beam 25 m long is supported 6m from the ends. Section is 300mm x 750mm. It is to…

Q: The hydrometer test is based on Stokes Law. What factors affect the measurements of suspension…

Q: For a constant head laboratory permeability test on fine sand, the following values are given:…

Q: The pressure drop per meter length in a smooth horizontal tube in a turbulent flow depends on the…

Q: Note: Please show all of the free body diagrams used (from reactions and etc.,) and also show the…

A: Deflection will be determined by the first mentioned method i.e. double integration.For other…

Q: 1. Kerosene (p = 804 kg/m³ ; µ = 1.92x10-3 kg/m-s) is pumped at 0.15 m³/s through 20 km of…

A: Calculate the head loss and the pressure drop through the pipe.

Q: Note: Please show all of the free body diagrams used (from reactions and etc.,) and also show the…

A: Deflection will be determined by the first mentioned method i.e. double integration.For other…

Q: For the frame and loadings shown and assuming El is constant, answer the following questions. Use 5…

Q: C9 × 20 PL를X 12 KL = 6.5 m W8 × 21 F,= 290 MPa MC 13 x 5 - F, = 345 MPa JKL = 4.8 m (a) (b)

A: Given, Section -a Fy=345 MPa KL=4.8+28×0.02=5.36 mProperties of w8×21Aw=4000 mm2Ixxw=31.34×106…

Q: how does climate change effect the use of such materials (concrete, steel and timber) in the future…

A: CONCRET The water is evaporated at high temperature it may be leads to the voids and strength of…

Q: B 8 ft 500 lb/ft 15 ft 15 ft

A: This question is from structural analysis in this question of cable is given with uniform loading…

Q: Given data : Void ratio=0.332 Find porosity

A: Introduction : The given question is related with geotechnical engineering . In this question we are…

Q: Q1 /A W21 x 68 of A992 steel is used as a simply supported beam with a span Tength of 50 feet. The…

Q: What is the rate of flow in a rectangular channel 4 m wide and 2 m deep with a bed slope of 1 in 900…

A: Given, Wide, b = 4 m Deep, d = 2 m Chezy's constant, C = 50 Bed slope, i = 1/900 = 0.0011

Q: 4.)The figure is a cross-section of two C6 x 13 and one 7" x ¾" thick flat plate. Properties of C 6…

Q: Determine the required diameter of the bolts to be used in the bracket shown if it has a allowable…

Q: Find the cross-sectional area (shaded area) of the l-Beam.

A: Given data : Flange Flange thickness tf=1 in Width of flange W=6 in Web Web thickness tW=1 in Depth…

Q: P7.39. Solve Problem P7.12 by the conjugate bea method.

A: As there are two different questions posted, according to the guidelines, only the first one is…

Q: For the following classified data, draw the frequency histogram, frequency polygon and the…

A: Given: Class limits and frequency

Q: The figure shows a cast-in-place reinforced concrete spread footing for an interior column that is…

Q: Calculate the discharge (in cubicmeter/ second) if Cd = 0.63 4 m 4.5 m -2 m- 0.5 m- AV NIN. Fig.…

Q: O 300 mm 30° 30° A P 300 mm B The two wires are connected togetherat A. If the force P causes point…

A: Determine normal strain developed in each wire

Q: Draw the influence lines of: a.) Vertical Reactions at A and D. b.) Moment Reaction at A. c.)…

Q: = 200,000 MPa. Compute the allowable axial load Pa (ASD) and ultimate axial load Pu (LRFD) that the…

A: Solution: (a) For both ends fixed Check for slenderness ratio, KLry= 0.5 x 600051.56 = 58.18 Check…

Q: A confined aquifer has a source of recharge. The hydraulic conductivity of the aquifer is 40 m/day…

Q: Q2: A(500 400) mm column shown in Fig.2 is reinforced with 12032mm bars. The applied service dead…

Q: Heavy fuel oil flows from A to B through 3000 ft of horizantal 6-in steel pipe. The pressure at A is…

A: Given data Pipe diameter is equal to 6 inch Pressure At A is equal to 155 PSI Pressure at b is…

Q: Using method of sections, determine the members BD, CD, and CE. statics of rigid bodies

Q: b) For the welded connection below, fillet weld of different lengths are provided at the heel and…

A: Solution: Given: Section: 2 L76 x 76 x 11 area = 1430 mm2 Total length of the weld = 80 + 120 = 200…

Q: I. Solve for the reactions and draw the shear and moment diagram. 101KN/m (d) 5@2 m = 10 m

Concept explainers

The Profession of Transportation

Transportation Engineering or Transport Engineering is the application of innovation and research-based fundamentals to the planning, management, and operations of facilities for any means of transportation for the provision of safety, efficiency, convenience, security, that is economically and environmentally suitable for the motion of people and goods transportation to various places.

Question

Find the optimal Solution of following transportation system formulated below by
1. Simplex method
MAX Z = 19x1 + 9x2 -4x3
subject to
3x1 + 13x2 + x3 = 142
7x1 + 2x2 + 15x3 <= 131
5x1 + 9x2 + 2x3 <= 104
and x1,x2,x3 >= 0

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Step 5

Step 6

Step 7

Step by step

Solved in 7 steps with 7 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

Then calculate the cross-section for section E, the image below: C 8.0 20.0 H C 7.2 C 1.4 9.6 C 0.0 B C F 12.0 Transition section (e)
o T ☺ ť Q2/ Two helicopters, H1 and H2, are traveling together. At the time t = 0, they separate and follow different straight line paths given by H: x = 6+ 40t y = -3 + 10t z = -3 + 2t H2: x = 6+ 110t y = -3 + 4t z = -3 +t Time t is measured in hours and all coordinates are measured in miles. Due to an error, H, stops its flight at (446, 13, 1) and lands at (446, 13, 0). Two hours later, H, is informed about Hz and moved toward H, at 175 mph. How long will it takes H, to reach H2? Ans./ 1.17 hours مرّ للأعلى لاستعراض الفلاتر + إضافة شرح. . . mum <
I) Write Erlang B formula. Mention its uses in traffic engineering. II) Explain briefly about Orthogonal FDMA ?
=if LL-30 and PL=10 then Pl 22 O 12 O 20 O 15 O 16 O
Note: Replace all zero digits of your ID number by number "2" Problem #7: 850 + A (N) 1.5 m 1.5 m Use X = Last 3 digits of ID number A 1 m Y = Last 2 digits of ID number J45° 450 + Y (N-m) A = 4th digit of ID number B = 5th digit of ID number C = 6th digit of ID number %3D e.g., ID # = 12-3456-789 X = 789 If the collar at A is fixed to the member and can slide vertically along the vertical shaft which means that there is no vertical reaction at point A, Y = 89 19. Determine the reaction at the roller support at B. (N) A = 4 20. Determine the horizontal reaction at the support at A. (N) B = 5 21. Determine the moment at the support at A. (N) C = 6
Solve the differential equation of (A) In y = c Inx B) y=clnx (C) y = Inx + c D) y^2=lnx + C dy y || dx Inx E
A company wants to run a pipeline from a point A on the shore to a point B on an island which is 6 km from the shore. It costs 4000 per kilometer to run the pipeline on shore, and 5000 per kilometer to run it underwater. There is a point C on the shore so that BC is at right angles to AC. The straight shoreline is the line AC. The distance AC is 9 km. Determine the minimum cost. 44000 54000 34000 64000
Question 2 For each of the following equations, state the order and tell whether it is nonlinear or linear, In the case of nonlinear equation, CIRCLE the term(s) which make it nonlinear. du au du 2²u a²u du au a²u du + ax² at = 0 +√1 + x² = 0 ди əx + et = 0 0 at at at at² əx² at əx www. AP +
A plank L m long is placed in a horizontal position with its ends resting on two inclined planes as shown. The angle of friction is p. Determine how close the load P can be placed near B before slipping impends.
Analyze the argument and its translation in quantificational logic: "All humans are mortals. Socrates is human. Therefore, Socrates is mortal. " [Hx, Mx] 1. (x) (Hx Mx) Valid 2. Hs .. Ms 3. asm: ~ Ms 4. (Hs Ms) {from 1} 5. Ms {from 4 and 2}MP {Line 3 and 5 Contradicts} What rule was used in obtaining line 4? (A) Drop Universal B) Drop Existential C) Reverse Squiggle (D) Modus Ponens
x³ – 1024 find lim x→4 x – 4 O 1 100 O 1300 O none O 1280
Which of the following inequality has a graph and solution as illustrated? O C. 3x+4yz-9 A. 3x+4y<9 B 3x-4ys9 D. 3x+4y2 9