Find the efficiency of the following circ +20 V R. 47042 22正 1000 µF R 22 pF 470 2

Q: Determine the average power supplied to RL in the figure 11.50. Xc R W- 10 2 2.7 kl 1 = 20 mA Lo R…

A: Given electrical circuit as follows     Note : i am choosing RL is R4

Q: The average power delivered to an impedance (4 – 3) N by a current 5 cos (100nt + 100) A is (В) 50…

A: Given value of current is - it=5cos100πt+100oI=5∠100oA Given impedance is - Z=4-j3

Q: Please show a complete solution to the problem 10. A 540 V, 50 Hz, 3-phase circuit takes 47 A at a…

A: In this question We need to calculate the VA input to the motor when driving a mechanical load of…

Q: Q1) For the circuit shown in Fig. 1, find the current I30 and the average power. Let v(t) = 15…

A: The circuit diagram is shown below, Where,V(t)=15sinωt+60°+10sin2ωt+30° VandI(t)=5 sinωt A

Q: For the network of the figure below, Calculate the true power delivered to the reactance Xc. R 20 E…

A:

Q: 1000 Ω W R m ig 160 nF 100 mH ?For the circuit shown above, what is the average power supplied by…

A:

Q: 1- For the circuit shown in Fig. 4, find the current I30 and the average power using superposition…

A: Given, vt=15sinωt+60+10sin2ωt-30=15∠60+10∠-30=7.5+j12.99+8.66-j5=16.16+j7.99 V it=5sinωt=5∠0 A

Q: 4. Determine the current in the 24 ohm resistor. 36 V A 120 18Q 70 B 150 2452 U17 15 2

A:

Q: 3. Given the circuit, Find lo and the overall complex power supplied namely PT, QT & Si 1.2 kW 0.8…

A: It is given that:

Q: Q1) For the circuit shown in Fig. 1, find the current Isn and the average power. Let v(t) = 15…

A:

Q: Find the power delivered to the element in Example 1.5 at t = 5 ms if the current remains the same…

A: sol:  (a)  consider the current in an element is i =5cos60πtA.      consider the voltage across the…

Q: 85. In Fig. 33.24, the current through resistor R is R=5kΩ I ΚΩ IL 10 ΚΩ 120V (i) 28 MA (iii) 14 mA…

A: Given circuit: Vs=120 VVz=50 VR=5 kΩ

Q: OJ AL aun Se delivered. (ii) Calculate the voltage across R, then terminal A being positive. 20Ω 40…

A:

Q: A coil develops heat of 800 cals/sec, when 20 V is applied across it. The resistance of the coil (1…

A: Relationship between developed heat or energy by resistance is given as E=(V2/R)   j/s Where R=…

Q: Question 3 What is the value of real power supplied by the source in the figure? 60 30/0° V ms 40…

A: Given circuit:

Q: I. Direction. Answer cach question quietly and encirele the letter of the correct answer. 1. One…

A:

Q: Q: Figure (1) shows the current through and the voltage across a device. (a) Sketch the power…

A: The given waveform for the voltage is It is represented as,

Q: Determine the values of currents I1 and I2 12 M = j10 a j50 a j50 2 50 2 25020° V 10 2 10 2 Fig.3.

A:

Q: What is the value of Rr? 2.52 20 Ω 15 V 26 2. RT- 3.4 Ω 11.25 Q

A:

Q: 44. Calculate the average power delivered to each resistor shown in Fig. 13.66. 50 Ω 38 Ω 1:9 1:4 5…

A: In this question we need to find a average power absorbed by each resistance in the given circuit.

Q: 2 H le 000 18 cos 21 VI IH

A:

Q: An industrial load is known to be inductive and consumes 90 KW. The ammeter reading is 260 A ms, and…

A: Given  Power 90 Kw, Voltage V =480Vrms, current I=260 A

Q: What is the value of the equivalent impedance? 80 ww 10 0 jsa キー20 j10n 340 13.45+18.2j

A:

Q: 2. The series is shown in the picture below, i(t) = 2 + 10 Cos(t+100) + 6 Cos(3t + 350 Amperre.,…

A: It is given that: i(t) = 2 + 10 Cos(t+10°) + 6 Cos(3t + 35°)

Q: 10/19/2020 P31. For what value of R is the power dissipated in R maximum? Calculate that power. 42…

A: To calculate the value of R such that it will dissipate maximum power, first we need to remove it…

Q: Calculate the real, reactive and apparent power, P, Q, and S, for R = 1 Ohm and oC = 3 Siemens R…

A: Given: Phase voltage (voltage with respect to neutral), Vph=120 V Supply frequency, f=60 Hz…

Q: Given the circuit below, determine the magnitude of the current through the 20-volt source. bo 10…

A:

Q: 2. Find Rab 30 30 32 MoWW 30 32 30 30 30

A:

Q: Find i(t) in the circuit of Fig.4. Then calculate the average power absorbed by the 2-2 resistor. ww…

A:

Q: [Answer: V,=+ 330 k2 470 k2 33 k2 12 mV 47 k2 47 kn V2 18 mV Fig. 02

A: Please refer the attached images for the complete answer..

Q: Referring to this figure, calculate Av if rd = 19 k. Q 12 V 2 kn 1 µF Zo 10 Mn o(en) = 6 mA Vas(on)…

A:

Q: 330 k 470 k2 33 ka 12 mV 47 k2 47 kN V2 18 mV FIG. 11.52

A:

Q: 2) 2401 6 A ↑ GA 22 Mar 120 V Find the curent in 22 ww 22 20 Mr 522 22 isl 22

A: We have to find the current i2 in the given circuit

Q: a) Hours used per Energy points Power Voltage (V) Item No. UL* Current (Y/N) (I) (P) month…

A: Dishwasher- Units consumed in one month, =15*12011000=18.015 kWh

Q: Three coils each having resistance of 29 Ω are connected in delta across 401 V, 50 Hz supply. Then…

A:

Q: 22 R 160 nF 100 mH ?For the circuit shown above, what is the average power supplied by the source…

A:

Q: 19. Calculate the average power supplied by the source as shown below. + 2Ω www 60 V 3Ω 8Ω 0000 w 4Ω…

A:

Q: The reactance of the Impedance Z=1 O 100 Ohms 48.48 Ohms 87.46 Ohms 1.64 Ohms

A:

Q: Homework: For the network depicted in the figure below: 1. Find the current I1. 2. Find the voltage…

A: In the network circuit as shown in the figure.  One independed voltage source are consist in the…

Q: For the following network find 1. V. 2. P. Q, S of the current source 3. Draw the power triangle of…

A:

Q: 10 The power being dissipated in the 1 Q resistor in the circuit shown below is ...W * 40 1:2 1:10…

A:

Q: 1. A resistance of 20 W and a coil of inductance 31.8 mH and negligible resistance are connected in…

A: The solution is given below

Q: = 8 cos(2t – 40) V in the circuit, find the average power delivered 1. Assuming that v, to each of…

A: According to the question we have to find the value of average power delivered to each passive…

Q: 60 Ω R1 R2 10 Ω + 20 N E = 40 V Z 0° XL = 80 Q |f1, Find the Current I Find the voltage V1 Find the…

A: multiple questions As per our guidlines we are supposed to do the first question if a student asks…

Q: QI: Find the voltage va for the circuit of fig.(1). (Using Kirchoff's voltage law) 52 b 32 Vas…

A:

Q: H.W.: For the circuit of Fig. 3.15, compute the average power delivered to each of the passive…

A: we have to compute the average power delivered to each of the passive elements. and verify answer by…

Q: 300 1 = 0.1 H 4 e= VZ(50) sen 2 1000 L 0.2 H + 5

A:

Q: R Ro Lo b Yük load

A:

Q: The voltage and current at the input of a circuit are given by the expressions v(t) = 255cos(wt +…

A:

Q: The AC EMF in this electric circuit is described by the following equation: = 3 = 18mF, L = (12V)…

A: In this question,  Find the average power supplied by the source E.  Power P= VI cos(V^I) watt

RTD (Resistance Temperature Detector)

A resistance temperature detector is a passive electronic device or a sensor. The name itself suggests that it is related to resistance, temperature, and detection. Similarly, its resistance changes when there is a temperature change; the resistance increases when the temperature of the RTD device increases or vice-versa. It is also known as a resistance thermometer. Its working is similar to the thermocouple.