Find the current lo in the network below using Thevenin's Theorem. 12 420°A 1220° v Ix j12 j10 Io 12 2Ix A,079,

Q: A, Rs=20 R3=60 A3 R,=D40 Rs=20 A2 Rq=42 14V (As A, R2=30 R,=32 R,=30 Using the given circuit, calcul...

A:

Q: i. Some reasons for adopting high transmission line voltages are to improve -------and the enhanceme...

A: Given that three fill in the blanks related to high transmission line voltages .

Q: List the difference between open loop and closed loop control system with suitable example.

A: Difference between open loop and closed loop control system :  

Q: 3) Using superposi hon principle to find v and the power dissipated by the 32 resistar 12 V (오 (^)6A

A:

Q: Refer to the circuit shown below. The current-controlled-current source has an unknown constant k. S...

A:

Q: In balanced star (wye) connected system, the line voltage is 0 707 times the phase voltage phasor su...

A: Electrical machines can be either generator, transformer or motors. They can be either Ac machines o...

Q: iv. When the half power point bandwidth is 10 MHz and the center frequency is 5MHZ, the quality fact...

A:

Q: A mini diesel power plant burns diesel at 12,500 kcal/kg.

A: Conductor-Materials which have free electrons in valence which can flow when comes under any externa...

Q: I JKS 10.12: For the circuit shown, Find the transmission parameters (A-Parameters)? (Ans.: a=4x104,...

A: We need to find out transmission parameters for given circuit

Q: In the circuit shown below, R = 200.0 Q, L= 0.200 H, C = 0.100 mF and the AC source is given by ɛ = ...

A: To calculate voltage across resistor

Q: If D1, D2 and D3 are removed in the circuit and are replaced by short circuit, determine the PIV rat...

A:

Q: Use nodal analysis to solve the circuit below

A: In this question,  We need to determine the all unknown current and voltage as shown in the circuit ...

Q: C, 2nF Using the given circuit, calculate: C, 2nF C Sn 2) Charge across each capacitor V 24V C 2nF

A: Given circuit diagram is shown below. We need to calculate charge across each capacitor.  

Q: The diodes in the circuit are all Silicon with forward voltage of 0.7 V. If R1 = 8 Q and R2 = 15 Q, ...

A:

Q: Find the pull exerted on the plunger of an electromagnet when the total flux is 381 uWb. The diamete...

A:

Q: How many nodes are there in the circuit? A. 2 B. 4 C. 6 D. 8 E 10 ii. How many circles are in the ci...

A: As per guidelines,we are supposed to answer only first three subparts of a question.Please repost th...

Q: Are the signals periodic or not? If it's periodic, what's the period? Show it by calculating.   a)...

A: The solution is given below

Q: 220N + 330N 470 L R 91Ω ET 15 V Ern, RTh

A: Thevenin's Resistance   It is the open circuit resistance across the load when all the independent s...

Q: An iron-cored choke is designed to have an inductance of 12.5 H when operating at a flux density 3 T...

A:

Q: Capacitors causes the voltage to lag the current by 90 degree. This is the same as saying that the c...

A:

Q: Find the transfer function, G(s) = X,(s)/F(s), for the translational mechanical system shown in the ...

A:

Q: electrical circuit contains a capacitor of 11.24 microfarads and a resistor of 1124 ohms. If the cap...

A: The solution is given below 

Q: Identify the connection and application of each op-amp: A1, A2, A3 and A4

A:

Q: 1. Which of the following is an even function of 1.? (a) t 2 (b)x 2 – 4t (c)sin2t + 3t (d)t 3 + 6 2....

A: “Since you have asked multiple  choice questions, we will solve the first  three questions for you. ...

Q: E, = 120/-30° and E, 120/30°, and 6. The following particulars are given for the T-network of Fig. 1...

A:

Q: A balanced delta load with impedance of 15 - j9 ohms is connected to a three-phase source by three w...

A: In this question,  A balance Delta connected load is supplied by the balance supply source.  Find th...

Q: 5. What was the effect on the motor power factor as the load increased? 6. What was the effect on th...

A:

Q: The 12V 50 Hz source has what RMS value?

A:

Q: The equivalent Impedance between terminals A and Bin the fol owin figure is: A 3H - 2F B

A:

Q: Q1% Find the follocwing system is (OLinear. O Time invarient. O Caubal . Stable , O gnwerztible , O ...

A: Given: Consider the following systems: To find: Find the following system is: 1) Linear 2) Time i...

Q: A circuit is constructed with six resistors and two batteries as shown. The battery voltages are V, ...

A: 2Apply Kirchoff's law,The current I3 that flows through R3 isI2=I1+I3 .....1I3R3-I1R1+V1=0From equat...

Q: QUESTION #5. Ob. Assuming ideal diodes, select from the choices shown the output waveform of the cir...

A: We need to select correct option for given circuit

Q: current I in Fig. 15-85 if E = 110/40°? 18. In Fig. 15.8a the current I = 4.33 - j2.5 when E 110/0°....

A: Solve the problem

Q: For the transistor circuit shown. VB=3V. Vcc= 20 V. RB= 220 kohm. Rc= 2.2 kohm, RE = 1.2 kohm. Deter...

A:

Q: A 3-phase system has line to line voltage Vab = 1500 Vrms with 30 deg angle with a wye load. Determi...

A: For star load line voltage is sq rt(3) times of phase voltage and leads by angle of 30 degree 

Q: 1. For the circuit shown, find the current I through the 6 Q resistor using Thevenin's Theorem R-62 ...

A:

Q: Find the power supplied by each source in the circuit in Fig. P2.49.

A:

Q: 12. A two-element series circuit has voltage V = 240 + j0 V and current I = 48 - j36 A. Find the cur...

A:

Q: Find the cross correlation of the sequences x(n) = {1, 2, 3, 4 } and h(n) = {2, 4, 6}

A:

Q: A class A transformer-coupled amplifier uses a 25:1 transformer to drive a 4 – 2 load. Calculate the...

A:

Q: 10. A 110-Volt AC line feeds two circuits in parallel. The currents are (2.2 - j6.5)A and (1.8 – j3....

A: Since you have asked for question 10 . So we are providing solution for question 10 . This question ...

Q: enclosure used in DC motor

A: Conductor- Materials which have free electrons in valence which can flow when comes under any extern...

Q: se your own words to define the density of states.

A: The density of states function is used to determine carrier concentrations and energy distributions ...

Q: Given a non inverting op – amp below, what should be the operating frequency to have a high frequenc...

A: The circuit is given as We know that the frequency response of opamp is like a low pass filter.

Q: 22 n VIN 8 V Figure 8

A: The given circuit diagram is shown below:

Q: Calculate the line and phase current drawn bythe load

A: In this question,  We need to calculate the line and phase current drawn by the load.  Current I= V/...

Q: 30V

A:

Q: A 4 pole, 500V shunt motor has 720 wave connected conductors on its armature. The full load armature...

A: The solution is given below 

Q: 9. The effective voltage across a circuit element is (20 + j10)V and the effective current through t...

A:

Q: How many GPS Satellites are present?

A: Solve the problem