Find a) capacitance b) Vdc filtered c) Vmax d) Vmin

Q: Consider the signal x(n) = [−1, 2, -3, 2, −1] ↑ with Fourier transform X(w). Compute the following…

A: Given dataSigna, To find outWe have to determine the , , ,  and

Q: Q5. Plot the root loci for the closed-loop control system with Equation 1 and Plot the root loci for…

A: Plot the root loci for the closed-loop control system with equation (1),.

Q: 5) The symmetric magnetic circuit of Fig. 1.36 has three windings. Windings A and Beach have N turns…

A: Given data:The three-winding symmetric magnetic circuit with,Winding 1 (in the middle leg) has the…

Q: 6V 0,2K Τ 0.004 U 251 Find the U value in the circuit. 40K U10K

A: Circuit is given,

Q: Using two D flip-flops only, Design asynchronous Counter. The Counter counts in the sequence 1, 6,…

A: Requirement:An asynchronous Counter using D-Flipflops to count the sequence of,1637...

Q: Two power system areas operating at a nominal frequency of 60 Hz are connected with a tie line, and…

A:

Q: 1. The signal m(t) = 3 cos (2m x 700t) is used to DSB-SC modulate the carrier c(t) = 7 cos(2 x 105t)…

A:

Q: You measure an electric field of 1.25 × 106 N/C at a distance of 0.150 m from a point charge. What…

A: E =electric field =1.25 x 106 N/Cr = 0.15 mWe need to find electric flux?

Q: Q21. Consider a star-connected system with a reactance of 652 and resistance of 852 per phase is…

A: Resistance is given R = Reactance is given = Supply voltage V =440 V

Q: d) A power amplifier generates an output signal power of 25.XY W with a measured noise power of…

A:

Q: Given the block diagram of the system below: x[n] Z Ţ -1| N 2 (a) Determine the system function…

A:

Q: Q.2 For a BJT amplifier shown in Figure Q.2, given ß= 100, VBE = 0.7 V, VCEQ = 3.5V, Rc1=3 Rc2 and…

A:

Q: b. Solve for the source current/s. Ra ΕΓΚΩ + EΞ 20 V R₁ • 2 ΚΩ R₁ • 3 ΚΩ Ho R₂ Μ 3 3 ΚΩ R₂ R₂ ΣΚΩ 3…

A: The given circuit can be drawn like:

Q: A fault occurs at bus 4 of the network shown in Figure Q3. Pre-fault nodal voltages throughout the…

A: x=1y=7Note: reactance of element right to bus 4 is not given. Hence we will not consider that in…

Q: Example 4: Maximum phase lead of the compensator D(s) is (A) 50⁰ (C) 60° 0.4s+1 0.04s+1 D(s)=- (B)…

A: It is given that:

Q: 2.An open circuit test was performed on a 150 kVA, 1200V/600V single phase transformer. Applying 600…

A:

Q: A diesel power station has the following data Fuel consumption/day = 1000 kg Units generated/day =…

A: It is given that:Fuel consumption/day = 1000 kgUnits generated/day = 4000 kWhCalorific value of fuel…

Q: Design a transformer coupled class A amplifier with high efficiency to supply an output power of Po=…

A: Transformer coupled class A AmplifierIt is a type of electronic amplifier that uses a transformer to…

Q: In cylindrical coordinates, let p = 0 for p 1.5 mm. Find D everywhere: ly

A: Electric/Displacement flux density Electric flux lines is always perpendicular to the displacement…

Q: There is a parallel plate capacitor. The gap between the two conducting plates is filled with a…

A: Given:When the gap between two conducting plates is filled with a vacuum the capacitor capacitance…

Q: Given the information appearing in Figure 2, determine Vce. 470 ΚΩ B =90 +22 V 9.1 ΚΩ Ic Figure 2…

A:

Q: Find the equivalent resistance in the follow circuit. 12V A B 4Ω 15Ω M 50 6Ω WwW

A:

Q: Question 1 Two positive 2nC point charges, denoted by q₁ and q2, are located at (0, 4cm, 0) and (0,…

A:

Q: IInitial conditions are frequency 5 ×106 Hz and current 1.5 A A magnetic far field of an antenna has…

A: The relation between the electric field and the magnetic field is described by Maxwell's Equation.It…

Q: 3- Find the z transform of the following two functions: (a) x₁(n) = -na" u(-n-1) (b) x2 (n)= (-1)"…

A: Given dataTo find outWe have to determine the  transform.

Q: Mechanical Characteristics Next, we will apply Newton's law to write the differential equations that…

A: The above question is based on the mechanical model of a DC motor.

Q: 1. Suppose that the voltage v(t) shown below is applied to a 200 µF capacitor. a) Plot the current…

A:

Q: Design a 3-bit ripple up counter using positive edge trigger J-K flip-flops.

A:

Q: Example 2: a 3-phase SM its armature resistance is 0.50 and syn. Reactance is 0.86692/phase. The…

A:

Q: The op amp in the circuit in (Figure 1) is ideal. Figure V₂ 20 ΚΩ ww 5 ΚΩ w 160 ΚΩ ww +●+ 18 V -18 V…

A: The circuit diagram,

Q: 3th 50 MVA, 12.2 kV, xgl = 0.10 pu 20 MVA, 13.8 kV, xg2 = 0.10 pu 80 MVA, 12.2/132 kV, XT1 = 0.10 pu…

A: The per-unit impedance expression is,The relation between the new and old per unit impedance is,

Q: Three loads are operating at 1000 V. Load 1 is an induction motor consuming 80 kW at 0.83 PF…

A: The above question is based on the concept of complex power in AC circuits.If V is the voltage, I is…

Q: 3) The total power delivered to a balanced Y-connected, three-phase load is 720 kW at a lagging…

A: A balanced Y-connected, three-phase load is 720 kW at a lagging power factor of 0.8. The line…

Q: A lossless transmission line with Z. = 500 is 30 m long and operates at 2 MHz. The line is…

A: ZL=60+j40 ohm is load impedance Z0 =50 ohm is characteristic impedanceFrequrncy,f=2Mhzu=0.6C

Q: 2. Given a current I(t) = I m charge as a function of time of the charge is Qm. sin(at + p) on a…

A: Let's denote the charge as a function of time as . The given current function is , where  is the…

Q: 4) The magnetic circuit of Figure 1 consists of rings of magnetic material in a stack of heigh h.…

A: Ri = 3.2 cm, Ro = 4.1 cm, h = 1.8cm and g = 0.15 cm, N = 72 turns

Q: 3.11 Find V, and the power dissipated in all the resistors in the circuit of Fig. 3.60.

A: It is given that:

Q: Suppose you have one circuit with three flip flops: T flip flop with input T₂ and output Q2 D flip…

A: First we will draw truth table from given expression of T,D & J-K flipflop from there we will…

Q: ANSWER C & D ONLY

A: As asked in the question, we will answer only part (c) and (d). Given:Block diagram of a system, To…

Q: For the following discrete-time signals, determine the z-transform, ROC and if they are BIBO stable…

A:

Q: Assume that the initial energy stored in the inductors of both figures is zero. Suppose that L₁ = 8…

A: The circuit diagram,The initial energy of the inductor is zero.

Q: Et 0.21. V0₁-0.2 |v2=0.2 Voz=0.2 Ik 24- 27 2K + 2k ли 2K 8k 2K- Yx YZ 10k миск 20k lok uy

A: The response of the circuit needs to be obtained and the same can be obtained by analysing the…

Q: The network of Fig. 8.149 is very similar to the two-source networks solved using mesh or nodal…

A: The current Given:The given circuit is:

Q: A PM motor operates at a magnetic flux of 4 mWb. The armature resistance is 0.8 R and the applied…

A:

Q: Vo

A: The output voltage of the given circuit needs to be calculated and the same can be obtained by…

Q: Draw the Q output waveform of the flip-flop in the following figure for the S, R, and CLK inputs.…

A:

Q: - sketch the root locus for a unity feedback system that have G(s) = k(s²-9) (s²+4)

A:

Q: Example 3 Find the Thevenin equivalent of the circuit in Fig. 11 as seen from terminals a-b. 4Ω j3 Ω…

A: In Thevenin circuit the network is replaced by Thevenin's voltage in series with Thevenin's…

Q: The current in a 50 μH inductor is known to be iL = 18te-10t A for t > 0, where t is in seconds.…

A: given here inductor value and current through the inductor and asked to find the energy stored in…

Q: 4. The power measured in an open circuit test on a transformer corresponds to:   A) Losses in…

A: to find the power losses measured in open circuit test of the transformer

Capacitor

The capacitor is an element used to store electrical energy in the electrical field. A capacitor is a form of passive energy.