Electrons in silicon have a mobility of 1000 cm / V - sec. The electric field is applied to make the electrons reach a velocity of 3 x 10 cm / sec. Assume that the mobility is constant and independent of the electric field. What voltage is required to obtain this field in a 5 um thick region? How much time do the electrons need to cross the 5 um thick region?

Q: For a semiconductor with a constant mobility ratio b=μn/μp > 1 independent of impurity…

A: For a semiconductor with a constant mobility ratio b=μn/μp > 1 independent of impurity…

Q: is given by for 0<x<L The electron mobility is The electron concentration in a semiconductor n(x)…

A:

Q: n-type semiconductor sample has an electron density of 6.25x10^18/cm^3 at 300K.If the additive-free…

A: Solution :-  As per mass action law :-  np=n2i where n is the concentration of electron in n type…

Q: A sample of n-type silicon semiconductor has the following properties:Donor density Ndis 5x1019per…

A:

Q: Q2:- A semiconductor material has electron and hole mobilities un and up respectively. When the…

A: We need to find out conductivity

Q: Below the temperature dependence of charge carrier concentrations of intrinsic semiconductors Ge and…

A: A)Energy band gap of Ge=0.72 eVEnergy band gap of Si=1.1 eVB)Fermi Energy level=Band gap energy2So,…

Q: A silicon diode said to be a 1-mA device displays a forward voltage of 0.7 V at a current of 1 mA.…

A: The conductivity of semiconductor is lies in between conductor and insulator. The conduction in…

Q: A voltage of 8 V is applied over a silicon specimen that is 78 mm in length. The electron mobility…

A:

Q: A diode is tested at the presence of dc+ac source, where the diode's average current level (dc…

A:

Q: Q:A resistor of pure Silicon with a resistance of 1.05M Q at 300 k, if the resistance of this…

A: The resistance of a resistor depends on the dimensions of the resistor and the conductivity of…

Q: 14 A 0-volt forwaurd voltage is spplied to a silicon diode in series with a koud of 3 k2. Draw the…

A: In electronics, the p-n junction diode works as the basic building blocks of electronics circuitry.…

Q: (11) The mobility of free electrons and holes in pure germanium are 3,800 and 1,800 cm2 /V-s,…

A:

Q: 4. The Silicon semiconductor (doped with 3 donor atoms per 6x10° si atoms) is subjected to a 300…

A:

Q: Course dashboard A diode has 1.5 mA at 0.62 V and 300 mA at 0.82 V. Find its reverse saturation…

A: Diode current equation

Q: For a P-type semiconductor with length of 55mm, the cross-section area of 0.55mm2, and resistance of…

A: An intrinsic semiconductor will have equal electron and hole concentration. This concentration is…

Q: 2. The concentration of donor impurity atoms in silicon is Nd = 1015 cm-3. Assume an electron…

A: The conductivity of a semiconductor lies in between conductor and insulator. The conduction in a…

Q: 5) Below the temperature dependence of charge carrier concentrations of intrinsic semiconductors Ge…

A: Consider the given values from the graph. At room temperature, the T(k) is 293 kelvin. The values of…

Q: a) An n-type extrinsic semiconductor is formed by the deliberate addition of a small number of…

A: For the given question, we have to explain that, why at room temperature, deliberate addition of a…

Q: A p-type sample of silicon has a resistivity of 5 2-em. In this sample, the hole mobility, , is 600…

A: Electronic devices and circuits

Q: 1 (a) Suppose in a donor doped semiconductor at a particular temperature, EF is 0.015 eV above than…

A: d is correctconcept: in n-typeas T→  OKEF lies avove EDAand at some intermediate temp. Ef-Edand at…

Q: When energy is supplied to a semiconductor, there are movement of electrons from lower level to…

A: Electrons  and holes are the two types of charge carriers in semiconductor material. They are…

Q: 1. What is the difference between a conductor and a semico 2. Which element is used to construct…

A: In this question we will write about semiconductors, conductors and doping... Note :- as per our…

Q: A semiconductor can be made into thermistors since their superior temperature sensitivity of…

A: Given values are - Band gapEg=1.107eVDiameterd=0.5mmLengthl=10mmdR=∆R=10-3Ohmσo=4×10-4ohm-1m-1T=300k

Q: ) If in pure silicon crystal there are 500000 holes, then how many free electrons are there in the…

A: The solution is given below

Q: A Silicon bar having a length of 4μm, doped with n-type at 10"/cm", calculate the current density…

A: Given,Length, l=4μmConcentrationof n-type material, n=1017/cm3Applied voltage, V=2VCross-sectional…

Q: ) The figure below shows the electron and hole concentration in a silicon region. The electron and…

A:

Q: Q2:- A semiconductor material has electron and hole mobilities µn and µp respectively. When the…

A: The solution is given below

Q: With regard ton-type extrinsic semiconductors, which one of the following explanations is not…

A: From given question, N-type semiconductor is the type of extrinsic semiconductor in which the…

Q: 1 (a) Why Ge material has a lower Vbi than Si at T = 300 K and GaAs has a higher Vbi than Si at T =…

A: Built in voltage given by vbi = (kT/q) loge(NaNd/ni2) Here ni is intrinsic concentration  T is…

Q: A chunk of n-type silicon with a of 0.002 cm2 cross-sectional area and 10-3 cm length is connected…

A:

Q: questions: Draw the energy band diagram of the semiconductor. In you drawing, you have to show the…

A: Dear student as per our guidelines we are supposed to solve only one question in which it should…

Q: What length of around copper wire of diameter 1mm will have a resistance 1K ohm if copper…

A: According to the question we have: R=1KΩ, σ=60Ω-m, d=1mm=10-3m The value of length is calculated as:…

Q: (a) Diode is made from n-type and p-type extrinsic semiconductors. Figure Q1(a) shows an example of…

A: Given :    Note :  According to the guidelines of the company we supposed to answer first three sub…

Q: Q1] Electrons in silicon have a mobility of 1000 cm /V-sec. The electric field is applied to make…

A:

Q: H.W5: If the ratio of mopility of electrons to mopility of holes is 3:1 and the condicutivity of…

A:

Q: A semiconductor junction diode, we can say that: a) The diode is composed of two types of crystal,…

A: I am giving the points which illustrate the correct answer.

Q: Q1/Fill in the following blanks and explain the solution steps in d 2-Approximately in a pure…

A: There are two types of charge carriers in a semiconductor these are holes and electrons whereas in a…

Q: Determine the (a) conductivity and (b) resistivity of an intrinsic germanium semiconductor at a…

A: For Germanium at 300 K, Intrinsic carrier concentration: ni=4×1013 cm-3electron mobiliy: μn=5800…

Q: ) The figure below shows the electron and hole concentration in a silicon region. The electron and…

A:

Q: Q3. Copy the diagram of a semiconductor junction diode. Show its p-type and n-type regions and the…

A:

Q: A picce of p-type silicon with a cross section of 1 mm x 1 mm and length of 10 mm has a resistivity…

A: We need to tell about different parameters of extrinsic p type semiconductor.

Q: In an intrinsic semiconductor, the electrical conductivity takes into account the contribution of…

A: We need to tell about whether the given statements are true or false.

Q: 5) Germanium doped with 1024 m³ Al atoms is a semi-conductor at room temperature and each Al atom…

A: a) aluminium is a trivalent impurities.so when Ge  doped with aluminium makes the semiconductor is a…

Q: Explain what will happen to a semiconductor doped by equal concentration of donors and acceptor…

A: Doping:- Doping is the deliberate introduction of impurities through an intrinsic semiconductor in…

Q: QI. In a P-type germanium, n, = 2x10" electrons/m' and the density of boron 4x102 atoms/m. The…

A: For the given data conductivity is calculated before and after adding of boron

Q: For a P-type semiconductor with length of 55mm, the cross-section area of 0.55mm2, and resistance of…

A:

Electrical Heating Unit

The conversion of electrical energy to heat energy is known as electric heating. The heating system that converts the electrical energy to heat energy for various application is called electrical heating unit. Electricity is employed as the firing mechanism in electric heating systems, which transforms electric current to heat. Electric heaters have heating elements in the form of electric resistors.