DRILL EXERCISE 1.6 Given the circuit shown in Fig. DE1.6, (a) use current-divider formulas to determine i, i2, and is; (b) find i,. is=y Answer: (a) 1.5 A, 4.5 A, 9 A; (b)-4 A -5=0 isto - 5= 852 SA 6 A 652 452 1252 ww Ash 8.2 =7is OSA V².

Q: R₁ www www R₂ Rc Bernuarta RE +Vcc En la figura presentada Vcc = 14 V, R₁ = 498 k2, R₂ = 479 kN, Rċ…

A:

Q: A 460-V, 25-hp, 60-Hz, four pole, Y-connected induction motor has the following impedances in ohms…

A:

Q: A 6 pole, delta connected three-phase alternator having 144 slots is wound using double layer lap…

A:

Q: K Given G(s) = (s+1)(s+3)(s+6)² For this system, create a root locus plot. a. Find the value of gain…

A: The open-loop transfer function of a unity-feedback system H(s)=1, is given…

Q: please could give a simplified drawn schematic/diagram to show a how  microcontroller is connected…

A: The above question is based on the interfacing of a microcontroller to a relay circuit.

Q: A power transformer nameplate lists 2 kVA, 500/100 V, 60 Hz. If the 100 V number is the secondary…

A: In this question, we need to determine the current rating of secondary. We know current I= S/Vwhere…

Q: Problem 5. The voltage across a 0.6 µF capacitor is zero for t < 0. For t ≥ 0, the voltage is 40e…

A:

Q: Q8. Assume the switch has been opened for a long time. The switch is closed at t = 0 s. (a) Find the…

A:

Q: What percentage of the energy used in the United States is unnecessarily wasted? Briefly describe…

A: Approximately 68% of the energy used in the United States is unnecessarily wasted, as reported by…

Q: give me diffrence between modefed DH and classical DH and give me exmable solve in classical dh and…

A: It is asked to give diffrence between modified DH and classical DH.Also we need to provide an…

Q: R(s) & 2 2 S+ 2 s+2 2 -I C(s) Calculate the steady-state errors for the step input u(t), ramp input…

A: Given:a system, we need to find:steady state errors for-i) step input u(t), ii) ramp input t,iii)…

Q: A 39-H inductor is in a series circuit with a 12-V battery and a 25-Qresistor. A switch completing…

A: The question is about finding voltage difference across resistor.

Q: Q9. Consider the circuit below. (a) Compute the average AC power for each circuit element. (b)…

A:

Q: Problem 4. The triangular current pulse shown in figure below is applied to a 375mH inductor. i (mA)…

A:

Q: g) (2-t)u(t)-(2-t) u/t - 1) 3 ult) t-s 시는 u/t) ml u/t) k) 2 te

A: Question J-M:Given that,       J) x(t)=(2-t)u(t)-(2-t)u(t-1)      M) x(t)=            Laplace…

Q: BEI30203 Considering a microprocessor has 12-bit address lines to access memory, determine the size…

A: We need to find out size of memory for given adress line .

Q: Use source transformation to reduce the circuit between terminals a and b shown in the figure to a…

A:

Q: PROBLEM: Draw the Bode log-magnitude and phase plots of G(s) for the unity feedback system shown in…

A: Given:a control system with forward path gain,with unity feedback. To draw:Bode log magnitude and…

Q: Find the value of 2 capacitors in parallel with an 8.2uh inductor to produce 1.8Mhz resonance…

A: The value of the capacitance in the resonance circuit needs to be calculated for a given frequency…

Q: Use the Laplace transform to solve the initial value problem y(t) Submit Question y" +4y= 3 sin(t),…

A: Given differential equation is,              y''+4y=3sin(t)  , y(0) =1, y'(0) =-1…

Q: Circuit Value XLI XCI IRI=VS/R₁ IL-VS/XLI Ici=Vs/XCI IT IRI+j(ICI-IL) ZT=VS/IT f=500 Hz f=5 kHz f=50…

A: The circuit diagram,

Q: Obtain the system time response y(t) for the unit step input, if the system transfer function is…

A:

Q: How many 8 bits data blocks can be transmitted per second over 4800 bits/second serial Communication…

A: Given that,       number of bits in a block = 8bits      Total number of bits in a block including…

Q: 232 for owin I Check discreze time signar description = linearity, T C x cm) } ก X (ก) for in or ion…

A: Given y(n) = T{x(n)} = n x(n) Need to find this output system y(n) is linear, causal, memory and…

Q: V2 = 5V + R₁ = 30Ω R2 = 450 V₁=3V R3 = 54N + 1 Ux ↑i = ¼ A R4-8192

A:

Q: 1. > Complete the timing diagram of the following circuit: CK X Y CLR PRST initial Q volue = 0 Y v…

A: A circuit is given byWe need to complete the following timing diagram.

Q: The MOSFET common-source amplifier shown here has 8m= 6 mA/V, ro= 20kQ2, CGS = 5 pF and CGD = 1 pF.…

A: The amplifier circuit is given ashere

Q: Determine the Laplace transform of the following equation

A: The objective of the question is to find the Laplace transform of the function f(t) = e^-3t. The…

Q: An e.m.f. whose instantaneous value at time t is given by v(t) = 283 sin (314t + π/4) volts is…

A: We need to find out active power for given voltage and current.

Q: Draw the amplitude bode plot of G(jω)=(10(1+0.1jω))/(2jω(1+0.5jω))

A: The question is about drawing bode plot for the given transfer function G(jw).

Q: Question 3 Find the Norton equivalent circuit at terminals a-b in the circuit in the fig. 90/30° V…

A: Given:a circuit,we need to compute norton's equivalent.

Q: The rating of a 3 phase synchronous generator is given as 2 MVA, 4400 V, 60 Hz. If the synchronous…

A: MVA rating of generator is S = 2 MVA.Supply voltage V = 4400 V.Inductive reactnace

Q: (a) An instrumentation amplifier shown in Figure 1 is an anplifier of low-level signals used in…

A: In the given questions we need to analyse the given instrumentation amplifier.

Q: #1 For the circuit below, (a) Find the h parameters. (b) Find the g parameters. V₁ 5Ω 20Ω 15 ΩΣ 12 +…

A: The circuit diagram,

Q: 5V +1 6 ΚΩ ww 6 ΚΩ 6 ΚΩ Α 6mA

A: Thevenin's voltage is calculated by removing the load and Thevenin's voltage is calculated across…

Q: Calculate circuit values below. Does the cuicuit change from a lead circuit to a lag circuit as the…

A: capacitance and inductance at differernt frequency

Q: A)Use Superposition Principle to find Vo in the circuit B)Use Thevenin Theorem to find Vo in the…

A: Given:a circuit, we need to find voltage V0 using:a) Superposition theorem. b) Thevenin theorem.

Q: In, R = 16.0 2 and the battery emf is 6.30 V. With switch S₂ open, switch S₁ is closed. After…

A:

Q: Compared with a 2-pole synchronous machine of same frame size and rating with the same excitation, a…

A: Both synchronous motors and synchronous generators make into a synchronous machine. Compared to a DC…

Q: 1: Design a circuit 10 Half-Wave Rectifier with Resistive Load to produce an average voltage of 40 V…

A: A single phase half wave rectifierInput Voltage=120 VOutput Voltage=40 VLoad Resistance=100 ohm

Q: Q2. Design a control logic to implement the following register transfer statements assuming that…

A: Here, the task specified in the question is to design a control logic for the given register…

Q: Compute the quality factor of an RLC series circuit: (ii) if R= 20Ω ,  L =50mH, C = 1μF

A: we need to compute the quality factor of an RLC series circuit having component values, R= 20Ω ,  L…

Q: Suggest a simple op-amp cct to build a Negative Resistor. In other words the resistor seen from the…

A: According to the question, we need to design a simple Op-Amp circuit to build a negative resistor by…

Q: Problem 5. We present a signal with power 5 mWatts and 27 dB SNR into an amplifier with Gain = 20 dB…

A: The noise power, The noise figure, The gain,

Q: current on the Battery

A:

Q: For the RLC circuit shown below, find i(t) and v(t) for all t. 65 1-u(t) A (↓ D + HH 1 1 H 12-2u(t)…

A:

Q: Determine v(t),t> 0. Determine v(t), t>o. вкл www 4k32 10kr www (↑)5A t=0 20kr 15 кл www + 100 μF =…

A: Given:a circuit, we need to find:voltage v(t) for .

Q: Find the voltage drop across (a)

A: The given circuit is We need to determine the voltage drop across (a).

Q: f(t) = 3 sin wt

A:

Q: The diplacement current density is given by the following equation: Jd = 717 sin( 2.1 x10³t - 3.9 y)…

A:

Power Measurement

According to Blondel's theorem, the total power is measured with one less number of wattmeters than the number of wires present in the system. So, a single-phase and two-wire system will require one wattmeter and a single-phase and the three-wire system will require two wattmeters, and a three-phase and the three-wire system will also require two wattmeters and a three-phase and the four-wire system will require three wattmeter devices. The wattmeter is a device that measures power using one voltage and one current input as shown in the above figure. Multiple current or voltage input pair cables are used by many power analyzers and digital storage oscilloscopes (DSOs) for measuring watts, in effect within a single instrument acting as multiple wattmeters. It is possible to measure three-phase and four-wire power with one correctly specified power analyzer.