Determine whether or not this signal is periodic, if so, determine the fundamental period
Q: Q2: Find Thevenin's equivalent across terminals a and b in the circuit of Fig. (1). ting the…
A:
Q: Question 2 Find the total resistance RT R, 100 R. 50 R, 100 R₁ {10 R. 20 R, 10 Figure 2 R, 250
A:
Q: Question 1:find Vo 5Ω 4Ω Vo www 1Ω www 3Ω +1 9V +)3V
A: The given circuit is,
Q: The Light Emitting Diodes
A: Given- Given- LED voltage = 1 Volts Current = 30 mA To find- Value of R for given data =?
Q: Simplify the following Boolean function F, together with the don't care conditions d and then…
A: Given that: The Boolean functions are F(A,B,C,D)= ∑(4,12, 7, 2,10,14)d(A,B,C,D)= ∑(0, 6, 8) Find the…
Q: Three identical resistances are connected in star to supply 400 volts. If the value of the line…
A: Solution: Given data Three identical resistances are connected in star, VL=400V, line current…
Q: A steam power station has an overall efficiency of 10% and 0.4 kg of coal is burnt per kWh of…
A: We have an steam power station with overall efficiency as, Efficiency = 10 % 0.4 kg coal is burnt…
Q: A 25 kVA, single phase transformer has iron loss of 400 W and copper loss of 200 W at half load.…
A:
Q: D5.4. A copper conductor has a diameter of 0.6 in. and it is 1200 ft long. Assume that it carries a…
A:
Q: A complex communication satellite has an inbuilt microwave repeater unit, having a mean time to…
A: According to the question, a complex communication satellite has an inbuilt microwave repeater unit.…
Q: 12 Problem: Final the Resistance between ab in the following circuit. b 6 3 un Land $4 2 un 5
A:
Q: 7. A 250 V d.c. shunt-wound generator has an armature resistance of 0.1 22 and a field resistance of…
A: Given a DC shunt wound generator with, Terminal voltage, V = 250 V Armature resistance, Ra=0.1 Ω…
Q: Consider a logic function with three inputs, A, B, and C, and three outputs, D, E, and F. The…
A: It is given that: The function is defined as follows: D is true if at least one input…
Q: A DC source has an open circuit voltage of 30 V and an internal resistance of 1.5 ohm. A resistive…
A: Given, A dc source has open circuit voltage, Vs=Vth=30 V Internal resistance, Rs=1.5 Ω
Q: What is the sensitivity of the galvanometer (that is, whatcurrent gives a full-scale deflection)…
A: Given: Galvanometer has a 25.0-kΩ resistance on its 100-V scale. Required: Sensitivity of the…
Q: Which option is correct and why? 2. Which of the following are characteristics of a closed loop…
A: Closed loop control system:- It is designed to maintain the desired output of the system and is also…
Q: QUESTION 19 7.07 V pp is approximately equal to 2.5 V RMS. O True O False
A: Given statement: 7.07 Vpp is approximately equal to 2.5 Vrms.
Q: r[n], g[n] and h[n] are three signal strings. Write g[n] in terms of r[n], considering the following…
A:
Q: 1GHz satellite antenna has an E-plane beam-width of 12º and on H-plane beam-width of 10°. The…
A: SOLUTION GIVEN--> Frequency f=1GHz…
Q: The current in Ris I = 20 mA units R₁ 100Ω M R₂ 200 Ω
A: Given circuit,
Q: 6. What is the natural frequency of the following system? 5 14s² +358 +350 a) 5 rad/s 18.7 rad/s b)…
A: Given transfer function, Ts=514s2+35s+350
Q: A three phase load is connected in delta to a three phase 440 V, 50 Hz mains. An inductor of 100 mH…
A: Solution: A three phase load is connected in delta, voltage V=440 v, f=50 Hz, Inductor L= 100mH…
Q: 25- Calculate the value of the current "I" needed
A: The given magnetic circuit is shown below. Given information, The air gap flux is φ=6×10-3 Weber.…
Q: A diesel engine power plant has one 600 kW and two 250 kW generating units. The fuel consumption is…
A: We have an diesel engine power plant with total of 3 units, 1 unit of 600 KW 2 unit of 250 KW Fuel…
Q: A d.c. In a brake test of a shunt motor, the following observations were taken: Spring balance…
A: solution: A d.c. In a brake test of a shunt motor; Spring balance reading = tight side W1=30.5 kg,…
Q: A single-phase full-bridge inverter has a DC input voltage of 123 V, and supplies an inductive load…
A:
Q: An office with 30 m * 15 m is illuminated by 40 W fluorescent lamps of lumen output of 2200 lumens.…
A: We have been given an Office area and the given data, Working Area (A) = 30 m * 15 m = 450 m2…
Q: for 0. -3. (a) Write a set of state equations for the mechanical system shown in Fig. 1-P3. The…
A:
Q: If the resistances 10, 20, 30, 40 are parallel, then the equivalent resistance (2) is
A:
Q: Assuming ideal op amps, find the voltage gain vo/vi. Show all steps and assumptions clearly. τι; α…
A: Given circuit: Feedback resistance, Rf=100 kΩ Input resistance, Rin=20 kΩ
Q: 5. What is the total capacitance of a circuit with three capacitors connected in series with the…
A: Given data, Capacitance is given C1=0.015 F, C2=0.015 F, C3=0.015 F
Q: Calculate the power dissipated by the voltmeter and by resistor R given figure when (a) R = 250 ohm…
A:
Q: (d) Calculate the output active power, apparent power and the power factor. (e) Suggest how the…
A:
Q: An electronic circuit contains a 47mH inductor and a 2.2nF capacitor. For the following questions,…
A: Given: An electronic circuit has, L=47 mHX=2.2 nF. Use π=3.142 . Impedance of inductor, XL=930 Ω.
Q: *Explain the process here; how to determine the resistor value using the color coders and nominal…
A: Color code of the resistor: Gold and silver color denoted the 5% and 10% tolerance respectively.
Q: 4.1 A single core aluminium cable with a length of 120 m has a uniform diameter of 12 mm. If the…
A: The given data is, Length of cable, L=120 m. Diameter, d=12 mm. Resistivity of aluminium, ρ=0.0182…
Q: 2. Design a circuit that implements function p below using AND, OR, and NOT gates. DO NOT change the…
A: It is given that: fio,i1,i2=i2ioi1+io'i1'.i2'+i1'
Q: .1 During the tensile test of IRON(Fe) sample, the results in respect of load and orresponding…
A: GIVEN: A table of sample of result of load and corresponding extension FIND: (1) number of proton,…
Q: Three Provent Shiropari Transmission Lines are taked on three disk suspension insulator. Potentials…
A:
Q: H.W.2 For the circuit shown, determine the feedback topology & determine Ave, Rif, Rof Is V₂ Rs SO…
A:
Q: What Is the jobs done by registers inside a CPU
A: A register is each of a small set of knowledge-holding locations that are part of a pc processor. A…
Q: As shown, the battery has emf ε = 18.0 V and the other circuit elements have values L = 0.400 H, R1…
A: NOTE_ “Since you have posted a question with multiple sub-parts, we will solve first three subparts…
Q: The color code for a 2.2K Q resistor with 5% : tolerance is O Orange - Orange - Brown -Gold O Red -…
A: The given data is, The resistor is 2.2 kΩ with 5% tolerance.
Q: In the circuit in the figure R R emf of the battery& = 25 V. %3D All the inductors are of the same…
A: The given circuit diagram is shown below: It is given that: ε=25 VL=0.064 HRo=6 ΩR1=4 ΩR2=8 ΩR3=8…
Q: What is the main difference between permanent and induced magnets?
A: Magnet: A object/material that creates magnetic field is termed as magnet. The most noteworthy…
Q: B₁ E₁=12V H R₁=2 D I₁ B G E₂=9V R₂=4 12 R6=12 B₂ F R4=8 R3=6 13 B3 E3=6V D E R5=10
A:
Q: The voltage signals VA and VB from two sensors need to be conditioned to obtain an output voltage…
A: Given : Output voltage VOUT=AVA-VB Gain A is between 0 to 100 Find : Circuit used to perform the…
Q: 33-Draw the root-Locus for the open-loop k(+12) 5³+3,5¹² +95¹ 42 T.F.
A: In this question we need to draw a root locus of the given open loop transfer function.
Q: If the resistance is 2 ohms and reactance is 4 ohms, what is the impedance?
A: Given: Resistance R=2 Ω and reactance XL=4 Ω are connected in series.
Q: An LTI systems with input as R₁ (t) = au(t) produce response C₁ (t) = (1 - C. e¯2t) u(t). The…
A: Given an LTI systems with, Input, R1t=αut Produce response, C1t=1-e-2t ut Transfer function of the…
Determine whether or not this signal is periodic, if so, determine
the fundamental period.
Step by step
Solved in 2 steps with 1 images
- If the measured values of R1 = 323.1 Q, R2 = 324.2 Q and R3 = 324.7 Q, calculate the difference in measured R compared to your calculation of equivalent R in Ohms? KIT NO. 1PASCO EM-8622 SCIentfic CYRCUIT EXPERIMENT TENMA 72-7780 1079 A C Auto Range 6000 Counte True RMS Multimeter ANGE MAX/MIN RELA Hz/% DILIGHT SELECTIVR.C Hz% mA H Am Hz% ONCV 60A. CE A (10mviA) VOHZC ww COM FUSED FUB RICircuits 1 HW 7 Q4The Value of R1 is 39.4Ohms. explain
- One steradian represents (rad)^3 O 2rad O (rad)^2 O none OPhotos-20200417 22546jpg See all phohos O Add toa creation X (dit & Creater E Share 100 GLS) = (S+1)(st 10) (S+50) PA=? GM=? Static Error constant = ? 00:00:04 1101 PM d0 O ENG 4/17/20r cut 1oum 20gm 1ocm 个 //// wax poper/ A capacitur is mad by sandwiching a sheet of wax psper between two sheebs of aluminum fail, as shoumm What is the figue. capacitance! I the capacitoris aut into twopieces, alme the hme, what oil be the expacitenel of each Diece ? wiggly What lo be the capactnce
- R1 85 RB 1.5. SiliconD1 Vs 12 0.7 +1)You will calculate the time constant for the circuit shown in the illustration below using Equation 1-1: AC source 4 w 1000 HH Figure 1-3 Calculate the RC time constant C1 1pF 1-6 What is the time constant of this circuit, in milliseconds (ms)?electirical circuit 1 please slove it fast in 5 minutes
- Sol this Q fast plzCalculate the signal and display it on the coordinate plane δ[n] unit sample signal and u[n] unit step signalBand 1 GR R y BU G GR BN G Band 2 R W V V GR BU R GR W BU Band 3 BN R BL S R R BL GO BL R Table 1 Resistor Color Codes and Measurements Band 4 GO 60 GO GO GO GO GO GO GO GO Band 5 Theoretical value R Plus Tolerance 8205% 8612 3 900±5% 40952 3705 27 2±5% 28-35 25-65 0.47±5% 0-493552 0.44651 71402 6800 ± 5% 5600 55880 82nt 5% 1-82±5% 86-1-22 1.892 R Minus Tolerance 39 150 40.952 56001 ± 540 5880 Measured Value 7792 8012 38542 26 0.45 6460 6630 53201 5570 77-92 80.5 #1.712 37.05~ 5320 2 1.82 39.25 5520 MAKE A CONCLUSION FOR THIS (8 SENTENCES ONLY) The content must be the connection of resistor color codes to tolerances and the relationship of the measured value to the theoretrical value