Determine the time constant. Write the mathematical expression for the current It after the switch is closed Repeat part (b) for VL and VR Determine il and VL at one three- and five-time constants. Sketch the waveforms of iL,VL and VR

Determine the time constant. Write the mathematical expression for the current It after the switch is closed Repeat part (b) for VL and VR Determine il and VL at one three- and five-time constants. Sketch the waveforms of iL,VL and VR

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter9: Current And Resistance

Section: Chapter Questions

Problem 63P: Consider a power plant is located 60 km away from a residential area uses Q-gauge (A=42.40mm2) wire...

See similar textbooks

Related questions

Q: For a classroom demonstration, a professor built an RL circuit similar to the one shown in the…

A: Given: V=6.00 vL=4.80 mH =4.80*10-3 HR=2.60 ohm

Q: Your RL circuit has a characteristic time constant of 20.0 ns, and an inductance of 0.150 H. • What…

Q: An RLC series circuit has a voltage source given by E(t)=20 V, a resistor of 150 Ω, an inductor…

A: In a RLC circuit , at resonance the angular frequency is calculated by using the formula ω=1LC ,…

Q: The dynamic power of a processor was reduced ONLY by reducing the voltage and not the frequency of…

A: The dynamic power of a processor was reduced ONLY by reducing the voltage and not the frequency of…

Q: For a classroom demonstration, a professor built an RL circuit similar to the one shown in the…

Q: A 40 V (volt) battery is connected to a simple series circuit in which the inductance is 0.2 H…

Q: An RL circuit has an emf given (in volts) by 4 cos t, a resistance of 100 ohms, an inductance of 4…

Q: Switch S is closed at time t =0, initiating the buildup of current in the 15.0 mH inductor and the…

Q: Find the steady-state current q (t) on the capacitor and the current i (t) in the given LRC-series…

A: The equation for the given LRC circuit is,…

Q: For the circuit shown in FigureP18.30, use Kirchhoff’s rules to obtain equationsfor (a) the upper…

A: a)Resistance R1 is 8Ω, resistance R2 is 5Ω, resistance R3 is 11Ω, and resistance R4 is 7Ω,…

Q: 10 Ω d 1Ω a o 6Ω Rab 3Ω 4Ω 5Ω 12Ω bo b ww ww ww

Q: Using applications of Differential Equations. If the circuit is moved to position 2, find the…

Q: A 1.7 kg body oscillates in SHM on a spring that, when extended 2.4 mm from its equilibrium…

A: Write the expression for the angular frequency of oscillation.

Q: A battery is connected to a series RL circuit at time t= 0. At what multiple of tL will the current…

Q: A constant inductance of one henry and a variable resistance R are connected in series with a…

Q: List any two applications of A. C. Circuit.

A: When a circuit is excited using an alternating source instead of direct current, then this type of…

Q: How long would it take, following the removal of the battery, for the potential difference across…

Q: What is the inductance of a series RL circuit in which R = 1.0 KΩ if the current increases to…

A: Given : R = 1 kΩ = 1000 Ω I = Io/3 t = 30 μs = 30 x 10-6 s

Q: Find the current at any time t > 0 for an RLC circuit with inductance 0.02 H, resistance 40 N, and…

Q: What is the capacitance of an oscillating LC circuit if the maximum charge on the capacitor is 1.60…

Q: The rms current in a copy machine is 7.61 A, and the resistance of the machine is 18.1Ω. What are…

Q: This setup is referred to as a balanced bridge, since VAB is very close to zero. In the above…

A: The resistances are set as the voltage across A and B is equal to zero. VAB=0

Q: If there is initially 12V across a 100 ohm resistor in an RL circuit (only a resistor in series with…

A: R-L Circuits: R-L circuits are the circuits in which there is one energy storing element (inductor)…

Q: In the circuit shown in Fig., neither the batterynor the inductors have any appreciable resistance,…

A: Given that, First capacitor C1=25.0 μF Second capacitor C2=35.0 μF First inductance L1=15.0 mH…

Q: At time t = 0 a current of 2 amperes flows in an RLC circuit with resistance R = 40 ohms, inductance…

Q: In one short sentence, explain why we calculate the root-mean-square of say the AC (alternating…

A: Introduction - Root mean square or RMS value also called virtual value of any AC wave is that amount…

Q: A battery is connected to a series RL circuit at time t= 0. At what multiple of t will the current…

Q: An electrical engineer designed an RL circuit similar to the one shown in the figure, with E = 6.00…

Q: Please choose the right answer for questions below: Seç. (a) What is the reactance of 2.5 Henry…

A: As per bartleby guidelines, we can only answer one question at a time. So, we are answering question…

Q: 1. A 2.0 Ω resistor is connected to a non-ideal source with internal resistance equal to 1.0 Ω and…

A: Loop equation is as follows: 15+8I2+3I1=0…

Q: In the circuit below, a battery supplies a constant voltage of 40 V, the inductance is 2 H, the…

A: Supply voltage, V = 40 V The inductance, L= 2 HThe resistance, R = 10 Ω

Q: Consider an LC circuit in which L = 480 mH and C = 0.108 µF. (a) What is the resonance frequency w,?…

Q: Find the approximate formula expressing the mutual inductance of two thin coaxial loops of the same…

A: Write the given values of the problem- Radius=a Distance=l

Q: Aseries circuit contains a resistor with R = 40Ω, an inductor with L = 2 H, a capacitor with 0.0025…

A: Given : Resistor, R = 40 Ω Inductor, L = 2 H Capacitor, C = 0.0025 F Voltage, V(t) =…

Q: The charge q on a capacitor in a simple a-c circuit varies with time according to the equation q = 3…

Q: The diameter of the inner conductor of a coaxial cable is 0.5 mm, the inner diameter of the outer…

Q: The sum of the electrical and magnetic energies in an L-C circuit is 0.800 J. At a certain instant…

Q: Charges on the capacitors in three oscillating LC circuits vary as follows, where q is in coulombs…

Q: A 0.50 kg body oscillates in SHM on a spring that, when extended 2.0 mm from its equilibrium…

Q: Using mesh analysis, determine the loop currents (I1, I2, I3) and load current at 4Ω and 1Ω.

A: Ans:- Image-1

Q: Consider an LC circuit in which L = 470 mH and C = 0.112 µF. (a) What is the resonance frequency w,?…

Q: What resistance R should be connected in series with an inductance L= 220 mH and capacitance C= 12.0…

A: Assume it is a RLC circuit, thus the expression for the time of N cycles is given is,

Question

For the circuit in fig.11.78

composed of standard values:

Determine the time constant.
Write the mathematical expression for the current It after the switch is closed
Repeat part (b) for VL and VR
Determine il and VL at one three- and five-time constants.
Sketch the waveforms of iL,VL and VR.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Trending now

This is a popular solution!

Step by step

Solved in 4 steps with 5 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

Mixing (non reacting fluids), Electric circuits. Problem: If the switch is closed, how long will it take for the circuit current to reach maximum? Assume that the initial current is 0 A.
For the following circuit diagram determine I(s). where I(s) is the Laplace function of current. The value of the resistor is (1/14) Ohm, Value of the capacitor is (13/25) Farad. Consider ramp input at V; and zero initial conditions. R i (t) Vị
what will be the equation for loop cfebc and answer for node c using kcl.
Compute for the voltage Vac in the circuit shown below.
A circuit outputs a digit in the form of 4 bits. 0 is represented by 0000, 1 by 0001, ..., 9 by 1001. A combinational circuit is to be designed which takes these 4 bits as input and outputs 1 if the digit ≥ 5, and 0 otherwise. If only AND, OR and NOT gates may be used, what is the minimum number of gates required?
Now take ɛ = 15V, C = 20 µF, and R = 4.0 X 105Q and charge the capacitor in the RC circuit. (4) What is the equation of the current as a function of time? (5) What is the maximum current? (6) What is the equation of the charge on the capacitor as a function of time? (7) What is the maximum charge? (8) What is the time constant for this circuit?
A control mechanism for a vending machine accepts nickels and dimes. It dispenses merchandise when 20 cents is deposited; it does not give change if 25 cents is deposited. Design the FSM asynchronous circuit that implements the required control, using as few states as possible. Determine the suitable state assignment and derive the minimum next-state and output expression.
(A) If the resistor color code has measured values between 7.79 2 and 8.61Q, what is its nominal value and tolerance? And then record resistor color code bands. (B) Using CDR to determine i-line and all i-branches for the circuit in Fig. below: 120 V 6Ω 1Ω 2Ω
Apply the loop rule to loops abgefa and cbgedc.
Total resistance in a parallel circuit is less than your smallest resistor. The reason for this prob is that the total resistance has to divide, (or) split up. Can you help me to conceptualize this, which would get into the difference between parallel versus series circuit.
(a) Define the electromotive force and explain the physical mechanism of theelectromotive force source.(b) One circuit has constructed by electromotive force source which has ε = 5Vand inner resistivity r = 1Ω. Two serial connected resistances which havevalues of R1 = 1Ω and R2 = 5Ω placed in that circuit. Calculate thepowers dissipated in R1, R2 and r.
When the switch just closod, the current through the circuit is: AV Oa zero if it is the only capacitor, but maximum if there is another capacitor in series with it. Obzero. Ocat its maximum value Od equal to the current in a resistive circuit in parallel with the capacitor circuit Oe greater than the current in a resistor that is farther from the battery than the capacitor. AMoving to another question will save this response.