Q: Find the force against a dam that is 8 meters deep and 83 meters long. The density of water is 1000…
A:
Q: a stream of water in steady flow from a kitchen faucet. At the faucet, the diameter of the stream is…
A: Given, The diameter of the stream = 0.940 cm. The volume of the container = 125 cm3. Time taken by…
Q: freshueter labe ( r000 A wooden boat is placed in a If ţ of the boat remeins above the water level,…
A: Density of water = 1000 kg /m³
Q: A force of 160N is applied to an object of area 5 m? Calculate the pressure ?
A: Given data : Force = F Area = A To find :…
Q: A small statue is recovered in an archaeological dig. It's weight is measured to be 52.4 pounds, and…
A: The weight density is
Q: A 70kg statue lies at the bottom of the sea. Its volume is 30,000m³. How much force is needed to…
A: Weight of the statue is m = 70 kg Volume of the statue is V = 30000 cm3 The statue replaces water of…
Q: If a municipal reservoir containing 185.0 acre-feet of water is drained at a rate of 5000.0 gallons…
A: The volume of the reservoir, VR = 185.0 acre-feet The rate at which water is drained, R = 5000…
Q: An ore loader has a weight of 1,200 metric tons. Convert this to a) lbs., b) N, c) gal and d) kg.
A: Given: The weight of the ore loader is 1200 metric tons.
Q: A reservoir has a surface area of 50.0 km2 and an average depth of 40.0 m. What mass of water is…
A: Given: The surface area of the dam is 50.0 km2. The depth of the dam is 40.0 m. Introduction: The…
Q: The small piston of a hydraulic press has an area of 85.0 cm 2. If the applied force is 1,750 N,…
A: Given data: Area of first piston (A1) = 85.0 cm 2 Applied force (F) =1,750 N Force required to pull…
Q: Assume it takes 10.0 min to fill a 35.0-gal gasoline tank. (1 U.S. gal = 231 in.3) Calculate the…
A: From unit transformation,
Q: granite has a mass density of 2650kg/m3.. find its weight density in lb/ft3
A: We know that , 1 pound(lb) = 453.6 g , that means 1kg = (1000/453.6) lb. Again we know that 1 fit…
Q: 3. cos t dt
A: Answer Using integration by parts formula we can find the result of this question
Q: The radius of as pnere of lead (B-4.2x101oNIm?)s lo00m ho a depth Of 1.10 X 104m wnere itis expused…
A: Given that:- Bulk modulus of lead=4.2×10^10 N/m^2
Q: An ore loader has a weight of 1,200 metric tons. Convert this to a) Ibs., b) N, c) gal and d) kg.
A: Comment: Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the…
Q: Workout the problem. How much Density can a Nickel have if it weighs 540 grams and has a Volume of…
A: The expression for the density is given as, Here, m and V represent the mass and volume,…
Q: 1%38 cm MASS of the obje a. Volume of th (Hint: V = b. Density of th (Hint : Den= C. Given that de…
A: Given data: Length of the object, l=8 cm Width of the object, w=6 cm Height of the object, h=5 cm…
Q: An iron block weighs 5N and has a volume of 200cm3. What is the density of the block in kg/m3?
A:
Q: Suppose 1.0 cubic meter of oil is spilled into the ocean. Find thearea of the resulting slick,…
A: Given data: Volume of oil, V = 1 m3 Thickness of each molecule, We have to determine the area that…
Q: My rock has a mass of 16 g and a volume of 2 cm3. What is it's d
A: (13)Given values:- Mass of the rock,(m)=16 gm=0.016 kg ----(1) Volume,(V)=2 cm3=2 x 10-6 m3 -----(2)…
Q: A cylindrical metal tank measures 1.0 meter in diameter and 1.5 meters in height. It can hold how…
A:
Q: A moon rock has a mass of 3.00 kg and a volume ofv0.0283 m3. What is the rock's density (in kg/m3)?
A:
Q: A severe thunderstorm dumped 2.8 in of rain in 30 min on a town of area 34 km2. What mass of water…
A: The volume of the rain water is
Q: Two streams merge to form a river. One stream has a width of 8.7 m, depth of 3.1m, and current speed…
A:
Q: The amount of water in reservoirs is often measured in acre-ft.One acre-ft is a volume that covers…
A: Given information:1 acre = 43560 ft2Given quantity = 25.0 acre-ft = 25.0 (43560 ft2). ft = 1089000…
Q: An oil tank is in the form of a right circul Find the total force on one e horizontal. 50 N/cubic…
A: GivenDiameter of right circular cylinder, d=4 mWeight density of oil, W=50 N/m3
Q: What is the mass of 5 m³ of cement of density 3000 kg/m³?
A: Given data : Density=3000 kg/m3 Volume=5 m3 To find : Mass
Q: A cylindrical tank with a large diameter is filled with water to a depth D = 0.30 m. A hole of…
A:
Q: ) A heavy thunderstorm dumps 12000 m' of water on a 6.0 acre flat piece of land (1 acre = 43560 ft).…
A: Given data *The given volume of water is V = 12000 m3 = (12000 × 35.31) ft3 = 423720 ft3 *The area…
Q: Suppose that it takes 15.3 hours to drain a container of 72.7 m3 of water. What is the "mass flow…
A: Time taken to drain the container is T= 15.3 hours Volume of container is V = 72.7 m^3
Q: Suppose a force of 100 N is applied to a piston with a cross sectional area of .0005 m2. what would…
A: F1A1=F2A2F2=F1A1A2
Q: A hydraulic lift raises a 2 000-kg automobile when a 500-N force is applied to the smaller piston.…
A:
Q: A force of 140N is applied to an object of area 4 m? Calculate the pressure ?
A:
Q: Oil (SG = 0.93) is pumped from a well. If the pump is 11.7 ft above the surface of the oil, what…
A:
Q: A small piston of a hydraulic press has an area of 20cm2. If the applied force to the piston is…
A: Area of smaller piston= 20 cm2Applied force on smaller piston = 75 N Force exerted on Larger piston…
Q: a hydraulic piston with a face area of 3E-4 m2 is paired with another, larger, hydraulic piston. If…
A:
Q: A force of 140N is applied to an object of area 2 m?. Calculate the pressure ?
A: Given data : Force = F Area = A To find : Pressure
Q: What is the density of a door with a mass of 250 kg and a volume of 1890m3
A:
Q: Assume it takes 7.00 minutes to fill a 30.0-gal gasolinetank. (a) Calculate the rate at which the…
A: (a). the rate at which the tank is filled in gallons per second is
Q: rillage wishes to measure the quantity of water that iped to a factory during a typical morning. A…
A:
Q: A large chunk of metal has a mass of 393 kg and its volume is measure to be 0.05m^3 What is the…
A:
Q: Estimate the time it would take (in hours) to fill a private swimming pool with a capacity of 90,000…
A:
Q: A standard 1 kilogram weight is a cylinder 44.5 mm in height and 55.0 mm in diameter. What is the…
A:
Q: Calculate the available water holding capacity (A.W.H.C)... With units as well
A: AWHC(Available water holding capacity) is the total amount of water that a soil can retain after…
Q: The amount of water in reservoirs is often measured in acre-ft. One acre-ft is a volume that covers…
A: Given value--- 1 acre = 43560 ft2 . We have to find--- Find the volume in SI units of a reservoir…
Q: Lenz’s Law is a consequence of the law of conservation of
A: Question: Lenz’s Law is a consequence of the law of conservation of_______________
Step by step
Solved in 2 steps with 1 images
- The first atomic bomb was detonated on July 16, 1945, at the Trinity test site about 200 mi south of Los Alamos. In 1947, the U.S. government declassified a film reel of the explosion. From this film reel, British physicist G.I. Taylor was able to determine the rate at which the radius of the fireball from the blast grew. Using dimensional analysis, he was then able to deduce the amount of energy released in the explosion, which was a closely guarded secret at the time. Because of this, Taylor did not publish his results until 1950. This problem challenges you to recreate this famous calculation. (a) Using keen physical insight developed from years of experience, Taylor decided the radius rof the fireball should depend only on time since the explosion, t, the density of the air, , and the energy of the initial explosion, E. Thus, he made the educated guess that r=kEabtcfor some dimensionless constant kand some unknown exponents a,b, and c. Given that [E]=ML2T-2 , determine the values of the exponents necessary to make this equation dimensionally consistent. (Hint: Notice the equation implies that k=rEabtcand that [k]=1 ). (b) By analyzing data from high-energy conventional explosives, Taylor found the formula he derived seemed to be valid as long as the constant khad the value 1.03. From the film reel, he was able to determine many values of rand the corresponding values of t. For example, he found that after 25.0 ms, the fireball had a radius of 130.0 m. Use these values, along with an average air density of 1.25kg/m3 , to calculate the initial energy release of the Trinity detonation in joules (J). (Hint: To get energy in joules, you need to make sure all the numbers you substitute in are expressed in terms of SI base units.) (c) The energy released in large explosions is often cited in units of “tons of TNT” (abbreviated “t TNT”), where 1 t TNT is about 4.2 GJ. Convert yow answer to (b) into kilotons of TNT (that is, kt TNT). Compare your answer with the quick-and-duty estimate of 10 kt TNT made by physicist Enrico Fermi shortly after witnessing the explosion from what was thought to be a safe distance. (Reportedly, Fermi made his estimate by dropping some shredded bits of paper right before the remnants of the shock wave hit him and looked to see how far they were carried by it.)Estimates and Fermi Calculations Assuming the human body is made primarily of water, estimate the volume of a person.Check Your Understanding Suppose we want the formula for the volume of a sphere. The two expressions commonly mentioned in elementary discussions of spheres are 4r2 and 4r3/3 . One is the volume of a sphere of radius r and the other is its surface area. Which one is the volume?
- Assume it takes 7.00 min to fill a 30.0-gal gasoline tank. (a) Calculate the rate at which the tank is filled in gallons per second. (b) Calculate the rate at which the tank is filled in cubic meters per second. (c) Determine the time interval, in hours, required to fill a 1.00-m3 volume at the same rate. (1 U.S. gal = 231 in.3)How many cubic centimeters (cm3) are in one cubic meter (m3)?A commonly used turn of mass in the English system Is the pound-mass, abbreviated Ibm, where 1 Ibm = 0.454 kg. What is the density of water in pound-mass per cubic foot?
- A floating-point operation is a single arithmetic operation such as addition, subtraction, multiplication, division. (a) Estimate the maximum number of floating- point operations a human being could possibly perform in a lifetime. (b) How long would it take a supercomputer to perform that many floating-point operations?Units and Standards What is the difference between a base unit and a derived unit? (b) What is the difference between a base quantity and a derived quantity? (c) What is the difference between a base quantity and a base unit?Check Your Understanding We know horn Figure 1.4 that the diameter of Earth is on the order of 107m , so the order of magnitude of its surface area is 1014m2 . What is that in square kilometers (that is, km2)? (Try doing this both by converting 107m to km and then squaring it and then by converting 1014m2 directly to square kilometers. You should get the same answer both ways.)
- Check Your Understanding Figure 1.4 says the mass of the atmosphere is 1019kg . Assuming the density of the atmosphere is 1kg/m3 , estimate the height of Earth’s atmosphere. Do you think your answer is an underestimate or an overestimate? Explain why. How many piano tuners are there in New York City? How many leaves are on that tree? If you are studying photosynthesis or thinking of writing a smartphone app tot piano tuners, then the answers to these questions might be of great interest to you. Otherwise, you probably couldn’t care less what the answers are. However, these are exactly the soils of estimation problems that people in various tech industries have been asking potential employees to evaluate their quantitative reasoning skills. If building physical intuition and evaluating quantitative claims do not seem like sufficient reasons tot you to practice estimation problems, how about the fact that being good at them just might land you a high-paying job? For practice estimating relative lengths, areas, and volumes, check out this PhET (https://openstaxcollege.org/l/21lengthgame) simulation, titled “Estimation.”A fluid ounce is about 30mL. What is the voIume of a 12 fl-oz can of soda pop in cubic meters?State how many significant figures are proper In the results of the following calculations: (a) (106.7)(98.2)/(46.210)(1.01) ; (b) (18.7)2 ; (c) (1.601019)(3712)