Consider the circuit below. Assume that the capacitor is initially uncharged. V₁=24 V R₁ = 10 kn: R2 = 30 ΚΩ www Description of Image a. What is the initial current through resistor R₂ when the switch is closed (t = 0)? Current through R₂ at t = 0 is 8 O = 0.8 mA. 100 οι C₁ = 10 μF Hint b. What is the current through resistor R₂ when the capacitor is fully charged, long after the switch is closed (too)? Current through R₂ as t→∞o is .6 c. What happens if the switch is opened after it has been closed for some time? Choose the most correct statement below. Current flows through C₁ but not R₁ or R₂. Current flows through V₁, R₁, R2, and C₁. Current flows through R₁ and C₁ but not R₂. O = 0.6 mA. No current flows anywhere in the circuit. Current flows through C₁ and R₂ but not R₁. Current flows through R₁ and C₁ but not R₂. X

Consider the circuit below. Assume that the capacitor is initially uncharged. V₁=24 V R₁ = 10 kn: R2 = 30 ΚΩ www Description of Image a. What is the initial current through resistor R₂ when the switch is closed (t = 0)? Current through R₂ at t = 0 is 8 O = 0.8 mA. 100 οι C₁ = 10 μF Hint b. What is the current through resistor R₂ when the capacitor is fully charged, long after the switch is closed (too)? Current through R₂ as t→∞o is .6 c. What happens if the switch is opened after it has been closed for some time? Choose the most correct statement below. Current flows through C₁ but not R₁ or R₂. Current flows through V₁, R₁, R2, and C₁. Current flows through R₁ and C₁ but not R₂. O = 0.6 mA. No current flows anywhere in the circuit. Current flows through C₁ and R₂ but not R₁. Current flows through R₁ and C₁ but not R₂. X

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter10: Direct-current Circuits

Section: Chapter Questions

Problem 74AP: Consider a circuit that consists of a real battery with an emf and an internal resistance of r...

See similar textbooks

Similar questions

A battery has an emf of 15.0 V. The terminal voltage of the battery is 11.6 V when it is delivering 20.0 W of power to an external load resistor R. (a) What is the value of R? (b) What is the internal resistance of the battery?
A 12.0-V emf automobile battery has a terminal voltage of 16.0 V when being charged by a current of 10.0 A. (a) What is the battery’s internal resistance? (b) What power is dissipated inside the battery? (c) At what rate (in °C/min ) will its temperature increase if its mass is 20.0 kg and it has a specific heat of 0.300 kcal/kg • °C, assuming no heat escapes?
A student makes a homemade resistor from a graphite pencil 5.00 cm long, where the graphite is 0.05 mm indiameter. The resistivity of the graphite is =1.38102/m . The homemade resistor is place inseries with a switch, a 10.00-mF capacitor and a 0.50-V power source, (a) What is the BC time constant of the circuit? (b) What is the potential drop across the pencil 1.00 s after the switch is closed?
Consider the circuit shown in Figure P28.21 on page 860. (a) Find the voltage across the 3.00-0 resistor, (b) Find the current in the 3.00-12 resistor.
The- pair of capacitors in Figure P28.63 are fully charged by a 12.0-V battery. The battery is disconnected, and the switch is then closed. Alter 1.00 ms has elapsed, (a) how much charge remains 011 the 3.00-F capacitor? (b) How much charge remains on the 2.00-F capacitor? (c) What is the current in the resistor at this time?
(a) When the switch S in the circuit of Figure P28.14 is closed, will the equivalent resistance between points a and b increase or decrease? State your reasoning. (b) Assume the equivalent resistance drops by 50.0% when the switch is closed. Determine the value of R.
Consider a circuit that consists of a real battery with an emf and an internal resistance of r connected to a variable resistor R. (a) In order for the terminal voltage of the battery to be equal to the emf of the battery, what should the resistance of the variable resistor be adjusted to? (b) In older to get the maximum current from the battery, what should the resistance variable resistor be adjusted to? (c) In order for the maximum power output of the battery to be reached, what should the resistance of the variable resistor be set to?
(a) During surgery, a current as small as 20.0A applied directly to the heart may cause ventricular fibrillation. If the resistance of the exposed heart is 300 what is the smallest voltage that poses thisdanger? (b) Does your answer imply that special electrical safetyprecautions are needed?
Explain why R=R0(1 + a?T) for the temperature variation of the resistance R of an object is not as accurate as P=P0(1 + a?T) which gives the temperature variation of resistivity P.
A capacitor of capacitance C is connected to four resistors R = 62 R, = 4O R, =90 and R 60 %3D and a battery V= 36 V with an open %3! switch. R, R. R R. What is the voltage across R1 when the switch has just been closed? Select one: O a 21.6 V O b. 0V O c. 14.4 V O d. 36 V The following is a part of a circuit. The potential of V = 200 V is provided at point a that is connected to resistors = 40 2=60 and 3 =9 12:12 PM 5/13/2021 近

In the circuit shown below E = 75.0 V, R5 = 4.0o n, R3 = 2.00 n, R2 = 2.20 n, Iş = 8.40 A, I4 = 5.50 A, and I = 11.0 A. Find the current through Rz and R3, and the values of the resistors R, and Ra. Iz = I3 = A R1 = R. = R4 ww Is ww
Consider the resistor network shown in the figure, with R₁ = 250 [N], R₂ = 1.0 [kN], R3 = 1.2 [kn], R4 = 1.0 [kn], and R5 = 1.5 [k]. The source voltage & is 24 [V], and has no internal resistance. What is the current passing through R₁? W R₁ www www.m R₂ O A. 34 [mA] B. 54 [mA] OC. 96 [mA] OD. 104 [mA] www R3 www-www R4 R5