Consider the amusement-park ride in (Eigure 1). It is observed that the cables are directed at 30° from the vertical. Each car, including its passengers, has a mass of 550 kg. Assume L = 8 m. Figure /30 L- 30 1 of 1 15 m > Part B Also, what are the components of force in the n, t, and z directions which a 75-kg passenger exerts on the car during the motion? Follow the sign convention. Enter the n, t, and z components of the force in newtons separated by comma Fn. Ft. F Submit Provide Feedback 195| ΑΣΦ. It vec Request Answer Re ? Next

Consider the amusement-park ride in (Eigure 1). It is observed that the cables are directed at 30° from the vertical. Each car, including its passengers, has a mass of 550 kg. Assume L = 8 m. Figure /30 L- 30 1 of 1 15 m > Part B Also, what are the components of force in the n, t, and z directions which a 75-kg passenger exerts on the car during the motion? Follow the sign convention. Enter the n, t, and z components of the force in newtons separated by comma Fn. Ft. F Submit Provide Feedback 195| ΑΣΦ. It vec Request Answer Re ? Next

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter7: Dry Friction

Section: Chapter Questions

Problem 7.50P: The block of weight W is pulled by the force P inclined at the angle to the horizontal. Find the...

See similar textbooks

Similar questions

The uniform 240-lb bar AB is held in the position shown by the cable AC. Compute the tension in the cable.
Find the tension T in the cable when the 180-N force is applied to the pedal at E. Neglect friction and the weights of the parts.
Repeat Prob. 4.152 assuming that the 400-kN force is applied at O instead of L.
The figure shows a steel bar being processed by a rolling mill. Given that P=80kN and r =0.016, determine the force F required to advance the bar at a constant speed.
The block of weight W is pulled by the force P inclined at the angle to the horizontal. Find the smallest force P and the corresponding angle that would cause impending sliding of the block. The angle of static friction between the block and the ground is s.
Situation 3 Blooke A ana B weign 30 lo and 50 lo, respectively. B µ = 0.5 20 HBA = 0.6 C HẠC = 0,4 D If the weight of blook Dia to be grestest witnout osueing motion, ueing the coeffioiente of atetio friotion inciceted, whet is the friotional foroe (Ib) between blook A and the floor C? Seleot the corect reoponoe 1275 O 21.25 5.81 40.33 15.72 0.60 43.67 36.04 47.17 26.20 S2 17.25 O O
A gardener uses a 60-N wheelbarrow to transport a 250-N bag of fertilizer. What force must she exert on each handle? (There are two handles and the force is distributed equally to each of them.) 0.15 m 250 N 60 N -0.7 m- -0.15 m
In the following figure, the horizontal surface onwhich this block slides is frictionless. If the two forcesacting on it each have magnitude F = 30.0 N andM = 10.0 kg , what is the magnitude of the resultingacceleration of the block?
The figure shows the finishing position of a body builder's arm who is performing a standing lateral raise with a 5.00-kg dumbbell. This is an excellent exercise that isolates the lateral deltoid muscle. The weight of the arm itself is 42.5 N, and it acts at point A in the figure. Given the information shown, and the fact that 0 = 9.74°, (a) find the magnitude of the tension force in the deltoid (F₁) and (b) the normal force from the shoulder joint (F acting on the humerus bone that holds the arm in this equilibrium position. S (a) Number (b) Number i Fa 0.075 m O 12⁰ 0.250 m Units Units W arm 0.510 m 5 kg WA
The figure shows the Russel fracture traction device and a mechanical model of the leg. The leg is held in balance in the position indicated by the two weights attached to the two cables. The combined weight of the leg and cast is W=180 N. The horizontal distance between points A and B where the cables are attached to the leg is L=100 cm and the vertical distance is d=5 cm. Point C is the center of gravity of the cast and leg at three quarters of the L measured from point A (3L/4= 75 cm). The angle that cable 2 makes with the horizontal is measured as β=30°. Accordingly, in order for the leg to remain in balance in the shown position; a) Find the tensile force T1 in cable 1. (Write your result in N) Answerb) Find the tensile force T2 in cable 2. (Write your result in N) Answerc) Find the angle α of cable 1 with the horizontal. Response
A string holds and wraps around a solid cylinder (7-kg and R = 8-m). A person pulls the string vertically upward, so the cylinder's center of gravity does not move and is suspended in midair for 7 second. Note that the rotational inertia of the cylinder about its axis is MR2/2, the tension in the string is 8- N. what is the net force on the cylinder in Newton? Note: Do not include the unit in your answer. T
Q2/ The out – of - balance of a machine rotor is equivalent to 5 kg at 10 mm radius in one plane A, together with an equal mass at 15 mm radius in a second plane B. AB = 375 mm and the two radii are 120°. Find the mass required in third plane C at a radius of 125 mm and its angular position with respect to the given radii so that there is no resultant out - of - balance force. Find also the position of C along the axis for the residual couple to be a minimum and of this couple when the speed is 500 г.p.m.