Composite headlights are being discussed: TechnicianA says that they have replaceable bulbs. TechnicianB says that a cracked or broken lens will preventthe operation of a composite headlamp. Who iscorrect?a. Technician Ab. Technician Bc. Both A and Bd. Neither A nor B

Composite headlights are being discussed: TechnicianA says that they have replaceable bulbs. TechnicianB says that a cracked or broken lens will preventthe operation of a composite headlamp. Who iscorrect?a. Technician Ab. Technician Bc. Both A and Bd. Neither A nor B

Automotive Technology: A Systems Approach (MindTap Course List)

6th Edition

ISBN:9781133612315

Author:Jack Erjavec, Rob Thompson

Publisher:Jack Erjavec, Rob Thompson

Chapter20: Lighting Systems

Section: Chapter Questions

Problem 3ASRQ: Composite headlights are being discussed: Technician A says that they have replaceable bulbs....

See similar textbooks

Related questions

Q: The ram and plunger of a hydraulic press are 150 mm and 25 mm in diameter respectively. With a…

A: GivenD=150mmd=25mml=30cmW=1 tonnes =1000 kgLift L=1.5mt=25min

Q: y O X 35 kPa 40 kPa 95 kPa

A: As given in question, Stress along x-direction = σx = -95 kPa Stress along y-direction = σy = -35…

Q: Obtain information about K - , E - , and R -type thermocouple wires. Write a brief report discussing…

A: The most popular kind of thermocouple is the type K (Nickel-Chromium/Nickel-Aluminum). It has a…

Q: A diesel engine takes in air at 0.95 bar and 21 o C and operates on the dual combustion cycle.…

A: Write the given data. P1=0.95 barT1=21 °Cr=19P3=P4=68 barQp=0.60QsQv=0.40Qs

Q: 30 kN Find the reactions in datums A and B for the threshold shown in Figure 3. A 10m 3.0m 125 KN 45…

A: The reactions in datums A and B are: ◆ Ax = 15 kN , Ay = 85.31 kN ◆ Bx = 0 kN , By = 110.67 kN

Q: Knowing that a = 45°, a) [ :.] Resolve each force into its x and y components. b) [] Determine the…

Q: The figure shows a pump that draws 840 L/min of crude oil (s= 0.85) in an underground storage drum…

Q: A car jumps out of gear into neutral, particularlywhen decelerating or going down hills: Technician…

A: The gear system in the cars is used to transmit the power from the engine to the wheels as per the…

Q: Consider wind blowing past a house with 10 windows of 1 m wide each as shown in the following…

Q: Calculate the forces in the ribs of the Muslim shown in Figure (1) and are the ribs of the Muslim in…

Q: = 5500 N. For a 8500 N and the tangential force is Ft diagram and assuming the shaft is rotating,…

A: Given as, δx=700kpaδy=100kpa7xy=-400kpa

Q: J 6

Q: For the system of forces shown in Figure (4), find the resultant and direction of the forces and…

A: Given question : For the system of forces shown in Figure, find the resultant and direction of the…

Q: 8. Two equal forces are acting at a point with an angle of 60° between them. If the resultant force…

A: As given in question, Let us consider two forces acting at a point F1 and F2. As these two forces…

Q: A 50 mm long and 4 mm thick fillet weld carries a steady load of 10 kN along the weld. The shear…

Q: Calculate the coefficient of isobaric volumetric expansion and isothermal compressibility, for…

Q: calculations to determine the values of (using the data provided for a heat exchanger): a. work done…

A: As you have posted multiple questions we will solve first 3 sub-parts as per Bartleby guidelines.…

Q: The ram and plunger of a hydraulic press are 150 mm and 25 mm in diameter respectively. With a…

Q: An Otto cycle engine operates with the cycle shown below. The air in the engine can be considered a…

Q: A rubber block is placed between two rigid walls where a load of P = 65 kN is applied on top as…

Q: 6 kN/m A- -3 m -6 m B

A: Given Data A uniform varying load acting on the beam is w=6 kN/m The distance on the beam from the…

Q: 30 kN 60% +1.0 m Find the reactions in datums A and B for the threshold shown in Figure 3. 3.0 m 125…

Q: A cantilever beam is supported by a tie rodat B as shown. Both the tie rod and the beam are…

A: given; distribution load(q)=200lb/ftE=30*10-6psilets take tension force in rod=Treaction force at…

Q: * A hydraulic lift raises a total load of 8 tonnes through a height of 12 m- once in every two…

A: given; total load(m)=8 tonnes =8000kgfor every 2 minute.total load rate…

Q: A 15 m building use cast iron pipes in their piping system. The water tank located on the top of the…

Q: 4.1 Write the expression used to define the following: (a) volumetric efficiency (b) compressor…

Q: Determine the force in member BE of the loaded truss. The force is positive if in tension, negative…

A: BE = 5.4083 kN (Tensile)

Q: 3 * The ram and plunger of a hydraulic press are 150 mm and 25 mm in diameter respectively. With a…

Q: A quantity of moist air of mass 3 kg has a humidity ratio of 0.015 and a relative humidity of 60%.…

Q: Using a lubricant that is thicker than the specifiedlubricant can lead to __ .a. the gear to jump…

A: Given Data : Lubricant

Q: 5 MPa 8 MPa 3 kPa Figure 2: The state of plane stresses. The state of plane stresses is as shown in…

Q: An Otto cycle engine operates with the cycle shown below. The air in the engine can be considered a…

Q: * A 1- Threshold shown in Figure (2), calculate the reactions in datums A, F and 1.5 m 1.5 m 450 N…

Q: he Bernoulli equation when the compressibility effects are not negligible for an ideal gas…

A: 1. The fluid is an Ideal Gas so, P = ρ R T 2. Neglect the frictional effects and the flow is staedy.…

Q: An Otto cycle engine operates with the cycle shown below. The air in the engine can be 0.71 kJ/kgK.…

A: To find : specific heat transfer from state 3-4

Q: 1. Two particles with masses in the ratio 1:4 are moving with equal kinetic energies. The magnitude…

A: Let us represent the properties of the first particle with subscript 1 and the properties of the…

Q: Q2:In the design of the lifting hook the action of the applied force F at the critical section of…

A: Introduction: Hooks are necessary for many rigging applications, although they vary greatly in form,…

Q: .Directional drilling is means many wells can be sunk from several location r false true False .The…

A: Introduction: Drilling is a cutting technique that uses a drill bit to create a circular…

Q: 3.0 m 400 KN B 6.0 m 200 kN 3.0m 800 KN E D 3.0 m 200 kN 3.0 m

Q: 8. A spherical balloon is being filled at a rate of 3 cm³ per 4 second. The Volume of a sphere is…

Q: Determine the z, y, z components of the moment of reaction at B using scalar notation. Expr

Q: 1- Threshold shown in Figure (2), calculate the reactions in datums A, F and E. 1.5 m 1.5 m

Q: 2. Determine the stoichiometric air-fuel ratio of 1 kg butane, assume complete combustion.

Q: A particle's position on the x axis of Fig. 2-1 is given by x=4 - 27t+t³, with x in meters and t in…

A: As stated in the question, Position of a particle as a function of time = x(t) = 4 - 27t + t3 When…

Q: a. b. for which G=27GPa, Determine the maximum shear stress and its location. Angle of twist at end…

Q: Determine stress produced by tensile force of 20 N applied on cross sectional area of 5 mm2

A: Given data: Tensile force (F) = 20 N Cross sectional area (A) = 5 mm2 Need to determine the stress…

Q: C-2 A uniform live load of 300 lb/ft and a single live concentrated force of 1500 lb are to be…

Q: The moment of force P about point A shown in the figure is equal to P= 5N 2 m O 10 05 ..... The rope…

Q: Tavo geometrically similar similar Pumps are running at same speed of 1000 YPM Pump has an impeller…

A: Speed of both pumps, N1=N2=1000 rpmImpeller diameter of first pump, D1=300 mm=0.3 mDischarge through…

Q: 1 The internal and external diameters of the impeller of a centrifugal pump are 200 mm and 400 mm…

A: The centrifugal pump is one of the pumps which differs from other types of the pump such as…

Concept explainers

Radiation

Radiation can be described as the energy in the form of a particular matter or electromagnetic waves traveling in the air and can be in the form of light, sound, and heat. Radiation can be detected through special instruments like X-rays. The radiation from a cooler object is less intense as compared to the radiation from hot objects.

Question

Composite headlights are being discussed: Technician
A says that they have replaceable bulbs. Technician
B says that a cracked or broken lens will prevent
the operation of a composite headlamp. Who is
correct?
a. Technician A
b. Technician B
c. Both A and B
d. Neither A nor B

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Technician A says that a composite headlight housing that is cloudy should be replaced. Technician B says that clouding or oxidizing of the composite housing or lens may be removed. Who is correct? a. Technician A b. Technician B c. Both A and B d. Neither A nor B
Technician A says that a sealed-beam headlight that is cracked should be replaced. Technician B says that cracking or breaking of the composite housing or lens does not prevent a halogen bulb from working. Who is correct? Technician A Technician B Both A and B Neither A nor B
Composite headlights are being discussed: Technician A says that they have replaceable bulbs. Technician B says that a cracked or broken lens will prevent the operation of a composite headlamp. Who is correct? Technician A Technician B Both A and B Neither A nor B
While troubleshooting a headlight problem: Technician A says that when one headlamp does not work, the problem may be a burned-out bulb or lamp. Technician B says that you should check for voltage at the bulb before replacing a bulb. Who is correct? Technician A Technician B Both A and B Neither A nor B
What types of headlights do not have a filament?
Which of the following offer(s) the least protection for your eyes? Face shield Safety glasses Splash goggles Prescription glasses
Which of the following statements about safetyglasses is true?a. They should offer side protection.b. The lenses should be made of a shatterproofmaterial.c. Some service operations require that additionaleye protection be worn with safety glasses.d. All of the above statements are true.
True or False: The BREAK command converts rays into Xlines.
While diagnosing an HID lamp that does not turn on: Technician A says a smoky or blackened lamp may indicate the bulb is burned out. Technician B says before replacing a suspected bad ballast, check to make sure it is getting power and ground. Who is correct? Technician A Technician B Both A and B d. Neither A nor B
Why do some manufacturers protect the headlamp circuit with a circuit breaker instead of a fuse?
Which of the following is(are) true regarding the solargain on windows?A. The solar gain due to north-facing windows is greaterthan the solar gain due to south-facing windows.B. The solar gain due to east-facing windows is greaterthan the solar gain due to west-facing windows.C. The solar gain due to west-facing windows is greaterthan the solar gain due to east-facing windows.D. The solar gain due to south-facing windows is greaterthan the solar gain due to north-facing windows.
A customer comes in with an indirect TPMS, complaining that despite all the tires running low on pressure, the TPMS light never came on. Technician A says it’s likely due to a faulty module. Technician B says it may just be normal operation of an indirect TPMS. Who is correct? Technician A Technician B Both Technician A and B Neither Technician A or B