Charge is: * an electrical property of the atomic O particles of which matter consists, measured in coulombs (C). is the rate of change of the charge, measured in Amper (A). In this figure : * 15 O 11 +12-1 3 +14 1 5 O 11 +12 =1 3 +14 +15 11 +12 +l 3 = | 4 +15

Q: 4) Design a saturated-load gate that implements the logic function Y = A(B +C D) + E . base on the r...

A: Logic gates- Logic gates are mathematical exponential process deals with true or false values instea...

Q: Given a sphere that has Q=30 micro C, radius a=10 mm Find electric field intensity E that is 5 mm aw...

A:

Q: A current transformer has a ratio of 100:2. If the secondary has 402 turns what will be the primary ...

A:

Q: も

A:

Q: In the following circuit : Vout=2.8 V R +1 VoW 22 kM 22 kN R2 +1.8 V oW 22 kN o VOUT Select one: O T...

A: Given circuit,

Q: In a long-shunt compound generator, the terminal voltage is 220 V when generator delivers 110 A. Det...

A: The voltage is 220 V The current is 110 A Consider the current through the shunt is, Ish=VshRsh=220 ...

Q: Find the total capacitance of the combination of capacitors shown in picture. Assume the capacitance...

A:

Q: Design a combinational circuit with three inputs x, y, and z with three outputs A, B, and C, when th...

A: Brief description : According to the given question here they want to design a combinational logic c...

Q: The discrete time periodic signal has (2, 0, 0, 1} samples. The frequency domain samples of the give...

A:

Q: A polarity test is performed upon a 7,620/230-Volt transformer. If the input voltage is 220 Volts, ...

A: In the given question, we have a transformer having the voltages as; Primary voltage, VP=7620V Secon...

Q: Which of the following is a viable clean and renewable alternative to the use of nuclear power to ge...

A: Answer: Natural Gas Explanation: A. It is a valid option. Natural gas is a clean renewable alternati...

Q: A synchronous motor absorbing 60 kW is connected in parallel with a factory load of 240kW having a l...

A:

Q: An inductive circuit of resistance of 2 ohms and inductance 0.01 H is connected to a 250 V, 50 Hz su...

A:  

Q: 3 kN 3 mH ww C1 6 µF R3 1 kN v(t) R2 2 kN ww

A:

Q: *9. Determine Vo, and Vo, for the networks of Fig. 159. Si Ge Si 4.7 k2 1.2 k2 +12 V o Voz -10 Vo- V...

A:

Q: For the given circuit and input waveform, determine the output waveform maximum and minimum voltages...

A: When input voltage will be below 4V then diode will conduct and output become constant at 4V . And w...

Q: (s+0.5)2+4 H(z) Iš designed from H«(s) by many-one mapping method, assuming sampling period T. Then,...

A:

Q: following: • Output (Controlled variable) • Input (Reference value) • Controller • Actuator • Proces...

A: Block diagram of  control system :

Q: 6.Given the circuit below, use Kirchoffs Voltage and Current Law to solve I1, l2 3Ω 42 40V 452 64V 2...

A:

Q: A 1.5k ohms resistor has a voltage drop of 22.5V across it. Can a 1/4W resistor be used for this app...

A:

Q: Find the Norton equivalent with respect to the terminals a, b for the circuit in Fig. P4.650. Figure...

A:

Q: ? She is very young. How is she

A: The given sentence is shown below: She is very young.How ........ is she?

Q: solve the I1, I2, IT using mesh analysis

A:

Q: A power conversion system having an impulse response h[n]={1,-1} accepts the input x[n]={1,-2,2, 1,3...

A:

Q: RMS Average Value Peak Phase Instantaneous Value Value Angle Value (c) ? ? 10 A 30° ? (d) 200 V ? ? ...

A: in the question a sinusoidal signal is given.  V=Vmsinωt Average Value =VmπRMS Value = Vm2

Q: For the cascaded binary symmetric channels shown below, find the maximum amount information transmit...

A: The given figure is shown below:

Q: 2 µF R1 1.2 kN L1 9 H v7(t) R2 C2 6 µF 0.5 kN

A:

Q: 5/ When a silicon material is doped th Arsenic (As) that has 5 valance ectrons, the impurity is call...

A: Penta valent impurity  And when a 3 valency electrons doped with silicon then it is called tri valen...

Q: c) The single-phase bridge inverter in Figure 2 has a DC input voltage of V,= 24 V and a resistive l...

A: Solve first three sub-parts in a multiple sub-part question, unless the student has asked for specif...

Q: 1. In a typical Zener diode configuration wherein the diode acts as a regulator, what is the value o...

A: Unlike Normal diodes Zener diodes operate in Reverse break down and can come back in normal operatio...

Q: 2. Find the parameter of the two-way network circuit as shown in the figure. j5 S -j5 S all 27 - j15...

A:

Q: find a sinusoid equivalent to -8.63sin 377t - 4.19 cos 377t

A: For simplicity, add them by converting in polar form.

Q: electric units a & b are connected in parallel and its rms current is 15A. If the current in b lags ...

A: The solution is given below 

Q: Two signals of frequency 1 Hz each are applied to the X and Y plates of an oscilloscope. If the time...

A: One period of waveform is corresponding to 360 degrees . Period = 1/frequency. Given phase differenc...

Q: 6. For the ac series-parallel circuit (Fig. 11-32), find the total current, the current through each...

A:

Q: Determine IL (in mA). Rs 220 N IR Vz = 10 V VL 20 V = 400 mW PZ max 470 N.

A: This question belongs to analog electronics . It is based on the working of zener diode . Zener diod...

Q: Complete the operational diagram for each load in the circuit. The timers are set for 5 seconds 1. O...

A: 1. The given figure is shown below:

Q: 12–7. A particle moves along a straight line such that its position is defined by s = (² – 6t + 5) m...

A:

Q: what is the similarities and differences between renewable and nonrenewable sources of energy? Point...

A: The sources of energy that are abundant in nature are the renewable source, while the sources that a...

Q: Two alternating voltages are given by vị = 120 sin wt volts and v2 = 200 sin(wt volts. Obtain the si...

A: This question belongs to basic electrical . It is based on the concept of calculation of expression ...

Q: Op amp and diodes are ideal. Derive Vout and sketch the transfer curve of Vin vs Vout. Please show c...

A: The circuit is given as

Q: Question 1: Explain the structure and the operation principle of one phase motors. Question 2: Why d...

A: It is asked to explain the structure and operation principle of one phase motors. Since no other spe...

Q: The parallel plates have an area of 2000 cmz and are separated at 1.00 cm apart. The original potent...

A: Note:  As per the  guide lines of the bartleby we are supposed to solve 3 questions, when they are i...

Q: Compute all the voltages and cuents in this circuit: YIL Vc 3KR 'I, Is

A:

Q: What value of capacitor is needed to compensate the reactive power of 1.5 kVAr fed by 230V, 50HZ АЗ ...

A:

Q: X1 = Inductive Reactance w = Angular Frequency f = Frequency = Inductance Where :

A: According to above statement need to create question : Question 1: An inductor of inductance 10 mH w...

Q: For the network of Fig. 5.151: a. Determine Z¡ and Z,. b. Find A,. c. Repeat parts (a) and (b) with ...

A:

Q: periodic convolution using DFT and IDFT method.

A: Delta Function-It is also known as the unit impulse function. It's value is equal to zero everywhere...

Q: PSPICE MULTISIM Find the Thévenin equivalent with respect to the terminals a, b for the circuit in F...

A: The solution is given below

Q: Why is it necessary to conduct polarity tests on transformers?

A: Polarity test:  It is a test conducted on primary and secondary winding of a transformer and to know...

Dielectric Breakdown

A dielectric is a material with low electrical conductivity and so is classified as an insulator. Dielectric materials are used to block the flow of electricity through them, allowing them to behave as an insulators. They can also be used to store electric charge or improve capacitance.Dielectrics have no free electrons for conduction because electrons are tightly bound to the nucleus. Because dielectrics contain a small number of electrons for electrical conductivity, they have a dipole. The two primary roles of dielectrics in electrical devices are insulation and electrical energy storage. An electric field polarizes the dielectric, and the polarization of the molecules allows dielectric materials to store charge.