(b). You are given a photodiode D1, a capacitor C₁, a resistor R₁ and an operational amplifier which operates at a supply voltage of 5 V. Draw a clearly labelled circuit diagram showing how you can construct a TIA from the given components for detecting and converting weak optical signals into electrical signals. (c). What component value should it be for one of the electronic components or devices in Q2(b) required for getting the specified signal gain?

(b). You are given a photodiode D1, a capacitor C₁, a resistor R₁ and an operational amplifier which operates at a supply voltage of 5 V. Draw a clearly labelled circuit diagram showing how you can construct a TIA from the given components for detecting and converting weak optical signals into electrical signals. (c). What component value should it be for one of the electronic components or devices in Q2(b) required for getting the specified signal gain?

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

Problem #6: An abrupt p-n junction varactor is used to tune an oscillator shown in Figure 3. At zero bias voltage, the varactor has a junction capacitance of 4pF, Vbi 1.3V for GaAs. The active device has CD = 2pF and RD = 10W. The load bias has L₁ = 15nH and R₁ = 10W. What are the oscillation frequencies at (a) -20V (b) -10V and (c) OV? = L₁ R₁ C₁ (V) -RD FIGURE-3 www CD
Convert the Mealy state diagram to a Moore state diagram.
Find the value of Rf necessary to produce an output that is 10 times the sum of the inputs in the Figure.
(a) Plot the even and odd parts of the signal of Figure
A diode noise generator is required to produce 10uV of noise in a receiver with an input impedance of 75 ohms, resistive, and a noise power bandwidth of200kHz. (These values are typical of FM broadcast receivers.) What must the noise current be through the diode?
Vcc=15V Q1: BC237 Rc 3.6kQ or BC238 B=200 VBE(on)=0.7V R1 110KQ Rs Cci 1000 4.7µF Cco 4.7µF R2 ·27kΩ RE 1.2kQ RL 12kΩ Vs Rin Rout Figure 1. Common-emitter amplifier. 2)
What type of A/D converter would work best for video signals with a frequency content up to 5 MHz? Why? (Our subject is Principles of Electronic Communications)
Sketch carefully the following signal.in dsp material or signal and system
How it is generated Single Sideband Modulator Using Phasing Metho
For positive half of the signal below, what is the peak output value of the circuit? NOTE: use silicon diode ?
Derive the transfer function of dc servometer
1-Ideal Envelop Detector 2-AM demodulation using diode and RLC circuit 3-Demodulation of AM signal using envelop detector Question 8: Can an overmodulated AM signal be recovered with the above demodulators? If possible, explain how.