Use the exact values you enter in previous answer(s) to make later calculation(s).Consider the following figure. (Assume R, = 32.0 0, R, = 21.0 0, andV = 18.0 V.)R10.0 V5.00 NR2(a) Can the circuit shown above be reduced to a single resistor connected to the baNo. This multi-loop circuit does not contain any resistors in series (i e,connected so all the current in one must pass through the other) nor inparallel (connected so the voltage drop across one is always the same asthat across the other). Thus, this circuit cannot be simplified any further,and Kirchhoff's rules must be used to analyze it.(b) Find the magnitude of the current and its direction in each resistor.R3: 21.0 N =X A5.00 QX AR: 32.0 N =X A

According to Kirchhoff's first law Algebraic sum of current at a junction is always zero

Answered: (b) Find the magnitude of the current…

Science

Physics

(b) Find the magnitude of the current and its direction in each resistor. R3: 21.0 N = X A 5.00 N X A R: 32.0 N = X A

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

A 0.7-F capacitor is connected in series with a 9-ohm resistor. If the connection is energized from an 11-V DC source, determine the voltage (in volts) across the resistor at t = 2.75 ms. The initial charge is 175 mC. Express your answers accurate to four decimal places. No need to put the units. Do not put spaces.
I need a labled schematic on paper of the circuit showing + and - terminals of the battery, the direction of any current flowing through the circuit, and any voltage drop across any resistors. I also need the form of the equations dealing with I, R (or 1/R), and V equations filled in with the appropriate numbers and answer with units for this problem. Problem: The same two resistors are connected in parallel to a voltage source. The voltage source (∆Vtot) is a 48-V source and the resistor values are 6.4 Ω (R1) and 3.9 Ω (R2). Determine the equivalent resistance of the circuit. Determine the current in the circuit. Determine the voltage drop across each individual resistor.
a) Use voltage division to determine the voltage v, across the 40 N resistor in the circuit shown. 3.4 b) Use v, from part (a) to determine the cur- rent through the 40 N resistor, and use this current and current division to calculate the current in the 30 N resistor. c) How much power is absorbed by the 50 N resistor? 40 Q 50 Ω + v, 60 V 20 Ωξ 30 Ωξ 10 Ω 70 N Answer: (a) 20 V; (b) 166.67 mA; (c) 347.22 mW. + |
Draw a circuit with a battery and three resistors. R1 and R 2 are in series with eachother and the battery. R3 is in parallel with R2 . Calculate the equivalent resistance of thecircuit if R 1 = 1k, R 2 = 2k, and R 3 = 3k.
Consider the circuit shown below. The terminal voltage of the battery is V = 18 V [note]. www R₁ = 4.00 Ω 3 V = 18.00 V Hint R3 = 4.00 Ω www a. Find the equivalent resistance of the circuit. Req 52. b. Find the current through each resistor. Give your answer as a comma-separated list in unit of ampere. currents through R2, and R3 (in ampere, in order): c. Find the potential drop across each resistor. Give your answer as a comma-separated list in unit of volt, as an absolute value. potential drops across R₁, R₂, and R3 (in volt, in order): d. Find the power dissipated by each resistor. Give your answer as a comma-separated list in unit of watt. power dissipated by R₁, R2, and R3 (in watt, in order): e. Find the total power supplied by the battery. Pbattery = W. Submit Question R₂ = 1.00 2 $ 4 G Search or type URL % 5 6 & 7 * 8 + 9 0
What is the equivalent resistor between the terminals a and b if you replace R1 by 38 Ohm and R2 by 34 Ohm ? This combination of resistors goes to infinity by repeating itself. Write your answer in units of Ohm. No decimal points is necessary. Maximum od 4% of error is accepted in your answer.
A circuit has a 12V battery, and two resistors of 82 and 162. Draw the circuit with the resistors in series, and solve the VIRP table. Repeat #1 with resistors in parallel.
The capacitor in the circuit shown below is initially uncharged. The switch is closed at t = 0 s. AV battery = 24 V, C = 3.0 μF, and R = 2.0 02. What is the current in the circuit at t = 9.0 µs, in Ampere? Your answer needs to have 2 significant figures, including the negative sign in your answer if needed. Do not include the positive sign if the answer is positive. No unit is needed in your answer, it is already given in the question statement.
Consider the circuit shown in the figure below, where and E = 11.0 V. R, = 9.00 Q, R2 = 6.00 Q, 10.0 N R2 5.00 N 2.00 N R + Find the voltage (in V) across R.- (a) Find the equivalent resistance in the circuit by applying the equations for resistances in series and parallel, and use your result and Ohm's law to determine the total current in the circuit. You can use this value to calculate the potential drop across the 2.00-Q resistor, and from this, find the voltage across R1. V Find the current (in A) in r,. (b)
The parallel circuit at the right depicts two resistors connected to a voltage source. The voltage source (AVtot) is a 12-V source and the resistor values are 7.4 Q (R,) and 3.9 Q (R2). a. Determine the equivalent resistance of the circuit. [ Select ] b. Determine the current in each branch resistor: Current in R, = [Select] Current in R, = [Select ] %3D C. Determine the total current in the circuit. Select ]
Physics written by hand. Determine the circuit's behavior for each of the following cases after S is again closed: i) The circuit element connecting alpha to beta is an ideal voltmeter. Also what would the voltmeter measure. ii) The circuit element connecting alpha to beta is an ideal ammeter. Also what does this ammeter measure.
Can you pls help me solve this. 5 resistors are connected as shown in the figure. The voltage on AB is 30V and the total resistance is 2 ohms. The voltage across resistor 1 is 14.25V and the current passing resistor 3 is 6 amperes. Determine the total current of the circuit and all other unknowns (r4 = 6 ohms, r5 = 10 ohms) Solve for: (a) Resistance of R2 (b) current through I4 (c) current through I1 (d) voltage across R4 (e) voltage across R2 (f) voltage across R3 (g) Total current *Pls refer from the photo attached* •Pls answer with complete and detailed solution (3 decimal places all final answers with correct units) •Sketch an illustration/diagram with labels (this is a must; for a better understanding) Thank you I will give your answer a LIKE for helping me... **Pls refer from the photo attached. •Pls answer with complete and detailed solution (3 DECIMAL PLACES all final answers with correct units) •Sketch an illustration/diagram with…