(b) Find the increase in the car's gravitational potential energy when it is raised 1.00 m.(d) Calculate the work done by P in moving the smaller piston. (a) Find the force P that must be applied to a piston of area 10.10 cm2 to produce sufficient fluid pressure to support a car weighing 10,151 N by means of acolumn of fluid of cross sectional area 315 cm² as seen in the figure below.325.47 N(b) Find the increase in the car's gravitational potential energy when it is raised 1.00 m.1051 J(c) How far must the smaller piston move in order for the larger one to move 1.00 m?31.19 m(d) Calculate the work done by P in moving the smaller piston.325.48 NCompare your answer with the answer to part b.

Name: (b) Find the increase in the car's gravitational potential energy when
Uploaded: 2024-03-20T06:57:25.000Z
Channel: Bartleby
Description: (b) Find the increase in the car's gravitational potential energy when it is raised 1.00 m.(d) Calculate the work done by P in moving the smaller piston. (a) Find the force P that must be applied to a piston of area 10.10 cm2 to produce sufficient fl

Answered: Image /qna-images/answer/5e5b81e8-d1be-42e5-888e-295cea648f92.jpg

Answered: (b) Find the increase in the car's…

Science

Physics

(b) Find the increase in the car's gravitational potential energy when it is raised 1.00 m. (d) Calculate the work done by P in moving the smaller piston.

University Physics Volume 1

18th Edition

ISBN:9781938168277

Author:William Moebs, Samuel J. Ling, Jeff Sanny

Publisher:William Moebs, Samuel J. Ling, Jeff Sanny

Chapter14: Fluid Mechanics

Section: Chapter Questions

Problem 131CP: Water supplied to a house by a water main has a pressure of 3.00105N/m2 early on a summer day when...

See similar textbooks

Similar questions

A sump pump (used to drain water from be basement of houses built below the water table) is draining a flooded basement at rate of 0.750 L/S, with an output pressure of 3.00105N/m2 . (a) The water enters a hose with a 3.00-cm inside diameter and rises 2.50 m above the pump. What is its pressure at this point? (b) The hose goes over the foundation wall, losing 0.500 m in height and widens to 4.00 cm in diameter. What is the pressure now? You may neglect frictional losses both parts of the problem.
Verify that work input equals work output for a hydraulic system assuming no losses due to fiction. Do this by showing that distance output force moves is reduced by the same factor output force is increased. Assume the volume of the fluid is constant. What effect would friction within the fluid and between components in the system have output force? How would this depend on whether or not fluid is moving?
Water supplied to a house by a water main has a pressure of 3.00105N/m2 early on a summer day when neighborhood use is low. This pressure produces a flow of 20.0 L/min through a garden hose. Later in the day, pressure at the exit of the water main and entrance to the house drops, and a flow of only 8.00 L/min is obtained through the same hose. (a) What pressure is now being supplied to the house, assuming resistance is constant? (b) By what factor did the flow rate be water main increase in order to cause this decrease in delivered pressure? The pressure at the entrance of the water main is 5.00105N/m2 , and the original rate was 200 L/min. (c) How many more users are there, assuming each would consume 20.0 L/min in be morning?
Verigy that the SI of hpg is N/m2.
(a) How high will water rise in a glass capillary tube with a 0.500-mm radius? (b) How much gravitational potential energy does the water gain? (c) Discuss possible sources of this energy.
A fire hose has an inside diameter of 6.40 cm. Suppose such a hose caries a flow of 40.0 L/s starting at a gauge pressure of 1.62106 N/m2. The hose goes 10.0 m up a ladder to a nozzle having an inside diameter of 3.00 cm. Calculate the Reynolds numbers for flow in the fire hose and nozzle to show that flow in each must be turbulent.
Considering the magnitude of typical arterial blood pressures, why are mercury rather than water manometers used for these measurements?
Suppose water is raised by capillary action to a height of 5.00 cm in a glass tube. (a) To what height will it be raised in a paraffin tube of the same radius? (b) In a silver tube of the same radius?
(a) Verify that a 19.0% decrease in laminar flow through a tube is caused by a 5.00% decrease in radius, assuming that all other factors remain constant. (b) What increase in flow is obtained from a 5.00% increase in radius, again assuming all other factors remain constant?
What effect does capillary action have on the reading of a manometer with uniform diameter? Explain your answer.
A host pours the remnants of several of wine into a jug a party. The host then inserts a cork with a 2.00-cm diameter into the bottle, placing it in direct contact with the wine. The host is amazed when the host pounds the cork into place and the bottom of the jug (with a 14.0-cm diameter) breaks away. Calculate the extra force exerted against the bottom if he pounded the cork with a 120-N force.
A garden hose with a diameter of 2.0 cm is used to fill a bucket, which has a volume of 0.10 cubic meters. It takes 1.2 minutes to fill. An adjustable nozzle is attached to the hose to decrease the diameter of the opening, which increases the speed of the water. The hose is held level to the ground at a height of 1.0 meters and the diameter is decreased until a flower bed 3.0 meters away is reached. (a) What is the volume flow rate of the through the nozzle when the diameter 2.0 cm? (b) What does is the speed of coming out of the hose? (c) What does the speed of the water coming out of the hose need to be to reach the flower bed 3.0 meters away? (d) What is be diameter of nozzle needed to reach be flower bed?