B 2. A certain AC bridge is in balance, with the following constants: arm AB: R=4502, arm BC: a resistance of 3002 in Zi series with a capacitance of 0.265µF, arm CD: an unknown G C impedance and arm DA: a resistor of 2002 in series with an inductance of 15.9mH. The supply frequency is 1kHz. Find 13 Z4 the constants of arm CD. (Answer: Za has a resistor of 2672 in series with a capacitor D of 0.795µF)

B 2. A certain AC bridge is in balance, with the following constants: arm AB: R=4502, arm BC: a resistance of 3002 in Zi series with a capacitance of 0.265µF, arm CD: an unknown G C impedance and arm DA: a resistor of 2002 in series with an inductance of 15.9mH. The supply frequency is 1kHz. Find 13 Z4 the constants of arm CD. (Answer: Za has a resistor of 2672 in series with a capacitor D of 0.795µF)

Glencoe Physics: Principles and Problems, Student Edition

1st Edition

ISBN:9780078807213

Author:Paul W. Zitzewitz

Publisher:Paul W. Zitzewitz

Chapter25: Electromagnetic Induction

Section: Chapter Questions

Problem 6STP

See similar textbooks

Similar questions

The mains ac supply in some countries is 110 V r.m.s at 50 Hz (sinusoidal). How much time will take one cycle of this ac supply? Select one: О а. 50s O b. 0.00318 Oc. 314 s O d. 0.02s
Determine the current in a simple series RL circuit having a resistance of 10 ohms, an inductance of 1.5 H, and an emf of 9 V if initially the current is 6 A. Ans.: I = 9/10 + (51e – 20t/3)/10 amp.
A series LRC ac circuit has a resistance of 4.0 kilo-Ohms, a capacitance of 33.0 mocroFarads, and an inductance of 23.0 H. If the frequency of the alternating current is 2.0/pi kHz, what is the phase angle between the voltage and the current?
9. A constant inductance of 1 henry and a variable resistance R are connected in series with a constant emf of E volts. If R equals fraction numerator 1 over denominator 1 plus t end fraction space space space ohms at time t seconds and if the current is initially zero, what value of E will make the current 37 amperes after 10 seconds? (Round answers to 2 decimal places, no units needed)
An RL circuit has an emf of 20 volts, a resistance of 20 ohms, an inductance of 5 H with an initial current of 4 mA. What is the current after 0.05 seconds?
2. A 0.7-H inductor is connected in series with a 9-ohm resistor. If the connection is energized from an 11-V DC source, determine the voltage (in volts) across the resistor at t = 2.75 ms. The initial current is 175 mA. Express your accurate answer to four decimal places.
5. Find v₁ across the inductor below. lotěst A V₂ m 0.14 + 6. Find the voltage across a 5 µF capacitor if the current through it is i(t) = 3e 2000t mA Assume that the initial capacitor voltage is zero.
> Combine PDF 4. The steady-state current I flowing in a circuit that contains a resistance R 5, capacitance.C= > Send Files = 10, and inductance L = 4 in series is given by: > Store Files E I =- 1 R +(27L 2 oC Where E = 2 and o = 2 are the input voltage and angular frequency respectively. Compute the value of I.
See the attached picture of an RLC series circuit. Power supply voltage is given as v(t) = 30Vsin(450t) and R = 200 ohms, L = 450 mH, C = 5 µF 1. What is the current (mA) read by an ammeter place in the circuit? 2. What is the maximum voltage (V) that occurs across the inductor? 3. What is the Average Power (W) delivered by the voltage source? Thank you.
A resistance of 5 ohms is connected in series with a capacitor of 442.1uF. The combination is then connected in parallel with an inductance of 21.22mH. Solve for the resultant current if the circuit is connected across a 120 V, 60Hz AC source.
A 5.1 mH inductor is connected to a 3.5 V, 818.3 Hz source. What is the inductive reactance (in ohms)?
1. A 1000 resistor is connected to a 220v, 50HZ ac supply. a) What is the rms value of current in the circuit?