Please help, thank you! 2. Consider again the circuit from problem 1, butsuppose now that the switch is closed.c) What is the voltage drop across the inductoras a function of time?a) What is the new impedance of this circuit?d) How much time does it take for the inductor togo from having no current flowing thorough itto having the maximum amound of currentflowing through it?b) What is the new current flowing out of thevoltage source? 1. Consider the series LRC circuit shown below,with L = 100 mH, C = 1000 µF, and R = 50 2.The AC source produces a voltage V(t) = Vosin(wt), with Vo = 200 V and w = 90 hertz. Aswitch is placed across the capacitor, but leftopen for this problem.RVsinorLC

The solution can be given as follows :-

Answered: at is the new impedance of this…

Science

Physics

at is the new impedance of this circuit? at is the new current flowing out of the age source? d) How go fre to ha flowi

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter14: Inductance

Section: Chapter Questions

Problem 14.8CYU: Check Your Understanding (a) If the current in the circuit of in Figure 14.12(b) increases to 909 of...

See similar textbooks

Related questions

Q: A circuit is constructed with a DC battery of 15 volts a resistance of 16 Ohms and 1900 micro…

Q: Write your understanding on resonance condition for an RLC circuit. What are the reactance's for a…

A: In RLC circuit, Resonance is the condition where the value of inductive reactance is equal to the…

Q: late the theoretical output DC voltage of the half-wave rectifier circuit an are it with measured…

Q: Truth table of OR gate is given bellow Input Output A В A+B 1 1 1 1. 1 1. к-Мар Draw the K-Map for…

Q: Determine, Z, of the circuit. Determine the rms current in the circuit. What is the voltage drop…

Q: What is the impedance of this circuit?

Q: Explain the phasor diagram uses in the AC circuit?

Q: Fill in the blank with correct answers: A B Frequency Series Resonance -Impedance vs. Frequency. The…

A: Impedance of an ac circuit is given by, Z = ( R2 + ( XL - XC ) 2 ) 1/2 R is resistance XL is…

Q: Please continue and explain all symbols. In general, the rms current in an series RLC circuit can be…

A: Given: R.M.S current in RLC circuit.

Q: For the parallel circuits (a ) and (b ) find a series circuit that will have the same total…

Q: Q4A/ For figure (1)draw and calculate the voltages waveform across each half of secondary winding…

Q: For the next two items (LC1 and LC2), consider the circuit shown. The switch is initially at state…

A: The voltage drop in the inductor is given as v=-Ldidt The voltage drop in the capacitor is given by…

Q: A series circuit has a capacitor of - Farad, a resistor of 3 Ohms and an inductor of 1 Henry. If the…

A: we have following data as given in question Resistance of resistor R = 3 ohm Capacitance of…

Q: HO09 1.75x 10°F

Q: What icon in Multisim should be clicked to see both the circuit and the waveform produced by the…

A: The answer is given below

Q: If the response is overdamped, calculate s1 and s2 using the equationsin Table 8.3;

A: Note the formulas given in the table as follows: α=12RCω0=1LCs1=-α+α2-ω02s2=-α-α2-ω02 Here, α…

Q: Calculate the conversational voltage and current Voltage and current of the capacitive and draw a…

Q: A simple difference amplifier circuit is shown in Figure 4.1. Why would replacing the common…

A: Normally difference amplifiers are meant to reject common-mode signals, especially when they are…

Q: One leg of a radio-tuned circuit has a capacitance of 1x10^-9 farad. It is tuned at 200 kHz. What is…

Q: he circuit below shows a simple RL circuit. Initially, the switch is in position 1. L ll AV 1 Vhich…

A: RL circuit is a type of complex circuit in which a resistor is connected with an inductor.

Q: Fill in the blank with correct answers: A B Frequency Series Resonance -Impedance vs. Frequency. The…

A: Impedance (symbol Z) is a measure of the overall opposition of a circuit to current, in other words:…

Q: İR, AUR What is Alternating Current? a Imax-- IR AVmax AUR Please continue and explain all symbols.…

A: Given : To explain Alternating current.

Q: In a series RLC circuit, at resonance, voltage leads the current. Select one: O True False

A: Answer-False

Q: RLC circuit with AC power supply, find reactance for C

A: Vc = IXc that is the voltage across capacitor C and it lags the current I by an angle of 90…

Q: For the circuit in Problem 5, calculate the final current flowing through the inductor if the…

A: in this question first of all we find Requivalent and then we find IL by current division.

Q: If the phase difference between voltage and current is -47', then the circuit will be series RL…

A: This statement is False This will be RC circuit because our phase angle is negative (-47⁰) that is…

Q: I am doing a lab about Analysis of AC circuits and am not sure about this activiy. How do we…

A: In a pure ohmic resistor the voltage waveforms are “in-phase” with the current. In a pure inductance…

Q: Fill in the Blank: If the two wires are running in parallel then the impedance to ground from each…

A: Impedance for two wires running parallel is given by Zo = 138/√k log(D/d)

Q: Write the function of (i) Transducer and (ii) Repeater in the context of communication system.

A: i. The transducer is an electronic device that is capable of transforming one form of energy into…

Q: The graph of impedance against frequency for an RLC series resonance circuit is shown in the…

A: At resonance impendence is minimum.

Q: How can we improve the quality factor of a tuning circuit?

Q: vo input terminals of an op-amp are connected to voltage signals of strength 754u and 740µV…

A: The voltage gain of the op-amp is given by : Here Vin is input voltage and Vout is output…

Q: Explain the AC operation of electrodynamic instrument in detail.

A: An electrodynamic type instrument comprises of Two Fixed Coil, a Moving Coil, Control Spring,…

Q: 1. Derive the expression for the frequency of a LC circuit.

A: For the expression for the reonant frequency of LC circuit. which is also known as resonant…

Q: irections: Write TRUE if the statement is correct and FALSE if the statement is wrong. 1 Poth ACa6 D…

A: Electric current flows in two ways as an alternating current (AC) or direct current (DC). In…

Q: Explain RLC circuit?

A: To be very basic, an RLC circuit primarily consists of 3 components that are, a resistor, an…

Question

Please help, thank you!

2. Consider again the circuit from problem 1, but
suppose now that the switch is closed.
c) What is the voltage drop across the inductor
as a function of time?
a) What is the new impedance of this circuit?
d) How much time does it take for the inductor to
go from having no current flowing thorough it
to having the maximum amound of current
flowing through it?
b) What is the new current flowing out of the
voltage source?

1. Consider the series LRC circuit shown below,
with L = 100 mH, C = 1000 µF, and R = 50 2.
The AC source produces a voltage V(t) = Vo
sin(wt), with Vo = 200 V and w = 90 hertz. A
switch is placed across the capacitor, but left
open for this problem.
R
Vsinor
L
C

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

Check Your Understanding A transformer steps the line voltage down from 110 to 9.0 V so that a current of 0.50 A can be delivered to a doorbell (a) What is the ratio of the number of turns in the primary and secondary windings? (b) What is the current in the primary winding? (c) What is the resistance seen by the 110-V source?
Check Your Understanding In an RLC circuit, L = 5.0 mH, C=60F , and R=200 . (a) Is the circuit under damped, critically damped, or overdamped? (b) If the circuit starts oscillating with a charge of 3.0103C on the capacitor, how much energy has been dissipated in the resistor by the time the oscillations cease?
A step-up transformer is designed so that the output of its secondary winding is 2000 V(rms) when the primary winding is connected to a 110-V (rms) line voltage, (a) If there are 100 turns in the primary winding, how many turns are there in the secondary winding? (b) If a resistor connected across the secondary winding draws an rms current of 0.75 A. what is the current in die primary winding?
What is the self-inductance of an LC circuit that oscillates at 60 Hz 1ien the capacitance is 10 F ?
In an oscillating LC circuit the maximum charge on the capacitor is 2.0 × 10-6 C and the maximum current through the inductor is 8.0 mA. (a) What is the period of the oscillations? (b) How much time elapses between an instant when the capacitor is uncharged and the next instant when it is fully charged?
In an LC circuit, what determines the frequency and the amplitude of the energy oscillations in either the inductor or capacitor?
At s1iat frequency is the reactance of a 20F capacitor equal to that of a 10-mH inductor?
Check Your Understanding (a) If the current in the circuit of in Figure 14.12(b) increases to 909 of its final value after 5.0 s, what is the inductive time constant? (b) If R=20 , what is the value of the self-inductance? (c) If the 20 resistor is replaced with a 100 resister, what is the time taken for the current to reach 90% of its final value?
A 2.0-F capacitor is charged to a potential difference of 12.0 V and then connected across a 0.40-mH inductor. What is the current in the circuit when the potential difference across the capacitor is 6.0 V?
A transformer is used to supply a 12-V model train with power from a 110-V wall plug. The train operates at 50 W of power, (a) What is the rms current in the secondary coil of the transformer? (b) What is me rms current in the primary coil? (c) What is the ratio of the number of primary to secondary turns? (d) What is the resistance of the tram? (e) What is the resistance seen by the 110-V source?
Check Your Understanding The angular frequency of the oscillations in an LC circuit is 2.0103rad/s . (a) If L = 0.10H, what is C? (b) Suppose that at t = 0, all the is stored in the inductor. What is the value of ? (c) A second identical capacitor is connected in parallel with the original capacitor. What is the angular frequency of this circuit?
At what time is the voltage across the inductor of the RL circuit of Figure 14.12(b) a maximum?