An iron ball with mass 180g is attached to a chain that is 1.2m long, suspended at an angle of 55 degrees . The iron ball is then released from this position and at the very bottom of its swing, it strikes a 450g wood block that is resting on a frictionless surface. To what angle does the iron ball rebound?

An iron ball with mass 180g is attached to a chain that is 1.2m long, suspended at an angle of 55 degrees . The iron ball is then released from this position and at the very bottom of its swing, it strikes a 450g wood block that is resting on a frictionless surface. To what angle does the iron ball rebound?

Physics for Scientists and Engineers: Foundations and Connections

1st Edition

ISBN:9781133939146

Author:Katz, Debora M.

Publisher:Katz, Debora M.

Chapter8: Conservation Of Energy

Section: Chapter Questions

Problem 77PQ: A block of mass m1 = 4.00 kg initially at rest on top of a frictionless, horizontal table is...

See similar textbooks

Similar questions

A block of mass m1 = 4.00 kg initially at rest on top of a frictionless, horizontal table is attached by a lightweight string to a second block of mass m2 = 3.00 kg hanging vertically from the edge of the table and a distance h = 0.450 m above the floor (Fig. P8.77). If the edge of the table is assumed to be frictionless, what is the speed with which the first block leaves the edge of the table?
You hold a slingshot at arms length, pull the light elastic band back to your chin, and release it to launch a pebble horizontally with speed 200 cm/s. With the same procedure, you fire a bean with speed 600 cm/s. What is the ratio of the mass of the bean to the mass of the pebble? (a) 19 (b) 13 (c) 1 (d) 3 (e) 9
A 1.00-kg object slides to the right on a surface having a coefficient of kinetic friction 0.250 (Fig. P8.62a). The object has a speed of vi = 3.00 m/s when it makes contact with a light spring (Fig. P8.62b) that has a force constant of 50.0 N/m. The object comes to rest after the spring has been compressed a distance d (Fig. P8.62c). The object is then forced toward the left by the spring (Fig. P8.62d) and continues to move in that direction beyond the spring's unstretched position. Finally, the object comes to rest a distance D to the left of the unstretched spring (Fig. P8.62e). Find (a) the distance of compression d, (b) the speed vat the unstretched posi-tion when the object is moving to the left (Fig. P8.624), and (c) the distance D where the abject comes to rest. Figure P8.62
Two gliders are set in motion on a horizontal air track. A spring of force constant k is attached to the back end of the second glider. As shown in Figure P8.48, the first glider, of mass m1, moves to the right with speed v1, and the second glider, of mass m2, moves more slowly to the right with speed v2. When m1 collides with the spring attached to m2, the spring compresses by a distance xmax, and the gliders then move apart again. In terms of v1, v2, m1, m2, and k, find (a) the speed rat maximum compression, (b) the maximum compression xmax, and (c) the velocity of each glider after m1 has lost contact with the spring.
The coefficient of friction between the block of mass ml = 3.00 kg and the surface in Figure P7.22 is k = 0.400. The system starts from rest. What is the speed of the ball of mass, m2 = 5.00 kg when it has fallen a distance h = 1.50 m? Figure P7.22
This is for advance physics..need the solution asap A 200 g steel ball hangs on a 1.0-m-long string. The ball is pulled sideways so that the string is at an angle of ? = 45° and then released. At the very bottom of its swing the ball strikes a 500 g steel paperweight that is resting on a frictionless table. To what angle does the ball rebound?
The massless spring of a spring gun has a force constant k = 12 N/cm. When the gun is aimed vertically, a 15-g projectile is shot to a height of 5.0 m above the end of the expanded spring. (See below.) How much was the spring compressed initially? www T Ki 2. W N N N N N N N - IN N N N N N N N 5.0 m
例題: A 15-g bullet is shot vertically into an 2-kg block. The block lifts upward 8.0 mm (see the figure). The bullet penetrates the block and comes to rest in it in a time interval of 0.0010 s. Assume the force on the bullet is constant during penetration and that air resistance is negligible. What is the initial kinetic energy of the bullet ? V.
A 5.08×104 kgkg railroad car moves on frictionless horizontal rails until it hits a horizontal spring stopper with a force constant of 4.09×105 N/mN/m . When the railroad car comes to a complete stop, the compression of the spring stopper is 30 cmcm . How fast was the railroad car initially?
A 25 kg block is held against a compressed spring and then the spring is allowed to decompress giving the block a velocity. The block then slides to the right on a horizontal frictionless surface and then up a frictionless incline.
1. Two air carts of mass m1 = 0.84kg and m2 = 0.42kg are placed on a frictionless track. Cart 1 is at rest initially, and has a spring bumper with a force constant of 690 N/m. Cart 2 has a flat metal surface for a bumper, and moves toward the bumper of the stationary cart with an initial speed v = 0.68 m/s. (a)What is the speed of the two carts at the moment when their speeds are equal? (b) How much energy is stored in the spring bumper when the carts have the same speed? (c) What is the final speed of the carts after the collision?Explain and lable the drawing.
A 17 g bullet is shot vertically into an 2.00 kg block. The block lifts upward 8.0 mm (see the figure). The bullet penetrates the block and comes to rest in it in a time interval of 0.0016 s. Assume the force on the bullet is constant during penetration and that air resistance is negligible. The initial kinetic energy of the bullet is closest to