Air flows steadily at a pressure of 105 kPa at a speed of 0.1m / s and a temperature of 300K in a duct with a diameter of 10 cm. After a deformation in the duct, the flow is uniformly out of the gap with dimensions of 3cm × 6cm out of the possible state. Act like a complete gas, you can make R = 287J / kg.k Assuming an incompressible flow, calculate the velocity of air out of the gap

Q: A water jet with velocity V jet impinges normal to a moving flat plate with velocity V plate Such…

A:

Q: Consider the incompressible flow of water through a divergent duct. The inlet velocity and area are…

A: Inlet velocity = 5 ft/s Inlet area = 10 ft2

Q: A fan running at 1480 rpm takes in 6 m^3/min of air at inlet conditions of P_1=950 mbar and T_1=15^0…

A: Given, Speed,  N=1480 rpm Volume rate, Q=6m3/min Inlet pressure, P1=950 m bar Inlet Temperature,…

Q: The water in a divergent duct has an incompressible flow. If the inlet velocity and area are 10 ft/s…

A:

Q: A jet of water with velocity 35 m/s strikes a series of radial curved vane mounted on a wheel which…

A:

Q: A jet of water of 75 mm diameter moving with a velocity of 15 m/s impinges on a fixed plate. Find…

A: Given, Diameter of water jet = d = 75 mm = 0.075 m Velocity of jet = v = 15 m/s Angle between the…

Q: A jet of water of diameter 7.5 cm strikes a curved plate at its centre with a velocity of 20 m/sec.…

A:

Q: The impeller of a centrifugal blower has a radius of 15 cm and a blade width of 6.1 cm at the…

A: Given: Inlet radius is r1=0.15 m. Inlet blade width is b1=0.061 m. Outlet radius is r2=0.3 m. Outlet…

Q: 3. Water flows radially outward through a space between 2 disks of diameter D= 200 mm at a mass flow…

A: Data given- Flow - radially outward Diameter D= 200 mm so r2 = 0.1 m Mass flow rate = 365 g/s =…

Q: A tank with openings 1, 2, and 3 is moving to left at a speed of 25 km/h. Knowing that D1 = D2 = 20…

A: Consider the diagram shown below with the velocities of flow. The velocity of the tank is The…

Q: The flow just upstream of a normal shock wave is given byp1 = 1800 lb/ft2, T1 = 480 ◦R, and M1 =…

A: Given data: *The pressure of the upstream flow is p1 = 1800 lb/ft2. *The temperature of the upstream…

Q: Two pipes, one of internal diameter (I.D.) 0.5 m and the other of I.D. 1 m, are connected as shown…

A:

Q: The cylindrical tank in the given image is being filled with water at 20°C by a pump developing an…

A: Given, The temperature of air, T = 20°C The exit pressure of pump, P2 = 180 kPa The air pressure, P1…

Q: A 5-cm-diameter horizontal jet of water with a velocity of 30 m/s relative to the ground strikes a…

A: Given data: The diameter of water is given as d = 5 cm = 0.05 m. The velocity of water jet is vj =…

Q: A 5-cm-diameter horizontal jet of water, with velocity 30 m/s, strikes the tip of a horizontal cone,…

A: Write the given information. Write the expression of the area of the jet.

Q: A mercury manometer is attached to a nozzle through which water flows with an inlet velocity of 2…

A: Given Data:- Inlet Velocity=2m/s Angle = 30degreeC Distance=40cm Diameter of nozzle = 40cm Exit…

Q: Water @ 30C and 1atm is flows at a rate of 0.5 m^3/s through a horizontal junction in a pipe. The…

A: To find: The resultant force on the junction. Given: The flow rate is Q=0.5 m3sec. The internal…

Q: A jet of water discharges into an open tank, and water leaves the tank through an orifice in the…

A:

Q: Fluid of constant density is flowing at a velocity of 0.5 meter per second into a horizontal nozzle…

A: Given Data d2=13d1V1=0.5 m/sTo findV2=?

Q: Consider the following figure showing a jet of water supporting a weight of 100 N at a height of 5 m…

A:

Q: A closed-form expression for the mass flow through a choked nozzle is poA* |Y 2 (y+1)/(y-1) T V R \y…

A:

Q: left ventricle into the aorta can be modeled as a reducing nozzle (Figur below). Model both the left…

A: Given data as per questionFor Left ventricle, Loaction 1d1=3.1 cm=0.031 mv1=120 cm/s=1.2 m/sP1=130…

Q: Here, air (105 kPa) at 37 degrees celcius is flowing upward in a 6cm diamater inclined duct, at a…

A:

Q: A 250-mm diameter jet of water discharging at the rate of 491 liters per second impinges normally on…

A: GivenDischarge Q=491L/s=0.491m3/sd=250mm=0.250mvelocity of plate u=4m/s

Q: A 5-cm-diameter horizontal jet of water, with velocity 30 m/s, strikes the tip of a horizontal cone,…

A: Given data: The diameter of jet, d = 5 cm. The velocity, v = 30 m/s. The deflected angle, Ɵ = 60o.…

Q: If a jet is inclined upward 30O from the horizontal, what must be its velocity to reach over a 3-m…

A: Consider the diagram as shown below for the given system.

Q: Q3/B/ A non-Newtonian fluid that can be described by a power law model for which n is 0.2 and k is 5…

A: n = 0.2 k = 5 (kpa s)^n length = 10 m Diameter = 20 mm Answer : Radius of required pipe is 15 mm

Q: atm FR Out A water jet with a uniform velocity profile, whose average speed is increased to 8 m/s…

A: Given data  Average speed increased = 8m/s  Outlet diameter = 10cm  To calculate  Force = ??

Q: A fluid moves in a steady flow manner between two sections in a flow line. At the entrance section:…

A:

Q: A pump is 2.2 m above the water level in the sump and has a pressure of –20 cm of mercury at the…

A: Bernoulli's equation in terms of head is used to get the velocity at pump. Using continuity ,…

Q: A 7 cm diameter jet having a velocity of 30 m/s strikes a flat plate which is inclined at 45 the…

A: We know that a 30 m/s jet collides with a flat plate that is inclined at 45o to the jet's axis. If…

Q: What is the volume (h x A) of this reservoir (m) if h is the height of reservoir (m) and its cross…

A: Bernoulli's equation.

Q: Air flows steadily between two sections in a long straight portion of 0.2 m inside diameter pipe as…

A:

Q: The test section of a low speed wind tunnel is a square duct with cross section of 7 cm × 7 cm. The…

A: In fluid mechanics, continuity equation represents the flow rate of the fluid flowing through a…

Q: from an ariface at bottom at a rate 0.003 m^3/s. what is rate of change of mass of water in the…

A:

Q: 5.102 A sphere is moving in water at a depth where the absolute pressure is 18 psia. The maximum…

A: Given Data The absolute pressure is: P= 18 psia The density of the water is: ρ=62.4 lb/in2 The…

Q: A jet of water with velocity 35 m/s strikes a series of radial curved vane mounted on a wheel which…

A: Given Vw=35 m/sN= 200 rpmθ=30oVj=5 m/sϕ=140Ri=35 cm = 0.35mRo=70 cm=0.7m To find Vane angles inlet…

Q: A fluid with a density of 0.8 g/cm3 is being emptied from a very large tank through a small…

A:

Q: calculate the outlet velocity (V2) of water by using continuity and Bernoulli’s equation.

A: Given: Density (ρ) =750 kg/m3 Inlet conditions: d1= 8 cm =0.08 mP1= 400 kPaOutlet condition: d2=4 cm…

Q: A water jet with velocity V jet impinges normal to a moving flat plate with velocity V plate such…

A: Given : The jet cross section area = 2 cm2 The velocity of jet = 20 m/s The velocity of plate = 10…

Q: at a point upstream of the throat in a converging-diverging nozzle the velocity temperature and…

A:

Q: (b) Water enters a two-armed lawn sprinkler along the vertical axis at a rate of 50 L/s, and leaves…

A:

Q: For the experimental setup of a jet striking on a hemispherical cup surface as shown in the figure,…

A: Given data: The diameter of the pipe is D = 145 cm = 1.45 mThe area of the jet will be given…

Q: A 7.6 cm jet of water strikes a vertical plate in its centrod. Find the velocity of water through…

A:

Q: A pump is 2.2 m above the water level in the sump and has a pressure of –20 cm of mercury at the…

A:

Q: The open jet of water at 20°C exits a nozzle into sea-level air and strikes a stagnation tube as…

A:

Q: Calculate the density of air entering the nozzle, if the air leaves a nozzle at a P=1.5atm and…

A:

Q: A partly full water tank admits water at 85 N/s weight flow while ejecting water on the other side…

A:

Q: A water intake at a pump storage reservoir (the figure) has a cross-sectional area of 0.722 m2. The…

A: