After 1000 mL of solution is given to a patient via an IV, then 20 mL per minute was given. This follows a function represented as M = 1000 + 20t. %3D Which answer best identifies the independent variable and the dependent variable O Independent variable M, for total milliliters, dependent variable t, for time in minutes. O Independent variable t, for total milliliters, dependent variable M, for time in minutes. O Independent variable M, for time in minutes, dependent variable t, for total milliters. O Independent variable t, for time in minutes, dependent variable M, for total milliters.

After 1000 mL of solution is given to a patient via an IV, then 20 mL per minute was given. This follows a function represented as M = 1000 + 20t. %3D Which answer best identifies the independent variable and the dependent variable O Independent variable M, for total milliliters, dependent variable t, for time in minutes. O Independent variable t, for total milliliters, dependent variable M, for time in minutes. O Independent variable M, for time in minutes, dependent variable t, for total milliters. O Independent variable t, for time in minutes, dependent variable M, for total milliters.

Curren'S Math For Meds: Dosages & Sol

11th Edition

ISBN:9781305143531

Author:CURREN

Publisher:CURREN

Chapter9: Parenteral Medication Labels And Dosage Calculation

Section: Chapter Questions

Problem 2.5P

See similar textbooks

Similar questions

The simple form of |Hoff equation is: II = [B]RT In this equation the [B] is the molar concentration of solute. So: n m [B] = v MV = cg /MA Where c, the mass concentration of the solute is in the total volume of solution and M, is the molar mass of the solute. This equation can be replaced in the previous one to get: RT II = MA In this equation molar mass of given solute can be detemined from the slope of the II vs Cz plot. This equation applies only to solutions that are sufficiently dilute to behave as ideal-dilute solutions. In the case of non-ideal solutions, however, the extended formula is: II = [B]RT{1+ k. [B] + n. [B]² + ...} Biological macromolecules dissolve to produce solutions that are far from ideal, but we can still calculate the osmotic pressure by assuming that the van't Hoff equation is only the first term of a lengthier expression: II [B]RT(1+ b. [B]) II = RT + bRT. [B] [B] II = RT + bRT./M. */Ma п RT ÞRT Ca MA MA In this equation molar mass of given biomolecule can…
After three minutes, the concentration of drug Zip in the red blood cells is 10 mmoles l-1. What is the average rate of entry of drug Zip into the red blood cells in units of moles min-1 red blood cell-1 during the first three minutes after placing the red blood cells into the bathing solution? Assume that each red blood cell occupies about 1 x 10-13 liters.
Calculate the effective quantity (g) of sodium chloride related to tonicity in 100ml of an intravenous fluid labeled "5% dextrose in 0.45% sodium chloride," and indicate whether the solution is isotonic, hypotonic or hypertonic. The answer is Hypertonic and 1.35g NaCl but I don't understand how to get the answer.
Determine the amount of glucose in the unknown sample by plotting a standard curve of Absorbance at 620 nm on Y-axis and μg of glucose on the x-axis.
A glucose solution is supplied in a repeated fed batch culture. The following parameters have been measured at t=2.5 hours; the system was under a quasi-steady state at this time. V = 1.0L, F = 0.22L/hr, S_0 = 98g/L, mu_m = 0.31/hr, K_s = 0.14 g-glucose/L, YM_X/S = 0.48 g-cells/g-glucose, Xt_0 = 33g (1) Calculate the value of V0 and S. (2) Calculate the value of Xt for t = 2.5hrs.
The standard curve to determine the amount of betacyanin is shown below. You extracted a red pigment from a beet disc (the mass of a disc is 2 g) using 10 ml of 20% ethanol solution. You measured absorbance of the solution above the beet disc every minute for a total time of 20 minutes. The increase in absorbance was linear during a period of time from 1 min to 10 min. The absorbance at 10 min was 0.8. Calculate the amount of betacyanin extracted from 1g of a beet tissue per minute. Explain your calculations. You can use Excel or a calculator.
What is the charge of an ionized peptide in the mass spectrometer if its isotopic peaks are 0.20 m/z apart? 6+ 5+ O 4+ 3+ QUESTION 34 In the Lineweaver Burke plot shown below, which of the following is true? wwhout intr O Km is increasing, Vmax is decreasing O Km is decreasing, Vmax is decreasing O Km is increasing, Vmax is increasing O Km is decreasing, Vmax is increasing QUESTION 35 789 Mistly cloudy and Submit to save and subit Click Save All Anners ta sae al anners
4 mL of 10% TCA solution was added to 1 mL of serum and after mixing, it was waited for two minutes and filtered through non-phosphorus filter paper. 1 mL of the filtrate was taken and 13 mL of distilled water, 4 mL of sulfomolybdic acid and 2 mL of dilute SnCl2 solution were added and mixed, and after waiting for 15 minutes, the absorbances of the obtained solutions against pure water at 520 nm were read. If the function of the calibration graph obtained with 0.5-2.5 mg/mL standard phosphorus solutions is y= 0.245x + 0.107 and the absorbance value of the serum sample is 0.109, what is the amount of phosphorus in the sample?
In the experiment performed for the determination of cholesterol, the function of the calibration curve obtained using 25-400mg/dL standard cholesterol solutions was determined as y= 0.0009x. If the absorbance of the serum sample is determined as 0.28, what is the amount of cholesterol in the sample, in mg/L?
After blood collection, the red cells are separated from the serum to be used for the preparation of the stock solution. How is it done? For the serial dilution, your stock solution must have a concentration of 3.5 mg/mL. How much diluent must be added to the 5.3 mg/mL red cell to prepare the stock solution? Show pertinent solution/s. What is the appropriate diluent used for the preparation of the red cell suspension?
The reults for the macroscopic part: 0.30M glycerin – solution was translucent (could see text behind the test tube) 0.15M NaCl – solution was opaque (could not see text behind the test tube) 0.30M NaCl – solution was opaque (could not see text behind the test tube) 0.15M glucose – solution was translucent (could see text behind the test tube) 0.30M glucose – solution was opaque (could not see text behind the test tube) 0.30M Urea – solution was translucent (could see text behind the test tube) Results for microscopic part: 0.30M glycerin – no cells present 0.15M NaCl – normal sized cells 0.30M NaCl – crenated (shrunken and star-shaped) cells 0.15M glucose – no cells present 0.30M glucose – normal sized cells 0.30M Urea – no cells present Determine the osmolarity (hypoosmotic, isosmotic, or hyperosmotic) and tonicity (hypotonic, isotonic, hypertonic) of the following solutions.In which solutions did the osmolarity NOT match the tonicity? For those solutions, why did the osmolarity…
You have an order for 1 gram of Cefazolin in D5W 100 ml. You have added 5 ml of sterile water to the 1 gram vial to reconstitute powder. However the recommended manufacturer’s diluent amount is 10 ml of sterile water for a final concentration of 100 mg/ml. How would reconstituting the vial with 5 mls affect the concentration and the final calculated dose. Please answer with explanation ASAP. I will really upvote. Thanks