A.The University of Zotto wants to upgrade its network so that the dean of the university can deliver important information related to students and teachers directly to the campus monitors located in the vicinity. The university has hired a firm named Internet Solutions for this purpose. The firm has come up with a solution where it will use a central receiver to distribute video signals to multiple monitors within a building. However, the firm is still not sure about the kind of cables it will be using as the allocated budget is not extensive. Analyze which of the following should be ideal in such a scenario. 1.RG-59 cables 2.Category 3 cables 3.RG-6 cables 4.Fiber-optic cables

A.The University of Zotto wants to upgrade its network so that the dean of the university can deliver important information related to students and teachers directly to the campus monitors located in the vicinity. The university has hired a firm named Internet Solutions for this purpose. The firm has come up with a solution where it will use a central receiver to distribute video signals to multiple monitors within a building. However, the firm is still not sure about the kind of cables it will be using as the allocated budget is not extensive. Analyze which of the following should be ideal in such a scenario. 1.RG-59 cables 2.Category 3 cables 3.RG-6 cables 4.Fiber-optic cables

Operations Research : Applications and Algorithms

4th Edition

ISBN:9780534380588

Author:Wayne L. Winston

Publisher:Wayne L. Winston

Chapter20: Queuing Theory

Section20.10: Exponential Queues In Series And Open Queuing Networks

Problem 8P

See similar textbooks

Similar questions

Consider building a CSMA/CD network running at 10Mbps over a cable with no repeaters. If the signal speed in the cable is 106 km/sec and minimum frame size is 1500 bytes, then what is the cable length (km)?
Assume you are working as a Network Engineer for a Telecommunications service provider and your task is to estimate the feasibility of a 20 km link between two buildings with one access point and one client radio. The access point is connected to an antenna with 12 dBi gain, with a transmitting power of 500 mW and a receive sensitivity of -84 dBm. The client is connected to an antenna with 10 dBi gain, with a transmitting power of 16 dBm and a receive sensitivity of -82 dBm. The cables in both systems are short, with a loss of 3 dB at each side at the 900 MHz frequency of operation. What is the link margin? By examining the link margin, comment on the reliability of the link.
Consider a CSMA/CD network that transmits data at a rate of 100 Mbps (108 bits per second) over a 1 km (kilometer) cable with no repeaters. If the minimum frame size required for this network is 1250 bytes, what is the signal speed (km/sec) in the cable?
Suppose we have a reservation system with 50 users, frame transmission time of 0.6 sec, v = 0.3. (a) What is the effective frame transmission time? (b) What is the efficiency/throughput if all stations are transmitting? (c) What is the efficiency/throughput if a minislot can reserve up to 7 frames?
What is the delay of sending a data file from a source station to a destination station? Suppose that the length of the data file is 2 Mbytes and the bandwidth of the channel is 1600 bps, and the network link between the sender and receiver is 20000 Km and the speed of the light inside the link is 2x108 meters/second? Assume that the delay is composed of only transmission time and propagation time.
200 nodes are connected to a 1,500 metre length of coaxial cable. Using some protocol, each node can transmit 50 frames/second, where the average frame length is 2,000 bits. The transmission rate at each node is 100 Mbps (where 1 Mbps = 1,000,000 bps). What is the efficiency of this protocol?
Consider building a CSMA/CD network running at 1 Gbps over a 1km cable with no repeaters. The signal speed in the cable is 200000km/sec. What is the minimum frame size?
200 nodes are connected to a 1,500-meter length of coaxial cable. Using some protocol, each node can transmit 50 frames/second, where the average frame length is 2,000 bits. The transmission rate at each node is 100 Mbps (where 1 Mbps = 1,000,000 bps). What is the efficiency of this protocol?
You are designing the Wi-Fi for a classroom of 20 students and all students are using Wi-Fi at the same time. The protocol efficiency is 40% and the channel utilization is 80%. Each students uses a throughput of 2 Mbps. What is the minimum PHY rate requirement for the radio in Mbps?
An Internet-service provider company uses a fiber-optic network to transmit data between locations. Data are carried through fiber-optic cables and switching nodes. A portion of the company's transmission network is shown here. The numbers above each arc show the capacity in gigabits of data per second that can be transmitted over that branch of the network. 3 4 3 4 2 4 1 2 6 5 5 3 2 7 To keep up with the volume of information transmitted between origin and destination points, use the network to determine the maximum amount of data, in gigabits per second, that may be sent from node 1 to node 7. X GB/s 1
⦁ You are designing a connection mechanism between two programs, sending packets of data over the internet. You are trying to choose a size for the packets to be sent, depending on the capacity of the channel (channel bandwidth). For example, if a channel has a capacity of 10KB, then you can choose a packet size of 10KB, and send one packet, or choose a packet size of 5KB and send two packets...Etc. The problem you face is that the two programs are at two different locations, with two different channel capacities. If the first channel had a capacity of 3201KB, and the second channel had a capacity of 4565KB, find the maximum packet size that is suitable for both channels.
Consider two hosts S and R connected directly by a link. A link has a transmission speed of 107 bits/sec. It uses data packets of size 400 bytes. Data needed to transmitted is 400 bytes. Length of the link is 600 km and the propagation speed are 3 × 108 meter per second. T is the transmission delay and P is the propagation delay. The propagation delay in millisecond and transmission delay in microsecond respectively are