A voltage V =inductance. What is the instantaneous equation of the resulting current i?230 sin(377t +30) volts supplies power to a coil with 10 ohms resistance and 100 mH

Answered: Image /qna-images/answer/54261603-0d5a-4a68-8bf0-b92977b988d1.jpg

Answered: A voltage V = 230 sin(377t +30) volts…

A voltage V = 230 sin(377t +30) volts supplies power to a coil with 10 ohms resistance and 100 mH inductance. What is the instantaneous equation of the resulting current i?

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter18: Resistive-inductive Parallel Circuits

Section: Chapter Questions

Problem 1PA: Incandescent lighting of 500 W is connected in parallel with an inductive load. A clamp-on ammeter...

See similar textbooks

Related questions

Q: Instructions Calculate the DC voltages and currents in the circuit. Find current emitter, collector ...

Q: Sketch the even and odd parts of the signals shown in Fig. 2. Label your sketches carefully. x(t) 1 ...

A: Given:

Q: Given the plot below, determine the amplitude, duty cycle and period Figure 1 Fle Edit View Insert T...

Q: R1 400 L1 20mH R2 300 V1 R3 L2 20Vpk 60HZ 0° 30mH R5 1kO R4 250 100 C1 :100µF

Q: Two unfocused grids are each 10 mm in height with 0.05-mm thick Pb strips. Grid A has grid ratio of ...

Q: Sensor Circuit Light Source Control Alarm Photodiode Circuit Circuit 9. Which may not be used as an ...

A: Given, Alarm circuit is LED source ---> Photo Diode ----> Control Circuit ----> Alarm circ...

Q: Find Vr2, Vr4, and Vr5 in the circuit shown. 10 V R1 1 kN + 5 V VAZ R3 R2 2.5 kN 1 kN R5 VAS |V, R4 ...

Q: 15. At which cycle will the 16. At what exact value of voltage waveform be cut from the diagram will...

A: I am attaching detailed solution images of this question.

Q: cis)=. %3D S+リとラ-

A: Given C(s)=11+τs×1s2

Q: 7) State the three-classified instrument based on their functions.

A: We are authorized to answer one question at a time, since you have not mentioned which question you ...

Q: A three-phase uncontrolled bridge rectifier delivers power to a resistive load of 102. The output vo...

A: It is given that: RL=10 ΩVo=400 V

Q: An alternating current of frequency 60HZ has a maximum value of 12A. Write down the equation for its...

Q: Solve for Vo1 and Vo2. 4.7 Ka Ge Si 1.2 Ka -10 V K K +12 Vo Ge 3.3 M2 (a) (b) a. Vo1=Blank 1 V; Vo2=...

Q: For the voltage-divider configuration of the figure below: Show the details of your work. ...

A: The given circuit is shown below:

Q: Find vo 10 kl w- 100 kn 20 kn 9V 30 kn 10 v(+ 12 V 40 kn (+ 20 kn3 V.

Q: PROBLEM 3 Obtain i in the circuit using mesh analysis 12 V 2i V3 v2 ti 42 1Ω 4Ω

A: This problem comes under electrical network theory . It is based on the mesh analysis . Mesh analysi...

Q: Q 4. ... Write statement of maximum power transfer theorem with limitation & find the maximum power ...

A: Maximum power transfer theorem (MPTT): Statement: MPTT states that the load resistance must be equa...

Q: Describe how the circuit works 1A1 1V2 1V1 1S1 LAW W TH

A: Fluid power applications include pneumatics and hydraulics. Hydraulics uses relatively incompressibl...

Q: Ex. 235. See Figure 235 Given V4=63 volts, and 3 capacitors in microfara C1=26, C2=55, C3=38, determ...

A: In this question we will find total voltages across each capacitor in given figure....

Q: A certain series RL ac circuit has an instantaneous power of p(t) . = 125 + 250 cos 240rt. Find the ...

Q: D D2 4 ΚΩ 6 Ω 3V. 10 V

Q: A load is supplied the complex power S = 60 + j80 VA by a voltage source of 50 cos 377t V. Find the ...

Q: B- Determinate the output logic function (Y) & truth table for the following logic Circuit?

A: It is given that: a) b)

Q: x(1) = u(t – t,)

A: In this case, the Laplace transform of the following function is to be determined: xt=ut-t0

Q: Discuss the mechanism of incandescent bulb, fluorescent lamp and LED

A: (1) Incandescent Lamp The incandescent lamp works on the principle of heating effect of the electri...

Q: 1. A wye connected load has a 5 < 20° ohm impedance per phase and is connected across a 120 V three ...

Q: A 3 phase 1.2 MVA, 10 kV star connected synchronous generator has Zs= 0.2+J10 ohm. Using circle diag...

A: Synchronous Generators, often known as alternators, are the most commonly used generators for genera...

Q: 1. In a temperature measurement used a sensor that has a sensitivity of S = 10mV/°C. The measured te...

A: Since you have posted multiple questions, we will solve the first question for you. If you require t...

Q: Introduction of the kind of application used by Voltage Controlled Boiling to surfactants.

A: Bubble formation governs the process of boiling, which has been used to power enterprises since the ...

Q: Find v(t) and i(t) in the circuit shown.

Q: When an impedance coil is connected to a 100 V, 60-Hz, ac supply, the circuit current is 1.325 A. Wh...

Q: A resistor and a capacitor are connected in series across a supp 250V. When the supply frequency 50H...

A: Given The resistor and capacitor are connected in series Supply voltage V=250 v frequency is 50 Hz...

Q: You may have noticed that the electric field lines never cross. What exactly does this mean? Explain

A: Electric field lines cannot cross. If they did, they would be telling you that the force on acharge ...

Q: Find the value of the following Wilkinson's Factor: 8.

A: I am attaching detaild solution image of this question.

Q: R ... 1ko vi vo vi 20V vo 1000HZ 0.2uF 0° FIGURE 1 Question Question 2 In the filter shown in Figure...

Q: Using Node-Voltage Method, find the node voltages for nodes I and 2 in the following circuit 60 2 ww...

Q: Find the complex power supplied by the source and the power factor of the source fo the network show...

Q: R1= 50 R3= 7N 20V R= 40 R2= 30 R5= 9N R= 20

A: In this question we will find total resistance....

Q: Using Node-Voltage Method, find the node voltages for nodes 1 and 2 in the following circuit: IA 20 ...

A: This question comes under circuit theory . It is based on the concept of nodal analysis in the circu...

Q: An impedance coil is connected in series with a fixed resistor, and a 120-V, 50-cycle Source is then...

A: The solution is given below

Q: 2. The signal to noise ratio is 100:1 after 16 scans. What would the signal to noise ratio be after ...

A: Note : As per guidelines of bartleby we are supposed to solve one question, when the questions are ...

Q: Design a charger circuit for your mobile phone from: 220V, 50HZ AC source 1.5 V AA Battery a. b.

A: Mobile Phone Chargers- This device is used to recharge the mobile phone battery. These devices are ...

Q: A load is supplied the complex power S = 60 + j80 VA by a voltage source of 50 cos 377t V. Find the ...

Q: An operational amplifier (op-amp) is shown in Figure Q2(a). Given R; = 15 k2, Rf = 100 k2 and supply...

A: Since you have posted a question with multiple sub-parts, we will solve first three sub-parts for yo...

Q: For the given circuit B=100 for silicon transistor. The value of VCE and IC. (Answers should have on...

A: DC analysis of transistor is done by finding the finding the DC biasing values also known as Q point...

Q: A 100-mH inductor is connected in parallel to the series connection of a variable resistor R and a 2...

Q: An impedance coil is connected in series with a capacitor across a 220 V, 60 Hz ac supply. The circu...

A: In this question, An impedance coil is connected in series with a capacitor across a 220 V, 60 Hz ac...

Q: Q1). find the convolution of the two sequences s(n)=δ(n-2)-2δ(n-4)+3δ(n-6) h(n)=2δ(n+3)+δ(n)+2δ(n-2...

A: In this section are multiple question i have solved only one question Convolution is a mathematical ...

Q: Q2/ Write True or False for the following: 1) The discrete-time system is a device or algorithm that...

A: “Since you have posted a question with multiple sub-parts, we will solve the first three subparts fo...

Q: DETERMINE THE FFG. 4. Rx Rx 2. TOTAL POWER F THE CKT- U8- 2 AMP. 1052 64v.

Question

A voltage V =
inductance. What is the instantaneous equation of the resulting current i?
230 sin(377t +30) volts supplies power to a coil with 10 ohms resistance and 100 mH

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1 lo

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Alternating Current (AC) Series Motor and Universal Motor

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Incandescent lighting of 500 W is connected in parallel with an inductive load. A clamp-on ammeter reveals a total circuit current of 7 A. What is the inductance of the load connected in parallel with the incandescent lights? Assume a voltage of 120 V and a frequency of 60 Hz.
7. In a pure inductive circuit, the phase angle between the voltage waveform and current waveform will havephase shift * 180 deg O deg 45 deg O 90 deg 8. Why do we say the "voltage across" or "the voltage with respect to?" Why can't we just say voltage? * Voltage is a measure of electric potential difference between two electrical points. O It's an electrical cliche. The other point could be negative or positive. None of the above.
If i have a coil with an inductance 0.14 H and a resistance of 12ohm is connected across a 110V , 25Hz source. how would you make the current in the coil and the phase between the cirrent and supply voltage ?
A current of i = 5 + 10 sin 377t + 377t Ampere flows through a series circuit containing resistance of 5 ohms and an inductance of 13.26mH. Determine the expression of the total voltage. a. e=25+70.7 sin (377t + 45°) Volts O b. e 25+ 70.7 sin (377t - 45°) Volts = O c. e = 25 + 70.7 sin (377t – 30°) Volts O d. e 25+ 70.7 sin (377t +30°) Volts
The inductive reactance of a 0.06-H coil connected to a 120-V, 60-Hz source is?
If an electrical circuit draws 100W + J100VAR from a sinusoidal source, then what would the circuit be? Explain why. a) a pure resistor circuit b) a series or parallel R-L circuit c) a series or parallel R-C circuit d) a series L-C circuit
Please answer the problem below. Give the waveform for the current of a 10-mH coil if the voltage acrossthe coil follows the pattern of the figure below if t = 0s and the curren IL = 4 mA
• The relationship between voltage and current in pure inductive circuit is, The current lags the voltage by 180 degrees The voltage lags the current by 90 degrees The current lags the voltage by 90 degrees The current and the voltage travel the same angle
A triangle waveform with following specifications in Table B1. Table B1 RMS Voltage 50mV Number of cycles/second 100 i) Sketch the approximate triangular waveform with all specifications. ii) A transformer has primary coil with 100 turns and secondary coil with 120 turns. Estimate the current in the secondary coil, If the current in the primary coil is 4 Ampere
For the series RL circuit shown in the figure below, answer the following questions and justify your answer.If the current is kept constant, does the coil have inductance?If the current is kept constant, does the coil affect the current value?Can the reverse emf ever be greater than the battery emf?
5) Find the reactance the inductance and impedance of the circuit. Calculate the current of this circuit and the sketch waveform of current and voltage. V1 10 V 60 Hz R1 m 100kQ 12 Vrms 1000 Hz 0° 6) Find the reactance the inductance and impedance of the circuit. Calculate the currents of this circuit R www 502 L L1 106mH eee 10 mH
A relay has 12 ohms resistance, and a 2.4 H inductance is suddenly switched across 120 volts supply of negligible internal resistance. Determine the instantaneous current after 0.1 second.Ans 3.9