A vaulter is holding a horizontal 3.00-kg pole, 4.50 m long. His front arm lifts straight up on the pole, 0.750 m from the end, and his back arm pushes straight down on the end of the pole. How much force does his back arm exert on the pole? Fback = [?] N onal Academy of Science. All Rights Reserved. Enter

A vaulter is holding a horizontal 3.00-kg pole, 4.50 m long. His front arm lifts straight up on the pole, 0.750 m from the end, and his back arm pushes straight down on the end of the pole. How much force does his back arm exert on the pole? Fback = [?] N onal Academy of Science. All Rights Reserved. Enter

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

A 6.0 m plank with a mass of 50 kg is supported on both ends. An 80 kg worker stands on the plank 1.5 m away from the left end. What weight must each end of the plank support? Separate your answers by a comma (i.e. 340 N, 567 N - the first answer for the left end, the second answer for the right end). Express your answer as a whole number (no decimal). Add the appropriate units.
A bridge of length 57 m and mass 80000 kg is supported at each end. A truck of mass 38200 kg is located 27 m from the left end. A MA W - 27 m B 57 m- What is the force on the bridge at the left point of support? The acceleration of gravity is 9.8 m/s². Answer in units of N. Your response... Previous Responses X #1.412105.263 PALETTE
2. A gymnast with mass 46.0 kg stands on the L. end of a uniform balance beam. The beam is 5.00 m long and has a mass of 250 kg (excluding the mass of the two supports). Each support is 0.540 m from its end of the beam. Answer the following questions. In unit-vector notation, what are the forces on the beam due to support 1 and support а. 2? b. What could be the mass of the balance beam such that the gymnast can just tip the beam at that position?
A 10.5 kg board 6.00 m long is supported by two sawhorses, one at each end. A 4.45 kg saw sits on the board 1.80 m from the left end. Find the upward force that the RIGHT sawhorse exerts on the board. (Unit = N) Academy of Science. All Rights Reserved. Q Search O H Enter hulu
A traffic light hangs from a pole as shown in the figure below. The uniform aluminum pole AB is 6.50 m long and has a mass of 14.0 kg. The mass of the traffic light is 20.0 kg. Determine the vertical and horizontal components of the force exerted by the pivot A on the aluminum pole. 37 3.80 m Q 150 N, 300 N O 220 N, 347 N Q 362 N, 333 N ( 410 N,328 N Q 200 N, 400 N A OOD
A uniform horizontal beam with a length of 8 m and a weight of 200 N is attached to a wall by a pin connection. Its far end is supported by a cable that makes an angle of 53° with the beam. If a 600-N person stands 2 m from the wall. What is the tension in the cable? 53.0% 8.00 m O A. 502 N O B. 410 N O C. 196 N D. None O E. 313 N
If you hold your arm outstretched with your palm upward, the force to keep your arm from falling comes from your deltoid muscle. Assume that the arm with hand has mass 4.25 kg and the distances and angles shown. What force must the deltoid muscle provide to keep the arm in this position, in Newtons? Use g = 10.0 m/s2. the answer is 367, please explain how?
A uniform 100-lb beam is held in a vertical position by a pin at its lower end and a cable at its upper end. A horizontal force (magnitude P) acts as shown in the figure. IfP = 75 lb, what is the vertical force at the pin? 3.0 ft Select one: О а.61 lb 5.0 ft O b. 69 lb с. 54 lb O d. 47 lb О е. 127 |b O f. 75 lb g. 28 lb
Figure P8.27. Find the tension in each rope when a 700.-N worker stands 1.00 m from one end? e2cm lon ropes, as indicated by the blue vectors in 27. VA uniform plank of length 2.00 m and mass 30.0 ke by three ropes, as indicated by the blue vectors in supported Figure P8.27. Find the tension in each rope when a 700 N person is d = 0.500 m from the left end. er of gravig fo 12, modeling rethooran 8 B of model 10.26 T, T2 0.250 Theatthe le 40.0° lid or boln vibbud ns bano sdi svode m81 o + d » 3. 2.00 m di In bas rirob be ss gairda Figure P8.27 goil sdrto idgiod oh bail rel 2 00 bou d 28. A hungry bear weighing 700. N walks out on a heam in
2. A gymnast with mass 46.0 kg stands on the end of a uniform balance beam. The beam is 5.00 m long and has a mass of 250 kg (excluding the mass of the two supports). Each support is 0.540 m from its end of the beam. Answer the following questions. In unit-vector notation, what are the forces on the beam due to support 1 and support а. 2? b. What could be the mass of the balance beam such that the gymnast can just tip the beam at that position?
2) Ray decides to paint the outside of his uncle's house. He uses a 4.0-m-long board supported by vertical cables at each end to paint the second floor. The board has a mass of 21 kg. Ray (70 kg) stands 1.0 m from the left cable. What are the forces that each cable exerts on the board?
F, y mg AF f.y F, fx e Axis The ladder in the picture has a mass of 39 kilograms and a length 3 meters. What is the normal force pushing the ladder up from the floor? This force is labeled Ff y in the picture. FN N. %D Assume that the ladder's weight is evenly distributed, so it can be treated as a single force through the middle. If the ladder is at a 69° angle from the ground, what is the torque exerted by the weight (using the floor as the pivot point)? N.m The torque from the ladder must be balanced by the torque caused by the normal force on the wall, labeled Fw in the picture. Calculate this force. Fw - N. The normal force from the wall must be balanced by the friction force from the floor, labeled Ff x.in the picture. Determine the minimum coefficient of friction to keep the