A tugboat is used to tow a barge as shown in Fig. The weight of the cable, after accounting for the buoyant force of the water on the submerged cable, is 120 N/m. The horizontal component of the force exerted on the barge by the cable is 40 kN. Determine The length of the cable. 200 m
Q: Calculate the pressure exerted by water on the hull of a submarine that is cruising at a depth of…
A: Depth, h = 500 ft = 152.4 m Density of ocean water = 1025 kg/m3
Q: Define the pressure of a fluid at rest increases with depth (as a result of added weight).
A: Given Data: The density of the liquid is ρ. The depth at which the pressure is to be defined is h.…
Q: If a man weighs 210 lb at sea level, determine theweight W of the mana. At the top of Mt. Everest…
A: Write the formula for the weight of the man at sea level using Newton's law of gravitation. Here, W…
Q: 4. The figure on the right shows a gate for a dam enclosing a seawater (S.G. 1.03) which is having a…
A: given; ⇒specific gravity (SG)=1.03⇒radius of gate (R)=1m⇒width of gate (w)=0.7m
Q: The hull of a boat has a volume of 200 m3, and the total mass of the boat when empty is 8900 kg.…
A: Given data,
Q: The volume and the average density of an irregularly shaped body are to be determined by using a…
A: In this problem, assume that the air and water are in a stationary condition. The density of air…
Q: ample 2: Convert the quantities 300 lb.s and 52 slug/ft' to appropriate SI units.
A:
Q: Q4; A liquid when poured into a cylinder is found too weigh 12 N when occupying a volume of I liter.…
A:
Q: Practice Problem 2: The figure shows the water pressure acting on the sides of a dam that is 20-m…
A: h=Length of the Dam=20 mq1=750 N/m2q2=1217 N/m2
Q: the maximum force, P (in lbs) wit
A:
Q: An open horizontal tank 3 m high, 3.5 m wide and 5.5 m long is initially filled at 2 m of water. a.…
A: Disclaimer: Since you have posted a question with multiple sub-parts, we will solve the first three…
Q: A hydraulic lift is to be used to lift a 5000-lb weight by putting a weight of 50 lb on a piston…
A: Given data, F1=5000 lb F2=50 lb D2= 0.5 ft , Let D1 be the diameter required
Q: tank for medical
A: Mass= 0.325 kg
Q: A flotation buoy has mass 806 kg, volume 1.43 m, and is attached to the sea floor by a cable in such…
A: Given Mass of buoy, m = 806 kg Volume of buoy, V = 1.43 m3 Density of sea water = 1025 kg/m3…
Q: 3. Determine the vertical and horizontal forces on the cylinder shown in Fig. below. The cylinder is…
A:
Q: a container whose capacity is 7.29 m^3 weighs 1867 N when empty and 9.53 kN when filled with a…
A: Given data: V=7.29 m3w=1867 NW=9.53 kN Need to determine the density of the fluid.
Q: Situation 9. The figure shows the water pressure acting on the sides of a dam that is 20-m long.…
A: tan θ =126=2⇒θ =63.435° Length of dam1 = 20mMagnitude of force F1= 12x 750 x 122+62 x20…
Q: 1. A block of wood that weighs 16lbr and of specific gravity with a relative density of 1213.6…
A:
Q: The length of submerged gate AB is 7 m. Determine the amount of horizontal and vertical components…
A:
Q: 1. What is the relation do you find between the weights of the floating body and the weight of water…
A: NOTE:- As per our company guidelines we are supposed to answer only one question. Kindly repost…
Q: water, while the other arm contains both f to-water height ratio of 4. Determine the heig n that…
A:
Q: flow of water from a container is controlled by a 6 ft wide L-shaped gate hinged at point a. If the…
A: Given:
Q: What lift does the balloon exert at an elevation of 16km, assuming that the volume has increased…
A: Given data: Elevation = 16 km Initial Volume = V Final Volume = 1.1V Unit weight of air = 2.50 N/m3
Q: An irregularly shaped object floats freely in water (y = 62.4 lbf/ft'), such that 20 of the volume…
A:
Q: A flotation device with volume = 0.15 m3 and specific weight 1 = 0.27H20 is held submerged in a tank…
A:
Q: Q6: A force of 1600 N is applied uniformly on a piston of 8 cm diameter. Determine the pressure on…
A: Given Force, F=1600N diameter, d=8 cm⇒8*10-2 m Area, A=π4.d2 A=π48*10-2 2 A=5.025*10-3 m2
Q: Finish attempt.. Q1) A gate is made of a cylinder of 3 meters in length. The gate will start opening…
A:
Q: 9. If methane gas has a specific gravity of 0.55 relative to air at 70OF, what are its specific…
A:
Q: (b) A vessel of 4 m' volume contains an oil which weighs 30.2 kN. Determine the specific gravity of…
A: Given data : The volume of the vessel (V) = 4 m3 weight of oil (W) = 30.2 kN To determine the…
Q: 9. When a dolphin glides through air, it experiences an external pressure of 0.75 m of mercury. The…
A: When dolphin glides through air, it will experience atmoshpheric pressure. Hence, we are given…
Q: A tank contains mercury up to a height of 0.3 m over which water stands to a depth of 1 m and oil of…
A:
Q: 26. A piece of plastic is held under water by a cord, as shown. Which is larger, the magnitude of…
A: Draw the schematic diagram of the plastic.
Q: The friction force between a 6 × 6-ft square sluice gate AB and its guides is equal to 10 percent of…
A: The hydrostatic force acting on gate, The friction force on the gate,
Q: 1 What is the net force on a ball of mass 20 kg and volume of 0.2 m^3 when it is submerged…
A:
Q: For the tank of water shown below, the radius of the circular surface is R=1.0 m, h=1.0m, and the…
A:
Q: A 1.67-m-diameter cylindrical mass is connected to a 3-m-wide rectangular gate as shown. The gate is…
A:
Q: You are given the shape of the vertical ends of a trough that is completely filled with water. Find…
A: Given The height of the trough is h=5 ft. The base of the trough is b=8 ft. The weight density of…
Q: A crane is used to lower a 0.4 m³ concrete block (density, p = 2200 kg/m³) into the sea (density, p…
A: Given data: The volume of the concrete block, V = 0.4 m3. The density of the concrete block, ρc =…
Q: 1.The density P Determine how the density varies with pressure along the depth h. The density at the…
A: As per our guidelines, experts can provide solution to only one problem in case of multiple…
Q: A tank for medical use has a cylindrical shape, determine its mass (in kgs) if the density of the…
A: GIVEN DATA DENSITY = 2.3 kg/m3 D=300mm L=2m WE HAVE TO FIND MASS
Q: An open rectangular tank 1 m wide and 2 m long contains gasoline to a depth of 1 m. If the height of…
A:
Q: The water pressure acting on a masonry dam varies as shown. If the dam is 20 ft wide, determine the…
A: Given Data, b= Width of the dam = 20 ft = 6.096 m P12 = Pressure at 12 m depth = 750N/m2 P19.5 =…
Q: PROBLEMS : A cube of wood floats in oil with a relative density of 0,78 so that half of the cube is…
A:
Q: Balloons are often filled with helium gas because it weighs only about one-seventh of what air…
A: Given Data Diameter of the balloon is: d=12 m Mass of each person is: m=70 kg Density of air is:…
Q: An open aquarium containing water and supported by wheels is allowed to accelerate without friction…
A: Draw the schematic as shown.
Q: If a man weighs 210 lb at sea level, determine the weight W of the man at the top of Mt. Everest…
A: GIVEN : weight of man at sea level=210lb
Q: The water pressure acting on a masonry dam varies as shown. If esultant force of the water pressure…
A: GIVEN:width of the dam w=20ft
Q: What is the actual weight of a block when its weight in water is 200 N?
A: suppose, block material is of iron. iron density, ρ = 7870 kg/m3 water density, ρw =1000 kg/m3 Block…
Trending now
This is a popular solution!
Step by step
Solved in 2 steps with 3 images
- Determine the force F required to pull up the 3.54m stopper from the drain of a sink if the depth of water is 10 in. Use =0.036lb/in.3 for water and neglect the weight of the chain.The weight of the cylindrical tank is negligible in comparison to the weight of water it contains (water weighs 62.4lb/ft3). The coefficient of static friction between the tank and the horizontal surface is s. (a) Assuming a full tank, find the smallest force P required to tip the tank, and the smallest s that would allow tipping to take place. (b) If the force P = 200 lb initiates tipping, determine the depth of water in the tank.The 12-ft wide quarter-circular gate AB is hinged at A. Determine the contact force between the gate and the smooth surface at B due to water pressure acting on the gate. Use =62.4lb/ft3 for water.
- Find the force applied by support BC to the gate AB. The width of the gate and support is 3 m and the weight of the gate is 1500 N.Situation 9. The figure shows the water pressure acting on the sides of a dam that is 20-m long. Determine the resultant force of the water pressure acting on the dam.A rectangular plane surface is 1.7 m wide and 2.7 m deep. It lies in vertical plane in water. Determine the total resultant force (in kN) on the plane surface when its upper edge is horizontal and 2.1 m below the free water surface.
- A person wearing long snowshoes can walk across a blanket of freshly fallen snow without sinking far into the snow because (p.s. Google snowshoe if you don't know how one looks like) snowshoes cover a larger area than a foot and so the pressure is reduced. the snowshoes reduce the force of the person on the snow. the large area of the snowshoe concentrates the force of the person to a point smaller than the foot. snowshoes push less dense snow out of the way so the person stands on more solid ice below4.0 m السرو 4.0 m The raft is made of solid square Pinewood (density= 550 kg/m'). Determine whether the raft floats in water (density = 1000 kg/m) and if so, how much of the raft is beneath the water surface. Weight of raft 0.30 m Since the density of the raft (pinewood) is less than that of water, the raft foats. Q: A force of 250 N is applied to a hydraulic piston that is 0.01 m in diameter. If the piston which supports the load has a diameter of 0.10 m, approximately how much mas can be lifted? 250 N 0.01 m 0.10 mThe volume and average density of an irregularly shaped object are to be measured using a spring balance. An object weighing 8200 N in air weighs 4740 N in water. Determine the volume and average density of the object. (The object is completely submerged in water.)
- 95 bläi 5 In the Fig. below is shown the * cross-section of the tank full of water under pressure. The length of the tank is 3 m. An empty cylinder lies along the length of the tank on one of its corners as shown. The horizontal component of the force acting on the curved surface ABC of * :the cylinder is 28 kN/m A r= 1.0m Tank full of water Empty cylinder1. What force is required to keep the 5 ft wide gate closed. Neglect the weight of the gate. 10 ft H20 Hinge 8 ftt 6 ft 2. The gate shown opens when the water reaches a certain height. Determine that height. 5 fi Hinge 4 ft -BlockA hydraulic lift is to be used to lift a 5000-lb weight by putting a weight of 50 lb on a piston with a diameter of 0.50 ft. Determine the diameter of the piston on which the weight is to be placed.