A three phase motor has a phase angle of 18 degrees with phase voltage of 420V and la =15A. What is the load angle if Xsd = 15ohm and Xsq =7?

Q: R(s) + K 25 s 0.04 S C(s)

A:

Q: 3. Find the ratio of starting to full-load current for a 7-46 kW, 400 V, 3-phase induction motor…

A: Three-phase induction motor A three-phase induction motor is an electromechanical energy converter…

Q: 6.11 Concentric cylinders p 2 cm and p = 6 cm are maintained at V = 60 V and V = -20 V,…

A: Given data Cylindrical radius ρ=2 cm ρ=6 cm Voltage V=60 V V=-20 V We need to calculate the value of…

Q: $ 2.7 Sinusoidal Inputs; Half-Wave Rectification 26. For the network of Fig. 2.150, sketch v, and…

A:

Q: Given a transformer with Np-100 and Ns-2000, what is the primary voltage when the secondary voltage…

A: As per our company guidelines we are supposed to answer only first question kindly repost the other…

Q: Example 2: A 220V shunt motor runs at 800rpm and takes an armature current of 50A. find the…

A: In this question We need to determine the resistance added in the field winding to increase the…

Q: I. Simplify the logic function given by f = {(1, 3, 7, 12, 13, 14, 15, 8, 9, 10) with the DON'T CARE…

A:

Q: 1. On a lossless 500 coaxial transmission line with a shorted load: a. a voltage minimum will occur…

A: Given data A lossless transmission line is given in the problem. Characteristic impedance, Zo=50 Ω…

Q: Ejercicio 3: Utilizando las Leyes de Kirchhoff, encuentre las corrientes: 1₁; 1₂ e 13. Respuesta: 1₁…

A:

Q: 24 V V1 www 1+ 12 V V2 V3 +1 10 V

A:

Q: 2. Write superposition equations used to solve questions. Add screenshots of circuit on ThinkerCad…

A: Given data circuit diagram with multiple independent sources is given in the problem. Part-a circuit…

Q: ■ Calculate the current Ic Ic Vs 1000° -j5 Ohm 8 Ohm j6 Ohm

A: Circuit is given as:

Q: A 4-pole, 50 Hz, 3-phase induction motor has blocked rotor reactance per phase which is four times…

A: Number of poles P = 4 Frequency f = 50 Hz Reactance of rotor = 4×Resistance of rotor per phase.

Q: Solution A 15 mH is connected in series with another coil. The total inductance in series addition…

A: Given: Two inductor coils are connected in series. The inductance of the first coil, L1=15 mH Total…

Q: 4. Find the transient charge in an RLC series circuit when: L = 1H C = 0.25F R = 2Ω E(t) = 50 cos tV…

A: Note: Resistance doesn't depend on source frequency  Reactance of capacitor or inductor depends on…

Q: Identify the correct statement regarding the machine whose state table is (PS-Present State, NS-Next…

A: From the given machine state table it is asked to find the correct statement

Q: lo vd1 1₂ ******* 1. With the figure above derive the value of vd-vd1. Answer:

A:

Q: In the half wave rectifier with freewheeling diode shown, R = 20 22 and L = 120 mH, Vm is 62.8 V,…

A:

Q: Operational amplifiers (op amps) are a special signal-conditioning building block around which many…

A: Given: OP-AMPs are not used as a building block in which of the following circuits?

Q: Question 5. A digital system has Z transfer function G(z) The input signal {un}, n ≥ 0, is un =…

A:

Q: Use of computers in digital control systems is particularly valuable for a number of reasons,…

A: Use of computers in digital control systems is particularly valuable for a number of reasons,…

Q: 3) Find the Thevenin equivalent with respect to the terminals a and b for the circuit in the figure.

A: The thevenin's equivalent circuit can be obtained by calculating the open circuit voltage and…

Q: In the circuit below, v1 = 10 V and i1 = -2.5 A. Use mesh analysis to find V i1 200 V₂ = 50 Ω ww 10…

A:

Q: For the block diagram in the attached pdf. 1 Find e when R(s) = SS Let K = 2. 2 — and D(s)=0.

A:

Q: The manufacturing and production of mineral water is considered generally as a: O Self Regulation…

A: The manufacturing and production of mineral water is considered generally as a: a) Self Regulation…

Q: Find the difference equation for the following transfer function: H(z) = 1+2Z/(3+Z)(4+Z)

A: transfer function of a given discrete system is given  it is asked to find the difference equation

Q: Q2/ (A) Determine the energy and power of the following signal: X(t) T2A -1 0 (B) Simplify the…

A: given signal .we have to calculate power and energy

Q: 1.1 Using the formula dv/dt approximate the slope of CT Answer: Vi vdc=1.8V 13 idc-Su A vd vd pr 010…

A:

Q: Q2) If line charge density p₁ = 2 nC/m lies on the x-axis [between points (1, 0, 0) and (7, 0, 0)]…

A:

Q: The transmitter send the data "0, 1" to the receiver side in BPSK, what is the symbol like in the…

A: The given problem is from communication system.  The detailed solution is given in the next step

Q: What is the ignition phase R S T in each thyristorThree-phase AC voltage regulators delta connection…

A: We have to explain the ignition phase RST in each thyristor Three-phase AC voltage regulators delta…

Q: A few measurements on the below circuit produces the labeled voltages (indicated in blue colors Find…

A: Given: In this question, the given details are, The given circuit diagram is, To find the value of…

Q: In digital signal processing , how can express the joint time frequency analysis methods or some…

A: In digital signal processing we have to express the joint time frequency analysis methods or some…

Q: 1. On a lossless 500 coaxial transmission line with a shorted load: a. a voltage minimum will occur…

A: Given data A lossless transmission line is given in the Question. Characteristics impedance (coaxial…

Q: Q.4: What is the sampling theorem this issue carefully with an condition? .example What is happening…

A: According to the Sampling Theorem, any signal can be regenerated or reproduced without any loss of…

Q: a. What is the DC gain of this amplifier? (in dB) b. Where is the input pole frequency located? (in…

A:

Q: Q3. For the JFET fixed-bias configuration shown in Figure 1, determine the following by DC Analysis:

A:

Q: Af we have pil 3, 30, 45) Find the point pin Cartesian and Cylindrical systes.

A:

Q: estion S A 119 kVA, three phase star connected altern at full load and 0.8 power factor lagging DO…

A: Given data, Rated KVA rating S=119 KVA. Line voltage VL=1196 V. Armature resistance Ra=0 Ω.…

Q: A sequence is defined by the relationship r[n] = Σ h[m]h[n+m} = h[n] * h[−n], m-00 where h[n] is a…

A: Given data rn=∑hmhn+mm=-∞∞= hn*h-n and  rn=4312nun+432nu-n-1 We need to find the Z transform of rn…

Q: 3. An audio-frequency generator is set to output v(t) = 5sin(400t) on a series RLC circuit. the…

A: In this question We need to determine the total impedance of the circuit, power factor of the…

Q: 1. A time-domain quantity is given as x(r)-5sin(3r+15). The phasor of this quantity is: (a) X-Se-A…

A: Given data, Function is given as xt=5sin3t+150.

Q: The LDO needs to be designed for VDD = 1.8 V with load current I varying from 200μA to 2 mA. Ignore…

A: Given: In this question, the given details are, The LDO needs to be designed for VDD=1.8V with load…

Q: y'''+17y''+80y'+100y=3(u''+5u'+4u)

A:

Q: A certain op-amp has three internal amplifier stages with midrange gains of 30 dB, 40 dB, and 20 dB.…

A: Operation Amplifier: We will see that operational amplifiers are linear devices with all the…

Q: 1. For the following circuit find a. VGSQ,IDQ b. VG, VD, VS, VDS 1 MQ + 12 V ¹2.2 kQ 1.6 kQ -3 V…

A: We need to find out the current and voltage for given circuit.

Q: 17-11 The thinnest copper wire normally manu- factured has a radius of 4 x 10-5 m. Find the…

A:

Q: Design a DC Power Supply Circuit with fix output (+5V & 3.3V) and variable output from (0 to 15V -…

A: a) The Block diagram regulated the power supply circuit  The electronic design above shows four…

Q: a) Fill in the table below for 4-bit A/D converter if Va = 13V with a reference voltage of 15V. Show…

A: According to the question, for a 4-bit SAR ADC the reference voltage is 15 V and the input voltage…

Q: Initially a d.c shunt motor having ra = 0.5 Ω and Rf = 220 Ω is running at 1000 rpm drawing 20 A…

A:

Single Phase Induction Motor

The single-phase induction motor or engine consists of a single rotating phase in the stator and a rotating cage in the rotor. When phase one supply is connected to the stator winding, a magnetic field is generated. In the pulsating field, the rotor does not rotate due to inertia. So, a single-phase import motor does not start and requires some initial methods.