A three-phase 2,300-V, Y-connected wound rotor synchronous rotor has Xs=2 ohms/phase and Ra=0.1 ohms/phase. The motor operates at 0.866 leading power factor while taking a line current of 350 Amperes. Find the power angle in degrees.
Q: 1. Determine V, 1₁, ₁ and ₂ for the parallel diode D1¹ D2 configuration in the figure.
A:
Q: 9ΩΣ b 6Ω 6V 9Ω ww V₂ Σ6Ω 6Ω 6V I 13 ΤΑ 39Ω (a) In the circuit above, I₁ 42/81 A, I₂ = 42/81 A, and…
A:
Q: 5/A- Consider the FSR of length 3 with nonlinear feedback function f(X1, X2, X3)=10x₂0x30x₁x₂ when…
A:
Q: A charged capacitor stores 10 C at 40 V. Its stored energy is:
A: Given data, Charge on capacitor Q = 10 C. Voltage across capacitor V = 40 V.
Q: A decimal to BCD priority encoder has inputs 0, 2, 5 and 9 activated; the active-high BCD output is:
A: Let the inputs of decimal to BCD priority encoder be D9, D8,D7,D6....., D0. Let the outputs of…
Q: need help question 5&6,pls assit
A: Resistor ,Capacitor,Inductor and voltage source are connected in parallel. Erms=230 volt (given)Real…
Q: Question 33 Refer to the circuit represented in Fig. 2.33, while noting that the same current flows…
A:
Q: Determine the required peak reverse voltage rating in the following circuit. R₁ 1 ΚΩ www Vs 200 Vpk…
A:
Q: 844 1242 2, 12 :G. 30- s : 2TV
A: The given problem is from circuits. The problem can be solved by using nodal analysis. The…
Q: In Fig., the potential difference between points P and Q is P 2A 252 m 10V 8Ω + 4Ω ww 692 Q
A: In this question We need to determine the potential difference between node P and Q. We are solving…
Q: 11) A binary receiver system receives a bit rate of 1 Mbits/sec. The wavefoem amplitude is 5 mV and…
A:
Q: ĮRc -vout {{REZ VAZOO find Av
A:
Q: A conducting bar rests to complete a circuit and immersed on a uniform magnetic field of B = 0.44 T.…
A: This is a question regarding the force on a current carrying conductor in a magnetic field. The…
Q: 2. A horizontal magnetic field of 2 × 104 T forms an angle of 30° with a current-carrying wire, 0.8…
A: Given: Horizontal magnetic field: B=2×10-4T forms an angle θ=30° Length of wire L=0.8mCurrent I=15A…
Q: -The line current taken
A:
Q: 300 MW, 30 z generator transm ing 260 MW real power to an bus through double transmission lines. A…
A:
Q: Determine VDS in the CC1 V₁H RG IM the circu VDD=+12V G RD D 10k не CC₂ Rs12k R$2 4k IDSS=12 mA…
A:
Q: _0. Using node analysis in the circuit of the given figure, find the voltage Vo. 1 ΚΩ 1 1ΚΩ +)12V…
A:
Q: Question No.63 The hexadecimal representation of (657), is
A: Given- Octal number, 6578. To find- The hexadecimal representation for a given octal number.
Q: 2. True or false In general, the output O depends not only on the signal input I but on…
A: As per guidelines given to us we can only provide the solution of first question in multiple type of…
Q: Determine V, the voltage of the dependent voltage source in the circuit
A: In this question We need to determine the voltage as shown the circuit. We know Current I= V/R
Q: A 10 Ω 50 Ω RL ww 20 Ω 40 Ω
A:
Q: The supply voltage and current drawn by a circuit are 200-30° V and 22-50° A respectively. Determine…
A:
Q: A circuit consists of a battery with an EMF of 2.5 V and three capacitors in parallel, where C₁ =…
A:
Q: Use nodal analysis to determine the current in the brach labelled i3 of the circuit shown below. R1…
A:
Q: A digital voltmeter has a read out range from 0 to 999 counts. If the full scale reading is 9.99 V,…
A: In this question We need to choose the correct options. We know resolution= VFL /count
Q: real power
A:
Q: Looking at this figure (from the textbook), what can you conclude about the direction of electric…
A:
Q: A resistance of 50 ohms is connected in a series with capacitance of 20uF , if a supply of 200V ,…
A:
Q: A long, straight wire carries a current of 15.0 A. What are the magnitudes of the magnetic field at…
A: Given that, I=15A We have to find B for a)r=2cm=0.02m b)r=4 cm=0.04m c)r=10cm=0.01m
Q: write a short note on balance modulator.
A: Introduction A balanced modulator is a circuit that produces double-sideband suppressed-carrier…
Q: 3) A light sensing circuit uses a LDR in series with a 22 k2 resistor. The resistance value of the…
A:
Q: Describe the difference between the protection of a radial power system and the protection used on…
A: Radial power system and Interconnected (meshed) networks.
Q: What if we have Re=8.31k Rc=8k Rb=100k Ie=1mA Ic=0.99mA Ib=0.0099mA Vcc=Vee=10v Beta=100
A:
Q: 23. Convert the following expressions to sum-of-product (SOP) forms: a. (A + B) (C+B) 24. Convert…
A:
Q: What is the rectification efficiency if an applied input ac power to a half wave rectifier is 150…
A: Given- Input AC power Pi=150 W, Output DC power Po=50 W, To Find- The value of the rectification…
Q: Problem 1: The driving circuit shown has a peak output voltage of 8 V. The LED has ratings of VF =…
A: Given, Vs = 8 volt, Vf = 1.8 To 2 volt, Idiode = 16 mA, To find the value of current limiting…
Q: D2 4. Determine the currents I₁, I₂, and I for the network shown in the figure. H 20 V Ľ Si D₂ 3.3 k…
A: We need to find out the current current through each resistor and current through diode for given…
Q: stories abo of people who receive radio signals fillings Suppose you have one filling that is 2.5 mm…
A: Let be wavelength, be the speed of light, and f be frequency Given that λ =…
Q: A point charge of +1 nC is placed in a space with a permitivity of 8.85 × 10-¹2 F/m as shown in Fig.…
A: Given- Point charge, q = 1 nC placed in a space. Permittivity, εo=8.85×10-12 Fm. Two points P and Q…
Q: 6. A loop measuring 15 cm on a side has 50 square turns. When placed in a 0.75-T
A:
Q: A single-phase 111-V, 50-Hz supply is connected to a coil with 200 turns of a coil-core assembly as…
A:
Q: For the instantaneous function: v(z,t) = 100 cos(10³t-0.5z+30°) V/m a) indicate the propagation…
A: We need to find out direction of propagation and phasor of given wave .
Q: Bus 1 V=1 p.u. Slack Bus j0.05 p.u. j(x) p.u. Bus 2 jo.025 p.u. (0.8 + j0.6) p.u. Bus 3 P= Y p.u.…
A: As per Bartleby guidelines, only 1 question can be solved, please send other questions separately…
Q: a) Find the node voltages V₁, V2, and v3 in the cir- cuit in Fig. P4.21. lov-obon or b) Find the…
A: It is given that:
Q: Current Transformer Distributed capacitance C of a coil is measured by a Q-meter. At a frequency of…
A: Given- Frequency- f1=1 MHz, f2=2 MHz, To Find- The value of Cd.
Q: A single phase distributor supplies two single phase loads as shown. What is the voltage drop from A…
A: Given data, Circuit diagram is given as,
Q: Suppose Q₁ = 4.2 nC and Q₂ = 8.4 nC (Figure 1). Figure 2₁ + 5.0 cm 10 cm 1 of 1 Q₂ + Part A What is…
A:
Q: 8) Find the capacitance that passes a 40A current when connected across a 6.6kV, 60Hz transmission…
A: Given: A circuit, To find: The value of capacitance C1.
Q: Homework 2: Design an Op-Amp circuit by depend on this figure as shown below? Inverting Amp. % dvo…
A: Given circuit
Step by step
Solved in 2 steps with 2 images
- A 6-pole, 3-phase, 60-cycle alternator has 12 slots per pole and four conductors per slot. The winding is 5/6 pitch. There are 2,500,000 maxwells (0.025 weber) entering the armature from each north pole, and this flux is sinusoidally distributed along the air gap. The armature coils are all connected in series. The winding is wye-connected. Determine the open circuit emf of the alternator.In a synchronous generator, a DC current is applied to the rotor windingList two advantages of this arrangement.The armature of a two-pole generator is rotating at 3600 r/min. The armature has a simplex lap winding with a total of 1504 conductors. Determine the generated voltage when the flux per pole is 600,000 x 10-8 Wb. 5.5
- A 6-pole ,3 phase , 60 cycle alternator has 12 slots per pole and four conductor per slot. The winding is 5/6 pitch. There are 2,500,000 Maxwell ( 0.025 weber ) entering the armature from each north pole, and this flux sinusoidally distributed along the air gap. The armature coils are all connected in series , The winding is wye connected. Determine the open circuit emf of the alternator.AC Machinery Fundamentals A three-phase delta-connected six-pole winding is installed in 36 slots on a stator. There are 150 turns of wire in each slot of the windings. All coils in each phase are connected in series. The flux per pole in the machine is 0.060 Wb, and the speed of rotation of the magnetic field is 1000 r/min. What are the resulting phase and terminal voltages?A 6 pole DC wave wound generator has 28 armature conductors with flux per pole is 23 mWb and the e.m.f generated is 64 V, then the speed of the machine is O 99.38 rps O 0.63 rps O 33.13 rps O 6.34 rps The thermocouples are suitable for temperature measurement applications in the range of 200°C to over 2000°C. Select one: O True O False
- A synchronous generator runs at 250 rpm and generators at 60HZ. There are 240 slots each containing 5 conductors arranged in full-pitched winding for three-phase star connection. All the conductors of each phase are in series and the flux per pole at no-load distributed sinusoidally over the pole pitch is 2.5 x106 Maxwell. What is the emf induced in each winding and the terminal voltage?8-pole 3-phase star-connected alternator with 144 grooves in its armature rotates at 900 rpm. There are 12 conductors in each groove in the armature of the alternator. The magnetic flux of one pole is 1.8.10 ^ 6 maxwels. Coils (1-16) were wound in -15 steps. Accordingly, find the phase and interphase voltages induced in the inductor of the alternator. (The speed of the alternator will be taken as synchronous speed ns.)An ideal dc generator has regulation of 40% 20% O 30% Zero
- A 6 pole DC lap wound generator has 41 armature conductors with flux per pole is 23 mWb and the e.m.f generated is 80 V, then the speed of the machine is O 0.74 rps O 84.84 rps O 7.43 rps 84.84 rpsA dc 4 pole lap wound generator is running at 1000 rpm having 1200 conductors and flux density is 10 mwb. find the generated emf * O 10 V O 200 V O 100 V O 20 VCalculate the phase voltages of a three phase star connected 4 pole small alternator having a total flux per pole 0.30 Wb. Each phase has a concentrated winding of 10 full pitched turns and the relative velocity between armature winding and field flux is 1500 rpm.