(a) Taking A = (6.00 î – 8.00 j) units, B = (-8,00 Î + 3.00 j) units, and C = (26.0 î + 19.0 ĵ) units, determine a and b such that a Ã + b B + T = 0. (b) A student has learned that a single equation cannot be Figure P22 solved to determine values for more than one unknown in it. How would you explain to him that both a and b can be determined from the single equation used in part (a)?

(a) Taking A = (6.00 î – 8.00 j) units, B = (-8,00 Î + 3.00 j) units, and C = (26.0 î + 19.0 ĵ) units, determine a and b such that a Ã + b B + T = 0. (b) A student has learned that a single equation cannot be Figure P22 solved to determine values for more than one unknown in it. How would you explain to him that both a and b can be determined from the single equation used in part (a)?

University Physics Volume 1

18th Edition

ISBN:9781938168277

Author:William Moebs, Samuel J. Ling, Jeff Sanny

Publisher:William Moebs, Samuel J. Ling, Jeff Sanny

Chapter1: Units And Measurement

Section: Chapter Questions

Problem 9CQ: Units and Standards What is the difference between a base unit and a derived unit? (b) What is the...

See similar textbooks

Similar questions

(a) A person's blood pressure is measured to be 1202 mm Hg. What is its percent uncertainty? (b) Assuming the same percent uncertainty, what is the uncertainty in a blood pressure measurement of 80 mm Hg?
The distance to the Sun is 93 miIlion miles. What is the distance to the Sun in the appropriate SI units?
Roughly how many heartbeats are there in a lifetime?
A sidewalk is to be constructed around a swimming pool that measures (10.0 0.1) m by (17.0 0.1) m. If the sidewalk is to measure (1.00 0.01) m wide by (9.0 0.1) cm thick, what volume of concrete is needed and what is the approximate uncertainty of this volume?
(a) How many significant figures are in the numbers 99 and 100? (b) If the uncertainty in each number is 1, what is the percent uncertainty in each? (c) Which is a more meaningful way to express the accuracy of these two numbers, significant figures or percent uncertainties?
Perform the following arithmetic operations, keeping the correct number of significant figures in your answer. a. The product 56.2 0.154 b. The sum 9.8 + 43.4 + 124 c. The quotient 81.340/
State how many significant figures are proper in the results of the following calculations: (a) (106.7)(98.2)/(46.210)(1.01) (b) (18.7)2 (c) (1.601019)(3712)
The first atomic bomb was detonated on July 16, 1945, at the Trinity test site about 200 mi south of Los Alamos. In 1947, the U.S. government declassified a film reel of the explosion. From this film reel, British physicist G.I. Taylor was able to determine the rate at which the radius of the fireball from the blast grew. Using dimensional analysis, he was then able to deduce the amount of energy released in the explosion, which was a closely guarded secret at the time. Because of this, Taylor did not publish his results until 1950. This problem challenges you to recreate this famous calculation. (a) Using keen physical insight developed from years of experience, Taylor decided the radius rof the fireball should depend only on time since the explosion, t, the density of the air, , and the energy of the initial explosion, E. Thus, he made the educated guess that r=kEabtcfor some dimensionless constant kand some unknown exponents a,b, and c. Given that [E]=ML2T-2 , determine the values of the exponents necessary to make this equation dimensionally consistent. (Hint: Notice the equation implies that k=rEabtcand that [k]=1 ). (b) By analyzing data from high-energy conventional explosives, Taylor found the formula he derived seemed to be valid as long as the constant khad the value 1.03. From the film reel, he was able to determine many values of rand the corresponding values of t. For example, he found that after 25.0 ms, the fireball had a radius of 130.0 m. Use these values, along with an average air density of 1.25kg/m3 , to calculate the initial energy release of the Trinity detonation in joules (J). (Hint: To get energy in joules, you need to make sure all the numbers you substitute in are expressed in terms of SI base units.) (c) The energy released in large explosions is often cited in units of “tons of TNT” (abbreviated “t TNT”), where 1 t TNT is about 4.2 GJ. Convert yow answer to (b) into kilotons of TNT (that is, kt TNT). Compare your answer with the quick-and-duty estimate of 10 kt TNT made by physicist Enrico Fermi shortly after witnessing the explosion from what was thought to be a safe distance. (Reportedly, Fermi made his estimate by dropping some shredded bits of paper right before the remnants of the shock wave hit him and looked to see how far they were carried by it.)
In SI units, speeds are measured in meters per second (m/s). But, depending on where you live, you’re probably mole comfortable of thinking of speeds in terms of either kilometers per hour (km/h) or miles per hour (mi/h). In this problem, you will see that 1 m/s is roughly 4 km/h or 2 mi/h, which is handy to use when developing your physical Intuition. More precisely, show that (a) 1.0m/s=3.6km/h and 1.0m/s=2.2mi/h .
Math Review (a) Solve the equation 7.20 103 m/s = (4.20 103 m/s) ln (Mi/Mf) for the fraction Mi/Mf. (b) If Mi = 2.65 104 kg, calculate Mf.
If the DNA strand in a molecule could be stretched out, it would have a length on the order of 2.0 m. What would this be in feet and inches?
A floating-point operation is a single arithmetic operation such as addition, subtraction, multiplication, division. (a) Estimate the maximum number of floating- point operations a human being could possibly perform in a lifetime. (b) How long would it take a supercomputer to perform that many floating-point operations?