A system is shown in Fig. Q2. Calculate the values of K and T for 2 seconds of peak time and 10% overshoot. R(s)< + Ke TH s+1 s(s+2) Fig. Q24 tete C(s)< 7

Q: While discussing the PCM, we learnt about the sampling frequency, number of voltage levels and the…

A: Given: The amplitude of the voltage signal Vmin=-15 V, Vmax=+15 V, Quantization level L=10, Find:…

Q: Q8/Chose the correct data input for 2-1 multiplexer that used to Design the switching network F F(A,…

A: SOLUTION  GIVEN--&gt;        F(A,B,C,D,E)=∑(0,1,3,5,8,9,12,15,17,21,24…

Q: A resistance of 8 ohms is connected in series with two resistances each of 12 ohms connected in…

A:

Q: 3. The power consumed by an electric appliance is computed as the square of the voltage across the…

A: Given: Power consumed by an electric appliance is computed as the square of the voltage across the…

Q: 1. Solve for the Laplace Transform of f(t) = 58(t) + 6e-4t - 7cos(5t).

A: Given: function f(t)=5δ(t)+6e-4t-7cos5t

Q: A parallel plate capacitor has an electrode area of 100 mm², with a spacing of 0.1mm between the…

A:

Q: Determine and sketch the output waveform in the following circuit below. HH 1uF +8V -8V t Si 5V www…

A: Given: Clamper circuit and square input waveform. To find: to determine the output and sketch the…

Q: PARALLEL CIRCUIT 9V R₁ R₂ R3 Given: R₁ = 95 R₂ = 12052 R₂ = 150.0 FR4

A:

Q: The cross-sectional area of a transformer limb is 80 cm2 and the volume of the transformer core is…

A: Given parameters are: The cross-sectional area of a transformer limb,Ac=80cm2=80×10-4m2 The volume…

Q: if R1 = 4.0 KQ, R2 = kQ 1.0 KQ then ID1 is: +5.0V IDI R₁ ID2

A: Given Two doides one is connected to ground and other is connected to -5v source. Let us first…

Q: 12 V Μ 4Ω Μ + 6Ω να * 2% 4V 1+

A: As per the question, we have to find the value of vo and i To solve the given problem, we will apply…

Q: Find the equivalent Excess -3 for the Decimal 814.

A: Given : 814 in decimal (814) 10 = (  ) xs3

Q: Two 10 uF capacitors have been connected in parallel across a 230 V 50 Hz AC supply. The current…

A: Given data, Two capacitors connected in parallel of each value C=10 μF Supply voltage V = 230 V…

Q: Give solution/explanation for letter i only. Answer Capacitive, 8.4883?F Subquestion/s  are given…

A: Since the solution of subpart i. is asked, so we are solving only this subpart. As the answers are…

Q: 3 V 1+ 1 V +- ix 10 Ω www + Vx

A:

Q: 1. When replace a relay control logic by a PLC the cost saving is C. Meduim D.High for Large power…

A:

Q: 41 Q3/ Fer the network shown in Figure (3), find the value of R₁ for maximum power to R₁, and…

A:

Q: Problem 1 • A sinusoidal source with frequency of 60 Hz and rms-voltage of 100 V is connected to an…

A: Given data, Resistance R= 10 Ω Inductance L= 10 μH=10×10-6 H

Q: A 50 Hz, 22 kV generator is corrected to a power system. The system inductance (L) and capacitance…

A:

Q: b. 50ΩΣ 14 Ω 30 Ω m 3ΩΣ 20 Ω b {2Ω 30 Ω w 27 Ω 12 Ω Μ {24 Ω

A:

Q: A 3-phase, 220 kV, 50 Hz transmission line consists of 1-2 cm radius conductors spaced 2 m at the…

A:

Q: A B 0 0 C O D D 8 U X

A:

Q: Determine the rated power output

A:

Q: The voltage across the 16-ohm resistor in the circuit is 80 V, positive at the upper terminal. a.…

A:

Q: find the current passing through the surface Z=1, 0<x<1, 0<Y<1 if H= (y^2*x) ax-(3*z^3*y) az

A:

Q: A concentric cable has a core diameter of 10 mm. The inductance of the cable is 4 × 10−7 H/m.…

A: As per the question, it is given that Diameter of core = 10 mm Inductance of the cable (L) = 4 ×…

Q: 1-28. Calculate Vo and the current through each resistor. Assume that the forward bias diode voltage…

A:

Q: A three-phase, three-wire Y-Y system a balance load. The following information are given of the…

A:

Q: Determine, in polar and rectangular forms, the current flowing in an inductor of negligible…

A:

Q: vi R₁ = 10 kQ Vcc=+4V Ig= 0.4 mA Rc VEE -4V Cc HF CE Cwi Cwo Ovo R₁ = = = 8 pF 10 pF = 20 kQ2 Figure…

A: Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: Consider the linear dynamics. Let B₁ = A = SO 1-2 O O O 1-4 A For S=1 in A x= Ax+Bu where x EIR c)…

A: “Since you have posted a question with multiple sub-parts, we will solve first three subparts for…

Q: A 3-phase, star connected 400-V synchronous motor takes a power input of 5472 watts at rated…

A: We have a 3-phase star connected synchronous motor which takes 5472 W at rated voltage. Synchronous…

Q: 1 +RV S I ref ↓ 3RT 2 57 KVL → 12V - Vas, - Rix Tref - Vas₂ = 0 1

A:

Q: Example: Calculate the Reg for the following circuit. Rea ΖΩ www 1Ω www Μ 3 Ω 60 4Ω 4Ω 3 Ω 5Ω

A: This is a basic problem of circuit. The solution is given in the next step

Q: 5. Determine the Thevenin's equivalent circuit across points A and B by disconnecting the RL. Find…

A:

Q: Q4. (i) A charge Q is uniformly distributed throughout a sphere of radius 2 cm. a. What is the…

A:

Q: Q- The characteristic equation of a control system is- S5+15s4 +85s3 +225s2 + 274s + 120 =0. What…

A: Given data- Characteristics equation- s5+15s4+85s3+225s2+274s+120=0. To Find- The no. of roots of…

Q: Q2/ The system given below has input x() and output y00. Determine whether of this is (i)…

A: Given  Y(t)is  x(t)sin(t+1)+cos(t-1)

Q: For an LTI discrete time system with the following impulse response h (n)= 8 (n-1)-28 (n-3) + 8(n-5)…

A:

Q: 4. Solve for the inverse Laplace Transform of 5³ +2s +6 s(s+ 1)² (s + 3) G(s) = =

A:

Q: loe v(t) 10 m 10 - 24 0./f ZA find Volt) in the circuit as shown in below with inital value Vo(o) =…

A:

Q: A pure element is connected across an AC signal. CH1 and CH2 measures the voltage and current…

A: Given a oscilloscope plot with divisions information Asked to find the following Impedance of load…

Q: A 3-phase, 60 Hz induction motor has 2 poles. If the slip is 2% at a certain load, determine  the…

A:

Q: (2) Find the final value of the function f(t), where: 2(s+1) F(s) = - s(s+3)(s+5)²

A: Given: Transfer function, Fs=2s+1ss+3s+52.

Q: 4. Find the current through 6-ohm resistor. E 12 V V1 R1 10 + A 3A R2 ww 60 B 4V1

A: We need to find out current through 6 ohms for given circuit

Q: A pure element is connected across an AC signal. CH1 and CH2 measures the voltage and current…

A: “Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: #2 Vitt) 13TAC पणकर हे 4AF HI th 110k2 F + 4MF (+) Vo(t) fat noson Solve for Transfer function. G(s)…

A:

Q: e W 553 f 1552 25V IB ISV ww-f IA 102 19-2 5J d J lov g wurst SOV 1622 Ic 15-2 30 C W 1052 h

A:

Q: For the given circuit, calculate the following: a) Ic b) IB c) IE d) Vc e) VCB f) VBE VBB=5 Vo RB…

A: Given, Gain β=99 Supply voltage VCC=12V, VBB=5V. Collector resistance RC=2KΩ, Base resistance…

Q: a) Find the equivalent resistance. b) Find the current supplied by the battery V = 24 V R₁ = 10 W R₂…

A: Given data, Resistances,  R1=10 ΩR2=6 ΩR3=4 Ω Voltage V=24 V

Speed control of motor

Speed control by DC motor-speed controller is required to realize variable speed drive. Whenever a motor drives a particular load, it is called drive, and variable speed drive refers to a load requiring variable speed. All this is obtained by a DC motor speed controller.