A submarine can be approximated as a cylinder of length 90.0 m and radius 14.0 m. If the submarine is fully submerged in seawater of specific gravity 1.020 what is the buoyancy force on the submarine? Your Answer: Answer units

A submarine can be approximated as a cylinder of length 90.0 m and radius 14.0 m. If the submarine is fully submerged in seawater of specific gravity 1.020 what is the buoyancy force on the submarine? Your Answer: Answer units

Name: A submarine can be approximated as a cylinder of length 90.0 m and ra
Uploaded: 2024-03-20T06:51:10.000Z
Channel: Bartleby
Description: A submarine can be approximated as a cylinder of length 90.0 m and radius 14.0 m. Ifthe submarine is fully submerged in seawater of specific gravity 1.020 what is thebuoyancy force on the submarine?Your Answer:8TabNeysCaps LockAnswerType here to sea

University Physics Volume 1

18th Edition

ISBN:9781938168277

Author:William Moebs, Samuel J. Ling, Jeff Sanny

Publisher:William Moebs, Samuel J. Ling, Jeff Sanny

Chapter14: Fluid Mechanics

Section: Chapter Questions

Problem 122CP: A submarine is stranded on the bottom of the ocean with its hatch 25.0 m below surface. Calculate...

See similar textbooks

Similar questions

Considering the magnitude of typical arterial blood pressures, why are mercury rather than water manometers used for these measurements?
In an immersion measurement of a woman's density, she is found to have a mass of 62.0 kg in air an apparent mass of 0.0850 kg completely submerged with lungs empty. (a) What of water does she displace? (b) What is her volume? (c) Calculate her density. (d) If her lung capacity is 1.7S L, is she able to that without treading water with her lungs filled air?
A submarine is stranded on the bottom of the ocean with its hatch 25.0 m below surface. Calculate force needed to open the hatch from the inside, given it is circular and 0.450 m in diameter. Air pressure inside the submarine is 1.00 atm.
The average human has a density of 945 kg/m3 after in haling and 1 020 kg/m3 after exhaling. (a) Without making any swimming movements, what percentage of the human body would be above the surface in the Dead Sea (a body of water with a density of about 1 230 kg/m3) in each of these cases? (b) Given that bone and muscle are denser than fat, what physical characteristics differentiate sinkers (those who tend to sink in water) from floaters (those who readily float)?
Look back to figure 14.29. Answer the following two question. Why is poless than atmospheric? Why is pogreater than pi?
Scurrilous con artists have been known to represent gold-plated tungsten ingots as pure gold and sell them at prices much below gold value but high above the cost of tungsten. With what accuracy must you be able to measure the mass of such an ingot in and out of water to tell that it is almost pure tungsten rather than pure gold?
If a person's body has a density of 995 kg/m3, what fraction of the body will be submerged when floating gently in (a) freshwater? (b) In salt water with a density of 1027 kg/m3?
A large tanker truck can carry 20 tons (40.000 lb) of liquid (a) What volume of water can it carry? (b) What volume of gasoline can it carry?
Why is it difficult to swim under water in the Great Salt Lake?
How do gases differ from liquids?
Concrete is pumped from a cement mixer to the place it is being lad, instead of being carried wheelbarrows. The flow rate is 200 L/min through a 50.0-m-long, 8.00-cm-diameter hose, and he pressure it the pump is 8.00106 N/m2. (a) Calculate the resistance of the hose. (b) What is the viscosity of the concrete, assuming the flow is laminar? (c) How much power is being supplied, assuming the point of use is at the same level as the pump? You may neglect the power supplied to increase be concrete's velocity.
An airtight dispenser for drinking water is 25 cm × 10 cm in horizontal dimensions and 20 cm tall. It has a tap of negligible volume that opens at the level of the bottom of the dispenser. Initially, it contains Water to a level 3.0 cm from the top and air at the ambient pressure, 1.00 atm, from there to the top. When the tap is opened, water will flow out until the gauge pressure at the bottom of dispenser, and thus at the opening of the tap, is 0. What volume of water flows out? Assume the temperature is constant, the dispenser is perfectly rigid, and the water has a constant density of 1000 kg/m3.