A sinusoidal 50 Hz voltage of 200 V (rms) supplies the following three circuits which are in parallel: (a) a coil of inductance 0.03 H and resistance of 3 ohms, (b) a capacitor of 400 microFarad in series with a resistance of 100 ohms and (c) a coil of inductance 0.02 H and resistance 7 ohms in series with a 300 microFarad capacitor. Find the total current supplied?

Q: Consider the circuit diagram below, where: v1(t) = 12 cos(377t) v2(t) = 5 cos (377t) Use node analys...

A:

Q: Find the power in the 10 A source. Find the power dissipated by 20-ohm resistor. Find the po...

A: The given circuit diagram is shown below:

Q: If three Impedances each of (8-j 6) N are connected in mesh across a three-phase 400 V ac supply, th...

A:

Q: What is the funchion of eth able an input multiplexer chip 2 apply Vec connect ground To (2) To 3) T...

A: The solution is given below  The answer is option 3. To active the entire chip 

Q: Given the operation of sinusoids. 20 sin 400f + 10 cos(400f+ 60•) – 5 sin(4001 – 20º) C. Express you...

A: In this question,  Sinusoidal signals is given.  Find the Resultant in the exponential form?  And ti...

Q: 11)Refer to the diagram below and answer all parts of Question 11. R1 R2 R3 Vs Dz Di D2 D3

A: Zener diode: This diode is on in the reverse bias condition. The power capability of the zener is mo...

Q: 1.) Explain, in full detail, the principle of operation of an oscilloscope, i.e. how does a represen...

A: The oscilloscope is a very useful and versatile laboratory instrument used for the display, measurem...

Q: ELECTRICAL CIRCUIT: Solve the problem and show your complete solution. Three currents, i1, i2, İ3 me...

A: In this question we have given three currents meeting at any node...With the help of 3 currents we h...

Q: 1. Thevenin equivalent circuit. а D44 24V (+ Figure 1: a. Find VTH. b. Find Rth •

A:

Q: a lossless transmission line, determine the value of the input impedance given: = 25 +j72, Zo = 452,...

A:

Q: An ammeter has a PMMC instrument with a coil resistance of Rm- 99 Q and FSD current of 0.1 mA, shunt...

A: For PMMC ammeter the current through coil resistance is given and the value of both coil resistance ...

Q: Find the power dissipated by 1-ohm resistor. Find the power in 6 V source.  Find the current throu...

A:

Q: Problem Statement: You design a circuit of a decade counter that will count from 0-9 only. You will ...

A: A decade counter, as opposed to a binary counter, counts in decimal digits. Each (that is, it may co...

Q: 7. Which of the following statements is FALSE for convolution? a. o(t) * [y(t)z(t)] = (x(t) * y(t)]z...

A:

Q: 20. Which of the following cannot be the Fourier series expansi a periodic signa a. all of these can...

A: Fourier series is only for periodic signals 

Q: ks Determine whether the LTI system characterized by Question 2. (a) ( the following impulse respons...

A:

Q: a. If known x(n) =a^n u(n), then the correct Z transformation for x(n) is = B. If known x(n) = u(n),...

A: Z transform of x(n) is  X(z) = summation of (x(n)* Z^n). Using above definition find a transform of ...

Q: Three infinite uniform sheets of charge are located in free space as follows: -7 nC

A:

Q: I2> や、 Is Res"

A:

Q: 6. Design a NAND Gate digital circuit using an AND gate and an inverte Describe the operation of the...

A: Explanation is given in following steps

Q: A point charge Q1 = 46 nC is located at P1(1,-4, -5) while a charge Q2= 31 nC is located at P2(9, -5...

A: In this question, A point charge Q1 = 46 nC is located at P1(1,-4, -5) while a charge Q2= 31 nC is l...

Q: 21. For a lossless transmission line, determine the value of the input impedance given: ZL = 25 +j72...

A: Dear,as per company guidelines we can answer only one question at a time, kindly post other question...

Q: In transformer, is defined as the change in the A7 secondary terminal voltage from no-load to full-l...

A: in transformer, ..... is defined as the change in secondary terminal voltage from no load to full lo...

Q: You have the transient response of a closed-loop system as shown in the figure, the entry being a un...

A: “Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts f...

Q: A coil is in series with a 20 µF capacitor across a 230-V , 50-Hz supply. The current taken by the c...

A: In this question,  We need to calculate the value of inductance of the coil if power factor is laggi...

Q: Find the value of capacitance which when placed in parallel with a coil of resistance 22 ohms and in...

A:

Q: For the amplifier below calculate the voltage gain (Av) if R1 = 3.3 kN and Rf = 5.6 kN? Rf +Vc R1 Vi...

A:

Q: A: periodic and power B: nonperiodic and power C: nonperiodic and energy D: none of these E: periodi...

A: It is decaying sinusoidal signal Decaying is done because of negative exponential

Q: Q1. (b) A single-phase, 120 V, 60 Hz universal motor is operating at 1800 rpm and its armature curre...

A:

Q: the magnitude of the force between a 10 mC charge at ( 2, 4, -1) and a 15 mC charge which lies on th...

A: We need to find out location of charge particle for given force .

Q: R1 3002 V1 |120Vrms C1 60HZ 8.84uF 0°

A:

Q: Question 5. A signal has a double-sided magnitude and phase spectra shown below The Magnitude Spectr...

A: We need to find out time domain expression of given Fourier transform and we need to find average va...

Q: e diffusion coefficient (including units) for:

A: We know. Semiconductor- The materials which are not very conductive as conductor but not very poor c...

Q: a plane charge of -8 milliC/m2 lies on  y = 12, determine the electric flux density D at G(-2, 7, 9)...

A: We need to find out flux density for given surface charge density.

Q: 29. The complex exponential Fourier series coefficient, c1, fcor periodic signal a(t) = 1+e/2 cos(at...

A:

Q: A 400-amp circuit breaker protects a feeder that's installed in a nonmetallic raceway that requires ...

A: Circuit Breaker- It is used as switch which works as a safety device for the circuit and circuit ele...

Q: The load on a 250 V supply system is: 12 A at 0.8 power factor lagging; 10 A at 0.5 power factor lag...

A:

Q: 1.2K 22K 100K 12V 100K 10K 18K 9V o- 12K 2.2K 47K 33K 1.5K -5V

A:

Q: If the stator flux density (Bs) of a machine is 0.5490°T and the rotor flux density (Br) is 0.34-80°...

A:

Q: Ex. (22) For the circuit shown below R R i(t) switch v.]= V(t) Find 1- The charge of the capacitor a...

A:

Q: 1. See example 4.2 on page 112. For silicon at 300 K, calculate the clectron concentration, no for t...

A:

Q: has an impulse response given by h[n] = {3,2, 1}. a. none of these b yln] = {3,-2, 1} c. y[n] = {3,8...

A:

Q: At a location in europe it is necesary to supply 300kw of 60hz power. The any Power sources avaiable...

A:

Q: Measure the current flowing in the circuit and the voltage drop across the voltage source. find the ...

A: Circuit diagram is given as,

Q: three phase converter has a rating of 600 kW when operating at unity power factor. Neglecting any ch...

A: We need to find rating at given power factor

Q: DEGREE: ELECTRICAL ENGINEERING  SUBJECT/COURSE: AC MACHINES   NOTE: Please solve in this way.  1. Pl...

A: Power factor: It tells how much true power is used from the apparent power.

Q: 22. Let z(t) and y(t) with Fourier transforma X) and Y) respective below then Y (w) is a. ) x- C. X:...

A:

Q: (b) Appraise the pre and post power factor correction effect of using the capacitor bank to correct ...

A:

Q: Design the following function G using only transmission gates G(A,B, C, D,E,F) = ABED + ABCD + ĀCDF ...

A: We need to design the following function G using only transmission gates. G(A,B,C,D,E,F)=AB¯ED¯+ABC¯...

Q: How do I tell the difference between single pole and 3-way switches? Is it through marks indicating ...

A: In a single-pole switch, there are two wires connected or separated by the switch mechanism. there i...

Single Phase Induction Motor

The single-phase induction motor or engine consists of a single rotating phase in the stator and a rotating cage in the rotor. When phase one supply is connected to the stator winding, a magnetic field is generated. In the pulsating field, the rotor does not rotate due to inertia. So, a single-phase import motor does not start and requires some initial methods.