a) Peak voltage, (b) Peak-peak voltage, (c) root mean square voltage, (d) period and frequency, (d) trigonometric equation and (e) value of voltage at t = 0.015 s.

Q: Q2) Design a CT-FWR to supply a load of (502) with a waveform of the following specifications: - •…

A: In this question we will find FWR parameters... Note:- due to bartleby policy , I will answer 3…

Q: Electronics Circuit: BJT biasing A fixed bias NPN BJT (Beta = 90) circuit is connected to a 16VDC…

A:

Q: The output signal given above is taken from a circuit with the frequency of the input signal 100 Hz,…

A: Given data C=4 microfarad ripple factor RF =1.21 f=100 Hz diode voltage drop is neglected

Q: A step down one-quadrant topology DC-DC converter is driving a DC motor with constant current of…

A: DC-DC converter will transfer the DC power from one circuit to another circuit at the required…

Q: 1. For a sinusoidal voltage trace displayed by the CRO, the time/cm switch is on 500µs/cm and the…

A: Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the question and…

Q: Q2) A 3-phase, half-wave thyristor converter is connected through a voltage source 150 V as input…

A:

Q: Q.7. Write a short note on active and passive components.

A: in case of VI( voltage current ) plane ,characteristics of passive components offers only positive…

Q: a. Determine at time t by how much the oscillating charge is reduced to 50% of the initial charge?…

A:

Q: Diode Model: 1N5817 R = 10k Vi= sine (05 100) Given the parameters above, simulate the given circuit…

A: The Given circuit is The Given diode model is 1N5817 The Given parameters is R=10k, Vi=sine0  5  100…

Q: source. Let T=130 us and L=250 pH. Determine (a) the duty ratio D, (b) max and /min- (c) average…

A: Solution-

Q: Question 1: In the circuit shown below, the output (Vo = 10V Max.) Unipolar. The frequency of…

A:

Q: The following set up the circuit with the numbers below. system By finding the required Ckomp value…

A:

Q: What is the peak-to peak voltage of a 56VRMS ac voltage? Select one: a. 79 V b. 164 V c. 82 V d.…

A: An a.c circuit differs from a d.c circuit in many respects. First, in a d.c circuit we consider…

Q: 1) Explain how this circuit works 2) Draw the waveform at the output (Vrl) for a sinusoidal signal…

A: Transformer ratio =5:1 Input voltage = 120 V  ( We assume it as rms value as nothing mentioned about…

Q: Full-wave rectified sine wave circuit is used to measure the RMS value of a half square wave with…

A:

Q: Determine percentage ripple and voltage drop of a six stage Cockcroft-Walton type voltage multiplier…

A:

Q: For a single phase (ac to ac) voltage controller, if the input supply voltage is (250Sin314t) with…

A: Peak Value of the supply voltage (Vm) = 250 V           Load resistance (R) = 5 Ω

Q: Solve

A: Referring to the given points, the power of the sine wave and square wave are equal:

Q: Calculate (d) Peak voltage (e) peak-to-peak voltage (O Time period for 3.53VRMS, 50HZ AC supply D3…

A:

Q: The output signal given above is taken from a circuit with the frequency of the input signal 100 Hz,…

A: Given data C=4 microfarad ripple factor RF =1.21 f=100 Hz diode voltage drop is neglected

Q: 4. Explain the operation of a full-wave voltage quadrupler circuit (With proper explanation,…

A: Full wave voltage quadrupler circuit:

Q: A phase modulator has kp= 2.8rad/V. What rms voltage of a sine wave causes a peak phase deviation of…

A: As per our guidelines we are supposed to answer only one question .Kindly repost other questions as…

Q: Determine the noise power for the figure shown below. Simulation Settings SNR > 31.623 SNR > 15.0…

A: Given: SNR=31.623 SNRdB=15 dBVsignal=1.35 Vf=0.2 kHz

Q: A PMMC meter rated at 50µA is used in a rectifier type of instrument which uses full wave…

A:

Q: A) what is the calculated Rin? B) Submit a plot for Vout as a function of Vin for varying Vin over 0…

A: As given in question , circuit diagram is On applying KCL at A ,…

Q: A half wave rectifier is given below as shown. The load is a resistive type of 25 Q. The source is…

A: Please submit part d&e as separate question. because according to our guideline we have to solve…

Q: Determine the zero-to-peak voltage, the peak- to-peak voltage, period and frequency of the waveform…

A: We need to find out amplitude and frequency and time period of given waveform

Q: Q4/ Find the voltage average and the voltage waveform for the output of the circuit shown below.…

A:

Q: i. the inductance value. ii. the peak-to-peak ripple in the inductor current if operating at the…

A:

Q: Draw the electrical model of a piezoelectric crystal. (ii) Over what portion of the reactance curve…

A: Piezoelectric crystal- A crystal or a material which acquires charge in it is known as piezoelectric…

Q: 1- For the values = 0.7 and @, = 2 find the rise time, peak time, settling time, and the maximum…

A:

Q: Q2) A 3-phase, half-wave thyristor converter is connected through a voltage source 150 V as input…

A:

Q: Assuming that the given function of voltage (in volts) is one period of a periodic waveform,…

A:

Q: 4. A motor of 160V, 60HZ has resistance and reactance of 120 and 0.40 respectively. Determine: a)…

A: Given, A motor of V=160 Vf=60 HzR=12 ΩXL=0.4 Ω

Q: What is the action of a capacitor in a Power Supply Circuit?*   a. To de-couple DC component of the…

A: In this question we need to choose a correct option.

Q: .Explain the working of any two wave energy conversion devices with diagram.

A: Ocean which contains the energy in the form of waves and also through the tidal currents both are…

Q: Exercise 1: Calculate the: (a) Peak voltage (b) Peak-to-peak voltage (c) Time period for 12VRMS 50Hz…

A: For sinusoidal signal,  Peak voltage = RMS voltage ×sqrt(2). Peak to peak voltage = 2×RMS voltage.…

Q: In a phase controlled full wave rectifier, the source voltage is 50 VRMS sinusoidal, the source…

A:

Q: An RLC circuit is connected across a variable frequency, 110-volt source. When the frequency is…

A: For RLC circuit V= 110 V , Here current ,I is given maximum as I= 5.6 A at frequency of 45 Hz which…

Q: Determine the output voltage for a bridge rectifier utilizing a transformer with a 110 Vrms primary…

A: In this question,  Determine the output voltage for a bridge rectifier?  a transformer with a 110…

Q: The voltmeter has an amplitude value rectifier, the scale is graduated to root mean square…

A: we need to find out the absolute and relative error.

Q: A half-wave rectifier circuit has an input voltage of 60V for the entire swing of the input signal…

A: Given  A half-wave rectifier circuit has an input voltage of 60V for the entire swing of the input…

Q: Q 4.12: The DC converter is used to control power flow from a DC voltage, V. = 110 V to a battery…

A: We are supposed to be answer of first question as per guildlines.

Q: Define the term temperature coefficient

A: Temperature coefficient:

Q: NOTE: Average of periodic signal f (x) of period T is given by: t0+T 1 f(x)(ave) = 7 f(x) dx T to D1…

A: The solution is given below

Q: 1. What is the average voltage and peak-to-peak voltage for a given voltage having an equation of…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Electrical Heating Unit

The conversion of electrical energy to heat energy is known as electric heating. The heating system that converts the electrical energy to heat energy for various application is called electrical heating unit. Electricity is employed as the firing mechanism in electric heating systems, which transforms electric current to heat. Electric heaters have heating elements in the form of electric resistors.