Answered: A particular wind turbine generator…

A particular wind turbine generator outputs 1500W of AC power at its peak performance. If the generator is rated for 95% efficiency, how many watts of wind energy are consumed?

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: Q2) A three-phase, full-wave full-controlled rectifier bridge circuit shown in fig(2) is operating…

A: As per the guidelines of Bartleby we supposed to answer first three subparts of the Question.…

Q: 1. The voltage u (t) = 12 cos (377t + 20°) V is applied to a 20-mH inductor, find the phasor…

A: In this question We need to determine the current in the phasor. We know current I = V/Z Inductive…

Q: Two generating units rated 250 MW and 400 MW have governor speed regulation of 6% and 6.4% resp.…

Q: A 1000 × 1000 bus admittance matrix for an electric power system has 8000 non-zero elements. The…

A: Given- 1000×1000 bus admittance matrix, 8000 non-zero elements, To Find- The minimum number of…

Q: A unity feedback system has the following G(s) 2 G(s) = 8+3 Use the LaPlace Transform to calculate…

A: Given , A unity feedback system has, Forward path transfer function, Gs=2s+3. Feedback transfer…

Q: 3 Apply Superposition to find current across 60 resistor. 84V 1252 652 352 21V

Q: A transmitter puts out a total power of 2.09 Watts of 30% AM signal. How much power is contained in…

A: Given- A transmitter- Total power=2.09 Watts of 30% AM signal, To Find- The power contained in each…

A: In this question We need to determine the power across the 10V voltage source and current source 7A.…

Q: 1.Modular structure of PLC. The controller cycle. Please answer for this theoritical question

A: We need to explain modular structure of PLC and the controller cycle.

Q: INDUCTION MACHINES PROBLEMS P1. Determine the number of poles, the slip, and the frequency of the…

A: Introduction Three-phase induction motor An induction motor is an AC electric motor in which the…

Q: 1. Find out whether the following vector fields are solenoidal or conservative in nature. a) F = b)…

A: For field to be solenoidal, divergence must be zero. For field to be conservative, curl must be…

Q: 84V 1252 ww 652 352 21V

Q: An inverting amplifier has an input resistance of 2 k. Determine the feedback resistance needed to…

A: Given data, An imverting amplifier has, Input resistance, R1=2 kΩ Voltage gain, Av=100

Q: . The reason that curves on roads are often banked is because a) the coefficient of static friction…

A: Answer: To find the reason that curves on roads are often banked

Q: he resistor. Complete parts A - I. R₁ m m R3 Vb R₂ M ww Rx

Q: 259 34 1 258 € 452 20V

Q: d'y Consider the open-loop system in Fig. 1(a) where closed-loop feedback control will be defined as…

Q: 2.8 For Fig. 2-30 a-d, find all equivalent resistances (Req): www • 2 ΚΩ ' 6 ΚΩ (a) :1kΩ Μ • 12 ΚΩ…

Q: Determine Io in the circuit below where R1=2 Ω, R2=2 Ω, R3=6 Ω, R4=9 Ω, and R5=16 Ω.

A: here we have to find the value of I0 .

Q: Calculate the inductance of the coaxial cable (Inductance per unit length) when the outer diameter…

A: Note: b= outer diametera=inner diameterL=μ02πlnba H/m

Q: ● What is the amplitude of the following sinusoidal voltage signal v(t) = 293 cos (374t + 250 ) V?

A: In this question We need to determine the amplitude of the following Sinusoidal voltage. We know…

Q: Using the Routh-Hurwitz criterion, find the value range of K to get a stable system having a…

A: Introduction Routh-Hurvitz Criterion: The Routh-Hurvitz Criterion is used to determine the stability…

Q: Problem B For the following circuit, find the energy stored between the mutually coupled inductors…

A: This is a question on coupled circuits and involves finding the energy stored in the magnetic mutual…

Q: The speed of a 4-pole induction motor is controlled by varying the supply frequency while…

A: Given- Frequency f=50 Hz, Voltage V=400 V, Speed N=1440 rpm, To Find- The speed at 30 Hz if load…

Q: Assuming ideal op amps, find the voltage gain. V₁/V; and input resistance for circuits a, b, c, and…

Q: An energy meter is designed to have 80 revolutions of the disc per unit of energy consumed. The…

A: Given- Meter constant, K = 80 rev/kWh Load carrying current, I = 30 A Voltage, V = 230 V Power…

Q: An alternator is supplying a load of 300 kW at 0.6 p.f. lagging. If the power factor is raised to…

Q: 1. Suppose the input signal x(t) and the impulse response h(t) of a continuous-time LTI system are…

A: “Since you have posted multiple questions, we will provide the solution only to the first question…

Q: 1) 100 /53.1° 2) 313 4

Q: Problem 4: The circuit below is a common configuration that can be used to determine the value of a…

Q: 13) Find the per unit diagram. G: 90MVA,22KV X-18% T₁: 50MVA,22/220KV T2:40MVA,220/11KV…

Q: Referring to a circuit shown in Figure Q.2(a) and using nodal nalysis i. Determine the nodes…

Q: 2.6 For Fig. 2-28a-c, find Req at the terminals: Fig. 2-28 (a) · 1kΩ • 12ΚΩ 30ΚΩ 100 Ω 50 Ω Μ SW A…

A: We need to find out equivalent resistance for given circuit .

Q: Please Must Show Given Questions in Design for 11KW Motor . A15 kW, 440 V, 4-pole, 50 Hz, 3-phase…

A: I have written this solution as handwritten solution. Hope you find your solution clearly.

Q: r(t) = 10 sin 20t + 7 cos 10xt

Q: Given: This circuit Find: R, XL,VS, Zcable are known. VLoad in terms of Vs, Zcable, and I The…

A: “Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: • If the voltage across a 24 F capacitor is 29 t e-3t V, calculate the power at t = 15 ms.

A: Note: As per Bartleby guidelines we are supposed to answer only 1st question when separate…

Q: x1 x2 x3 = - = H = f1 f2

Q: Exercise 10: A signal x(t) has the two-sided spectrum representation shown below. 57 43e-j/2 43e)*/2…

A: I have written this solution as handwritten solution. Hope you find your solution clearly.

Q: 2. In the following two-machine system, the voltages of sending and receiving ends are V₁ = 104/10°…

A: Two-machine system: To find active and reactive power?

Q: At t = 0, a charged capacitor with capacitance C = 500μF is connected in series to an inductor with…

A: Given data, Capacitor is given C=500 μF. Inductance L=200 mH. Rate of change of current didt=20 A/s.

Q: 1.3 If determine: (a) A 2B + C (b) C-4(A + B) 2A- 3B C (c) A = 2a, + a, - 3a₂ B = a, - a₂ C = 3a, +…

A: This question requires basic knowledge of vector algebra and primary deals with three vectors A, B…

Q: Find the power factor of a circuit that absorbs 1.5 kW for an input voltage and current of 230 V…

A: pf (1ϕ )=P1ϕVphase×Ipf (3ϕ )=P3ϕ3×Vline×I

Q: 1.4 If the position vectors of points T and S are 3a, 2a, + a, and 4a, + 6a, + 2a,, re- spectively,…

Q: *2.15 Determine I, in the circuit of Fig. P2.15. 12 V + www 502 2523 Ix Figure P2.15: Circuit for…

A: Given circuit, To determine current Ix.

Q: 1.15 Points P₁(1, 2, 3), P₂(-5, 2, 0), and P3(2, 7, -3) form a triangle in space. Calculate the area…

Q: 5. For the circuit below, the switch is moved from position 1 to position 2 at t=0, (and remains…

Q: 4. Draw the circuit structure of a TCR. By changing the firing angle of thyristors, how can we…

Q: How do we solve for the currents through the resistors in this problem (assuming we know the values…

Q: 4. Suppose we have a linear, time-invariant discrete-time system with an unknown impulse response…

Question

A particular wind turbine generator outputs 1500W of AC power at
its peak performance. If the generator is rated for 95% efficiency,
how many watts of wind energy are consumed?
002
F3
$
4
R
000
900
F4
%
5
T
F5
6
MacBook Pro
F6
Y
&
7
AA
F7
A
* 00
I
8
DII
F8
(
9
F9
O
F10

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Alternating Current (AC) Series Motor and Universal Motor

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Draw and explain a typical power curve for a wind turbine and write the definition of the four important terms that are shown in the power curve
Identify the main components of a wind turbine and explain three of them and their functions
a) A sinewave is having a frequency of 50 Hz and instantaneous value of 150 Volts at 1.2 milli seconds. Find i) The maximum value of sinusoidal voltage waveform and i) The value of voltage at 1.7 milli seconds. b) Determine the instantaneous equation for the voltage waveform shown in figure, if Vp=100 Volts, Time period is 5 milli seconds and 0 =50 degrees. Vp i= 0 Upload your Answers steps in the "Final Answer Submission" Link provided in the Moodle. a) (i) Maximum value = a) (ii) Value of voltage at 1.7 ms b) Angular frequency %3D
a) A sinewave is having a frequency of 100 Hz and instantaneous value of 150 Volts at 1.4 milli seconds. Find i) The maximum value of sinusoidal voltage waveform and ii) The value of voltage at 1.7 milli seconds. b) Determine the instantaneous equation for the voltage waveform shown in figure, if Vp=200 Volts, Time period is 5 milli seconds and 0 =40 degrees. Vp t = 0 Upload your Answers steps in the "Final Answer Submission" Link provided in the Moodle. a) (i) Maximum value = a) (ii) Value of voltage at 1.7 ms = b) Angular frequency =
Question: A 4 Pole DC Generator Is Wounded Lap. It Rotates At 500rpm To Be Able... A 4 pole DC generator is wounded lap. it rotates at 500rpm to be able to generate 150 V of open circuit voltage. What is the percentage decrease in the exixting flux per pole if a frequency of 10 rps can produce 120 V? %.
Write down construction of an alternator with help of diagram and write its principle of operation. Subject is Electrical Machines.
A four pole machines generates 250V when operated at 1500 rpm. If the flux per pole is 1.85 x 106 maxwell, the number of armature slots is 45 and the armature winding has two parallel paths. If the speed of the generator is reduced to 1350 rpm, what would be the generated voltage. To what value of flux per pole should the excitation be adjusted if the generated voltage is to remain the same at 250V
Example 1: The stator of a 30, 2-poles machine has 18 slots and a double-layer winding. The coils are short-pitched by 7/9. Determine winding factor for first and 3rd and 5th harmonies. ans: kwi1 = 0.9598 * 0.9397 = 0.9019, kw3= 0.6667 * 0.5 = 0.3333, kws= 0.2176 * (-0.1736) = -0.0378
A basic one-loop dc generator is rotated at 60 rps. How many times each second does the dc output voltage peak (reach a maximum)?
The frequency of voltage generated in SG depends on: Select one:a. Number of polesb. number of poles and speed rotationc. Field currentd. Rotor speede.Number of poles, speed rotation and type of winding
A 6 pole DC wave wound generator has 28 armature conductors with flux per pole is 23 mWb and the e.m.f generated is 64 V, then the speed of the machine is O 99.38 rps O 0.63 rps O 33.13 rps O 6.34 rps The thermocouples are suitable for temperature measurement applications in the range of 200°C to over 2000°C. Select one: O True O False
a) A sinewave is having a frequency of 50 Hz and instantaneous value of 200 Volts at 1.5 milli seconds. Find i) The maximum value of sinusoidal voltage waveform and i) The value of voltage at 1.6 milli seconds.