A parallel circuit consists of two branches, in one of them there is a resistance of R=50 W, and in the other there is an unknown element. The applied voltage is VT=100 cos(1500t+45º) volts, while the total current is It=12sin(1500t+135º) amps. Find the unknown element and the value of its reactance

A parallel circuit consists of two branches, in one of them there is a resistance of R=50 W, and in the other there is an unknown element. The applied voltage is VT=100 cos(1500t+45º) volts, while the total current is It=12sin(1500t+135º) amps. Find the unknown element and the value of its reactance

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter29: Dc Generators

Section: Chapter Questions

Problem 1PA: You are working as an electrician in a large steel manufacturing plant, and you are in the process...

See similar textbooks

Similar questions

Lesson: Alternating Current System A series connection of a 30-ohm resistor and a 100-mH inductor is connected across 240-V, 60-Hz supply. What will be the resulting equation of the current?
In the circuit in Figure 2, the capacitor andThe circuit of resistance is defined as a load circuit.a) Find the average power dissipated by the load circuit?b) How much of the average power calculated in a) by the resistance in the load circuit and how muchspent by the capacitor? Interpreting the results obtained?c) In the circuit in Figure 2, with a resistance of 80 ohms 23?A coil of is connected in series. In this case,calculating transformer ratio () to optimize power delivery to the load? Obtainedinterpreting the result?d) Calculate the distributed load complex power and reactive power in the newly learned circuit?
An inductance of 2 henries and a resistancc of 20 ohms areconnected in series with an emfE volts. If the current is zerowhen t 0, find the current at the end of 0.01 sec if E = 100 volts.
A five-Ohm resistor is in series with a 0.001-Henry inductor and is supplied from a 10-V DC source. Solve for the current 2 milliseconds after the switch was turned on. a. 2.0000 Amperes b.1.9999 Amperes c.1.0001 Amperes d. 2.0001 Amperes
An inductance of L Henries and a resistance of 15 ohms are connected in series with EMF of 135 volts. If the current is initially zero, and is equal to 7 amperes after 3 seconds. Determine L and the current after 5 s.
Using superstition, find the value of i0 if voltage source at the left is 10, angle - 30 degrees V, and current source is 2, angle zero degrees. A total of three sources will be considered, separately. The 24 volt source is DC. When this source is acting alone, the capacitor will be open-circuited.
Answer the following. Use a detailed explanation. In clamping circuit, what is the value of the sum of the voltage output for the whole cycle? In DC power supply, what is the use of the first capacitor?
Inductive reactance, resistance, and impedance are all measured in ohms. What is the common characteristic that makes this possible?
How temperature effect conductivity? Explain with the help of following equation. m e'n7'
An inductance of L henrys and a resistance of 10 ohms are connected in series withvoltage of 100 Volts. If the current is initially zero, and is equal to 9 Amperes after 1second.a) Find L? and b) Find the current after 0.5 s.
Eлample (1) For the series-parallel arrangement shown in Figure below, find: a) The supply current. I ?. b) The current flowing through each resistor. c) The p.d. across each resistor. R3 2.50 40 Ri R4 RE I ? 200V
(b) Determine the voltage, və(f) in the circuit of Figure Q1(b). 30 2F 20 sint2t A 5H Figure Q1(b)