(a) Minimise the following logic function using the Karnaugh maps method: f(x, y, z) = x'y'z' + x'y + xyz' +
Q: Question 3. Answer the below questions for the given combinational circuit W3 DawI W2 Dow W1 f y W4 ...
A:
Q: The input x(t) and the corresponding output y(t) of a linear, time-invariant system are shown as fol...
A:
Q: 1. Simplify the following using basic laws of Boolean algebra: a) Y = ABC + ABC + ABC + ABC+ĀBC + AB...
A: Note: As per the guide lines of the bartleby we are supposed to solve 3 questions, when they are i...
Q: (b) Figure below shows a ring distributor with interconnector BD having resistance 0.04 Q. The suppl...
A:
Q: Vcc Ic 2.2 k2 RB + VCE = 7.2 V B IB = 20 µA %3D lg = 4 mA
A:
Q: 5. Given: R1 R2 1kQ 1kQ R3 V1 12V 1kQ R4 1kQ Find: Rt, It, Pt
A:
Q: "Determine the dc resistance in ohms of commercially available silicon diode at a forward current of...
A: Given: The voltage across a forward biased silicon diode is, V=0.7 V Forward current, I = 4 mA
Q: Two resistors, R1 = 100 Q and R2 = 200 Q are connected in parallel. If the current through R1 is 1 A...
A:
Q: 3. Given Vec=100V, R,=2002, B=100, VBB-5V, flip the switch to close, and Ic=0.4A, 1) Determine Ig. 2...
A:
Q: Determine the total charge transferred over the time interval of 0 < t< 9 seconds whet i(t) = (1/2) ...
A: This question belongs to circuit theory . It is based on the concept of relation between charge and ...
Q: 1) The true value of a current through a resistor is 10A Themeasurement finds a value of 9.95A, dete...
A: As per guidelines we are supposed to answer only first question when multiple questions are given. S...
Q: The maximum current that a 2W, 80 KOHM resistor can safely conduct is: uA
A:
Q: A single phase half wave rectifier is used to supply power to a load of impedance 12 from 230 V, 50 ...
A: We are authorized to answer three sub-parts at a time, since you have not mentioned which part you a...
Q: 4)Mark the correct statements: a) The frequency at the output of a half-wave rectifier circuit is 3...
A:
Q: A parallel circuit consisting of a resistor, an impedance coil, and a capacitor of negligible loss i...
A:
Q: +9V 2k RB IB Rc Ic + IE VBE RE 3k 343ko 333ko 323ko O 313ka
A: Given VCE = 3V and taking Beta as 79. Generally beta value can be 50 to 200 Now finding value of RB ...
Q: electrostatic force?
A: Given that q1=2.8μCq2=-6.2μC
Q: Find the shortest lengths for short circuited line of 75 to give the following input impedances: Z= ...
A:
Q: A capacitor with length L= 1 cm as shown i
A:
Q: A 4 pole dc shunt generator with a shunt field resistance of 100 ohm and an armature resistance of 1...
A: We have given;pole P=4shunt filed resistance=100Ωarmature resistance=1Ωz=378flux per pole ϕ=0.02wblo...
Q: A 15 V source is connected across a 12-0 resistor. How much energy is used in three sec'
A: In this question we will find energy used by resistance in given time....
Q: The fixed bias circuit shown in figure uses a silicon transistor with VBE = 0.7V. Find the VCE. (if ...
A: This question belongs to analog electronics . It is based on the concept of fixed bias of BJT ( bipo...
Q: A 100-turn square coil of side 20.0 cm rotates about a vertical axis at 4.9 x103 rad/min as indicate...
A: Given a square coil, Number of turns, N = 100 Area, A=20 cm×20 cm=400 cm2=0.04 m2 Rotational speed,...
Q: 1) For the network shown in the below figure, the value of current needs to be measured in the 10002...
A:
Q: Question 3. Answer the below questions for the given combinational circuit W3 W1 W2 y W4 Figure 1. C...
A:
Q: Determine the DC bias values using DC equivalent circuits (in order of VE, VB, VC) * Vcc +10 V Re 4....
A:
Q: 3. Three particles of charge +70, +48, and -80 µC are placed in a line as shown below. Calculate the...
A: Electron-An electron is a fundamental particle, unlike protons and neutrons which are made up of par...
Q: e. Given Vcc=80V, R2=1602, B=100, VBB=6V. Flip the switch to close, nd Iz=0.002A, 1) Determine Rg- 2...
A:
Q: Define voltage regulation
A:
Q: Calculate the resistance of 1 km long cable composed of 38 stands of similar copper conductors, each...
A: Given that, length L=1 km=1000 m Number of strands = 38 diameter D=1.32 mm =0.00132 m change in len...
Q: In the circuit shown in the figure, the voltage vo(t) at t = 1 s is: 1H t=0 30 V U8 ww
A:
Q: The current entering the positive terminal of a device is i(t) = 3e-2" A and the voltage across the ...
A:
Q: Applying Superpositon What is the magnitude and direction of the current at Rx
A: The voltage across the element or current through the element is the algebraic sum of response of in...
Q: 4.39 In the circuit shown in the image below, if R1 = 26 Q, V1 = 43 V, and /4 = 6.0 A, determine the...
A:
Q: E = 20 V R1 3 Ω o E, = 15 V 12 R233 0 Va R4 R5 .6Ω R,.
A: The value of current I1 is given directly as: I1=20-153=1.67 A The value of current through R4 is gi...
Q: An optical intensity of 1 W/cm2 is incident on an intrinsic GaAs detector. The photon energy is 2 eV...
A: Given - Optical intensity = 1 W/cm2 Photon energy = 2 eV Absorption coefficient = 4+10^6 m^-1 ni = ...
Q: Assume, there was a daily cost of 10 cents/day per kW for the mitigation (repair) of the total envir...
A: Given that daily cost=10cent/day-kW
Q: 4.57.3 In the circuit shown in the image below, if Rx= 7.8 Q, R1 = 10.3 Q, and V1 57 V, determine th...
A:
Q: A 3-phase induction motor has a rotor resitance and standstill reactance of 0.1 ohm and 3.5 ohms per...
A:
Q: Determine the proper size of copper wire conductor necessary to apply a 750 W electric motor that is...
A: It is given that: P=750 WL=100 feetVpanel=120 voltsVdrop=1.2 volts
Q: .Implement the following logic equations using a single PLA. а. АВС b. АВ +АВС с. АВ + АВС d. AB + A...
A: We the to implement the logic equations in a single PLA
Q: Simplify the given Boolean functions (F) below, together with the don’t care conditions (d): 1. F(A...
A:
Q: Two conductors carrying 60 A and 75 A, respectively are placed 10 cm apart. Find the force between t...
A: We need to find out force between wire for given current
Q: 1.Given the information appearing beside. Choose from the given selection the correct answer. Solve...
A: In this question we will find value of collector current....
Q: A 200:5 current transformer is used in conjunction with 5 if the ammeter reads 1.02 find the actual ...
A:
Q: 10.Analyze the following sequential circuits (derive the state transition table and the state diagra...
A: The solution is given below
Q: I Design a CS amplifier using E-MOSFET with voltage gain 6 , VGs=6V (gm-4500uS). Il-(a) State the fu...
A: “Since you have asked multiple questions, we will solve the first question for you. If you want any ...
Q: Compute the frequency response H¿(jw) = Vo/Is 2mH ll Is s (1) 1KN 4KN; v. 1ΚΩ
A: The solution is given below
Q: Find the current that flows through the filament of a 400 watts flat iron connected to a 220 Volt po...
A:
Q: VDD RD C2 HE R1 Zo R2 Rs
A: Given circuit
part a
[plz provide hand written answer asap
Step by step
Solved in 2 steps with 2 images
- Design circuit that has an input w and an output z. The circuit is a sequence detector that produces z = 1 when the previous two values of w were 00 or 11; otherwise z = 0. Use W=0101100010101110101011100010 a) For this problem design the circuit using JK flipflops, draw the state diagram, true table, logic circuit.Consider the given logic equation below. Draw the logic diagram then simplify it using Boolean Algebra. Draw the logic diagram based on the simplified logic equation. X = A'BC' + A'B'C' + AB'C + AB'C' + A'B'C From the given logic diagram, trace the output using all possible input combination. Give it a conclusion upon completion..Design a logic circuit with four inputs and one output that will produce "l" in the output only if the input patterns have odd number of zeros. a) Write the Boolean equation for the circuit in the simplest SOP form. b) Draw the logic circuit for the above equation in its simplest form. c) Re Design the logic circuit using NANI) gates only?
- Design a combinational circuit with the four inputs A,B.C, and D, and three outputs X, Y, and Z. When the binary input is odd number, the binary output is one lesser than the input. When the binary input is even number the binary output is one greate than the input. Implement the function using multiplexers with minimal input and select line.A logic function is expressed by the equation = 0.1.8.9.4. Plot the the values on the K-map below Note: w is the msb (most significant bit) 3 x 10 0- - W X 1 00 01 Write the simplified Sum of Products (SOP) expression. Use yz WIM or "" for NOT; 11 10 for AND; "+" for OR (without the quotation marks.DIGITAL LOGIC DESIGN Are the following addition results Overflow or underflow and why?
- Consider two 8-bit inputs, A = $52 and B = $C3 to the arithmetic and logic unit (ALU). Compute R =A + B. Express R in the hexadecimal form $-- : -61 Express N-Z-V-C bits in the form ----:Q (A, B, C) = A̅ .B̅. C + A̅ .B. C + A .B. Obtain the function given as C̅ + A.B.C, simplified by the Karnaugh Map method, in terms of minterms and maxters separately. Set the output functions separately with logic gates with AND NOT for minterms and OR for maxima.USE DIGITAL LOGIC AND DESIGN Part 1: In Figure_4; we have 4-bit Comparator using 2-bit Comparators block. You have to satisfy given condition by applying all data on figure 4. At the end, given condition should produce HIGH output and other two should be LOW. A3 A2 A1 A0 = 1101 and B3 B2 B1 B0 = 1110 Figure_4 Part 2: The serial data-input waveform (Data in) and data-select inputs (S0 and S1) are shown in Figure_5. Determine the data-output waveforms from D0 through D3. Figure_5 Part 3: Decoder can be useful when we have to decode some specific numbers from their equivalent code. Figure 6 has a concept of 3 to 8 line decoder from which you have to generate output waveform from D0 to D7 with proper relationship to input. Figure_6 Part 4: The data-input and…
- Q6: For the following logic function: F(x,y,z) = xyz + xyz + xyz +xyz a. Draw the logic Circuit b. Construct the Truth Table c. Simplify the Logic CircuitSimplify the following expression using Karnaugh map and implement. Draw simplified logic diagram as well. Implement on Multisim software. (a) Y=A.B.C'.D+A.B'.C'.D+A'.B'.C'.D+A'.B.C'.D+A'.B'.C'.D'+A'.B.C'.D'+A'.B.C.D'+A'.B.C.D+A'.B'.C.DIH.W: Draw a logic eircuit of the following Boolean expression before and after simplification using karnough map and Boolean expression. Y-AB+ AB A B Y 1 1