A fluorescent lighting fixture has a compact ballast with a nameplate rating of 180w, 120 V. Determine the number of fixtures that can be connected to a two-wire circuit protected by 15A circuit breaker if the fixtures are used in an office building where they will be on for 8 hr continuously each day. Use the continuous-load multiplier 80%. a. 10 fixtures b. 24 fixtures c. 8 fixtures d. None of these e. 80 fixtures

A fluorescent lighting fixture has a compact ballast with a nameplate rating of 180w, 120 V. Determine the number of fixtures that can be connected to a two-wire circuit protected by 15A circuit breaker if the fixtures are used in an office building where they will be on for 8 hr continuously each day. Use the continuous-load multiplier 80%. a. 10 fixtures b. 24 fixtures c. 8 fixtures d. None of these e. 80 fixtures

EBK ELECTRICAL WIRING RESIDENTIAL

19th Edition

ISBN:9781337516549

Author:Simmons

Publisher:Simmons

Chapter33: Residential Utility-interactive Photovoltaic Systems

Section: Chapter Questions

Problem 6R: To size conductors and overcurrent devices for source circuits, you must multiply the module string...

See similar textbooks

Similar questions

please include the request below with the phasor diagram C ii) Construct the new phasor for E’ on the same diagram, using the same value for reactive volt drop.
(5) Primary AC Source Transformer Secondary AC/DC Full-wave Rectifier Capaictor in Non- linear Load Figure 6 Analyse different methods of harmonics mitigation to eliminate the harmonic, which you have identify in above power system circuit. You can use harmonic filters, K or equivalent transformers or oversized neutral method depending upon the harmonic sources.
If 3-phase transfomer configuration in figure in has the givens as listed below: E-line on high side = 480V, turns ration = 2:1/coil, resistance per load =10, efficienscy = 100%. E/coil on the high side is _____, E/coil on the low side is___, E-phase on the low side is____, E/resitor of the load is____,(a-480v, b-240v, c-120 d-69.28v) I/resitor on the load is____, I-line on the low side is___, I-phase on the low side is____, I/coil on the low side is____(a-2A b-4A c-6.93 d-12A), I-phase on the high side is____, I-line on the high side is____(a-1A b-1.73A c-2A d-4A), Va/phase of the load is____, 3-phase Va on the high side is____(a-120VA b-360VA c-480VA d-1440VA).
In Fixed-bias configuration, the DC voltage across the Source terminal is equal to ____. a.Vgs b.0V c.Vp d.Vds
Consider Two same size Parallel connected PV modules,each with the specification as Po=100W, Voc= 24.5V and Isc=5A.then choose the correct Statement Refer to this connection. a. The output power and voltage from this panel is Po=50W,Voc= 24.5V b. The output power and voltagefrom this panel is Po=200W,Voc= 24.5V c. The output power and voltage from this panel is Po=200W,Voc= 49.0V d. The output power and voltage from this panel is Po=100W,Voc= 24.5V
Most residential general lighting circuits are wired with 14-AWG copper conductors and are protected by 15-amp circuit breakers. However, there are many electricians who install 12-AWG copper conductors and protect them with 20-amp circuit breakers. How will you know which conductor size and which circuit breaker size will be used for the general lighting branch circuits in the house you are wiring?
Draw the circuit diagram of Two quadrant chopper which is having average load voltage might be positive or negative. Explain each quadrant operation with neat sketch. I want more than 350 words and I do not want it in handwriting
Which of the following statements is/are true? A In purely resistive circuit, the current lags voltage. (B In purely capacitive circuit, the voltage lags current. In purely resistive circuit, the current is in phase with voltage. D In purely inductive circuit, the current leads voltage.
A parallel connection of a RL branch with a C branch is connected across a 100V AC mains. At first R = 10 ohms, L = 20mH and frequency of 1000rad / s, the current measured is 2.2361A at 89.44 leading power factor. A) Determine the initial capacitance. B) However, a fault occurs on the capacitor branch making its capacitance 20% lower and a resistance of 5 ohms is detected. If this faulty circuit is rerun but at a frequency of 500 rad / s, determine the new current that will flow through the circuit.
WHAT IS THE POSSIBLE OBSERVATION AND CONCLUSION ABOUT SERIES–PARALLEL CIRCUIT AND DELTA WYE CONVERSION?
Using the rules for parallel circuits and Ohmslaw, solve for the missing values. ETE1E2E3E4ITl1I2l3l4RTR182kR275kR356kR462kPT3.436WP1P2P3P4
At what height are the telephone outlets in this residence mounted? Give measurement to center. _____