A communications system uses a superheterodyne receiver with an intermediate frequency of 10.7 MHz. Suppose the receiver is to receive a transmitted signal with a center frequency of 105.1 MHz. a) Determine the frequency of the local oscillator at the superheterodyne receiver. b) Find the center frequency of an image station that must be rejected by the tunable bandpass filter in the superheterodyne receiver.

A communications system uses a superheterodyne receiver with an intermediate frequency of 10.7 MHz. Suppose the receiver is to receive a transmitted signal with a center frequency of 105.1 MHz. a) Determine the frequency of the local oscillator at the superheterodyne receiver. b) Find the center frequency of an image station that must be rejected by the tunable bandpass filter in the superheterodyne receiver.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

For a superheterodyne receiver, the intermediate frequency is 15 MHz and the local oscillator frequency is 3.5 GHz. If the frequency of the received signal is greater than the local oscillator frequency, then the image frequency (in MHz) is........…...
Narrowband FM is a compromise between the minimal bandwidth of DSB-AM and the enhanced noise immunity of FM. i) Sketch a phasor diagram for a narrowband FM signal, and explain how is it different to a DSB-AM signal? ii) Calculate the bandwidth of a narrowband FM signal modulated by a message signal frequency of 12.5 kHz.
S Answer the two following questions: A. A sinusoidally modulated AM waveform is shown below: Determine: (a) Peak amplitude of the upper and lower side frequencies. (b) Peak amplitude of the unmodulated carrier. (c) The modulation index. (d) The transmission efficiency. (e) The amplitude of the carrier which must be added or subtracted to attain a modulation index of 0.5. 16V 8V- -8V. -16V-
(a) A signal at 900 MHz is mixed with a local oscillator signal at 1.0 GHz. What is the frequency of the VHF output signal? The unwanted output signal? (b) Repeat for a local oscillator signal of 0.8 GHz.
A 75 MHz carrier having an amplitude of 50 V is modulated by a 3 kHz audio signal that has an amplitude of 20 V. a. Sketch the audio signal. b. Sketch the carrier. c. Construct the modulated wave. For a, b and c - label your diagram d. Determine the modulation factor. e. What frequencies would show up in a spectrum analysis of the modulated wave? f. Write trigonometric equations for the carrier and the modulating waves. Kindly answer a-f. Please have mercy. Thanks!
D Page view A Read aloud (b) Find a PM modulated signal when k, = 10 (c) Determine the modulation index and maximum frequency deviation of FM modulated signal. (d) Determine the modulation index and maximum phase deviation of PM modulated signal. Problem 2: The message signal m(t) = 10 cos(2000nt) angle modulates the carrier signal c(t) = cos(2nfct), where f. = 10 kHz. %D (a) Find an FM modulated signal when k, = 200 (b) Find a PM modulated signal when k, = 10 (c) Determine the modulation index and maximum frequency deviation of FM modulated signal. (d) Determine the modulation index and maximum phase deviation of PM modulated signal.
4. Given FM modulator with the following parameters: Frequency deviation = 44 kHz Modulating signal, vm = 2 sin (2rókt) a) Determine the modulation index. b) Determine number of sets of significant side frequencies. c) Determine the bandwidth using both Bessel function and Carson's Rule. d) Sketch the output frequency spectrum for the Bessel approximation.
1) A 10-Vrms carrier signal with a frequency of 91.1 MHz is FM modulated by a 15 pts 8-Vrms, 4-KHz information signal that resulted to a deviation of 12 kHz. A) Determine the bandwidth using Carson's rule B) determine the bandwidth using Bessel Function C) determine the total power of the modulated wave
Explain through equations what happen if there is a phase error θc between the transmitted QPSK signal and local (replica) carrier signals in coherent QPSKdemodulator. Then what happen if θc=90o
1. Explain the difference between narrowband and wideband frequency modulation. 2. Briefly explain the process of indirect FM generation using a phase modulator.
Multiple Choice directions: Circle the letter of the answers that best answer the question. 29. In a klystron amplifier, velocity modulation is produced by:a. Buncher cavityb. Cathodec. Catcher cavityd. Collector30. At what position is the input signal inserted into a traveling wave tube?a. At the collector end of the helix b. At the collector c. At the control grid d. At the cathode end of the helix31. The main frequency determining element of a klystron is:a. Its mode of operation b. The accelerating voltagec. Its resonant cavityd. The repeller voltage Note: Explanation is not needed just provide the correct answers for each number.
Obtaining broadband FM signal from narrowband frequency modulated (FM) signal is shown below. The narrowband FM signal has a maximum frequency deviation of 100 Hz. The frequency of the local oscillator is f0=100 kHz. Obtaining broadband FM signal from narrowband frequency modulated (FM) signal is shown below. The narrowband FM signal has a maximum frequency deviation of 100 Hz. The frequency of the local oscillator is f0=100 kHz.Since the broadband FM signal has a carrier frequency of fc=80 MHz, find the N value.