A chemistry graduate student is given 100. ml. of a 0.10 M chlorous acid (HCIO,) solution. Chlorous acid is a weak acid with K,-1.1 x 10. What mass of KCIO, should the student dissolve in the HCIO, solution to turn it into a buffer with pH =1.96? You may assume that the volume of the solution doesn't change when the KCIO, is dissolved in it. Be sure your answer has a unit symbol, and round it to 2 significant digits.

A chemistry graduate student is given 100. ml. of a 0.10 M chlorous acid (HCIO,) solution. Chlorous acid is a weak acid with K,-1.1 x 10. What mass of KCIO, should the student dissolve in the HCIO, solution to turn it into a buffer with pH =1.96? You may assume that the volume of the solution doesn't change when the KCIO, is dissolved in it. Be sure your answer has a unit symbol, and round it to 2 significant digits.

Chemistry for Today: General, Organic, and Biochemistry

9th Edition

ISBN:9781305960060

Author:Spencer L. Seager, Michael R. Slabaugh, Maren S. Hansen

Publisher:Spencer L. Seager, Michael R. Slabaugh, Maren S. Hansen

Chapter9: Acids, Bases, And Salts

Section: Chapter Questions

Problem 9.90E

See similar textbooks

Similar questions

a.Calculate the pH of a buffer that is 0.1M in lactic acid, C2H4(OH)COOH, and 0.1M in sodium lactate, C2H4(OH)COONa. b.What is the pH of a buffer that is 1M in lactic acid and 1M in sodium lactate? c.What is the difference between the buffers described in parts a and b?
A buffer solution is prepared by adding 5.50 g of ammonium chloride and 0.0188 mol of ammonia to enough water to make 155 mL of solution. (a) What is the pH of the buffer? (b) If enough water is added to double the volume, what is the pH of the solution?
Each symbol in the box below represents a mole of a component in one liter of a buffer solution; represents the anion (X-), = the weak acid (HX), = H+, and =OH. Water molecules and the few H+ and OH- ions from the dissociation of HX and X- are not shown. The box contains 10 mol of a weak acid, , in a liter of solution. Show what happens upon (a) the addition of 2 mol of OH- (2 ). (b) the addition of 5 mol of OH- (5 ). (c) the addition of 10 mol of OH- (10 ). (d) the addition of 12 mol of OH- (12 ). Which addition (a)-(d) represents neutralization halfway to the equivalence point?
What is meant by the capacity of a buffer? Describe a buffer with low capacity and the same buffer with greater capacity.
Sketch the titration curve for a weak acid titrated by a strong base. When performing calculations concerning weak acidstrong base titrations, the general two-slep procedure is to solve a stoichiometry problem first, then to solve an equilibrium problem to determine the pH. What reaction takes place in the stoichiometry part of the problem? What is assumed about this reaction? At the various points in your titration curve, list the major species present after the strong base (NaOH, for example) reacts to completion with the weak acid, HA. What equilibrium problem would you solve at the various points in your titration curve to calculate the pH? Why is pH 7.0 at the equivalence point of a weak acid-strong base titration? Does the pH at the halfway point to equivalence have to be less than 7.0? What does the pH at the halfway point equal? Compare and contrast the titration curves for a strong acidstrong base titration and a weak acidstrong base titration.
Which of the following acids and its conjugate base would you use to make a buffer with a pH of 3.00? Explain your reasons: formic acid, lactic acid, nitrous acid.
A monoprotic organic acid that has a molar mass of 176.1 g/mol is synthesized. Unfortunately, the acid produced is not completely pure. In addition, it is not soluble in water. A chemist weighs a 1.8451-g sample of the impure acid and adds it to 100.0 mL of 0.1050 M NaOH. The acid is soluble in the NaOH solution and reacts to consume most of the NaOH. The amount of excess NaOH is determined by titration: It takes 3.28 mL of 0.0970 M HCl to neutralize the excess NaOH. What is the purity of the original acid, in percent?