A broadside array operating at 100 cm wavelength consists of 8 half-wave dipoles placed 50 cm apart. Each element carrier radiofrequency current in the same phase and of magnitude 0.5A . if the radiation resistance is 2000, then the radiated power will be A B C 200 w 100 w 400 w D 800 w

Q: 14. Determine whether the following system is controllable and observable CHE KHE y=[1

A:

Q: In the given circuit below, what will be the value of RThevenin (RTH) across terminals A & B? 492…

A: Given circuit,

Q: A three-phase system having an rms line voltage of 141.4V is connected to a delta balanced load with…

A: Given data, Line voltage VL=141.4 V Load impedance ZL=15∠300 Ω

Q: 4.2 For a step up d.c.-d.c. chopper with an input d.c. voltage of 220 volts, if the output voltage…

A: Given a step up DC-DC chopper with, Input DC voltage, Vs=220 volts Required output voltage, Vo=330 V…

Q: Determine the input and output impedances of the given amplifier. The op-amp datasheet gives: Zin =…

A: Calculation of input and output impedances of the given amplifier :where:Zin=2 MΩZout=75 ΩAol=200000…

Q: voltage is 0.7V the +ve and -ve peak of the output waveform is +10V Vin 0- -10 V n O +4.3, -4.3 O…

A: When two diodes are present in the circuit the probability of diode states are Both OFF Both ON…

Q: Q3: Find the current and power supplied by the battery to the given circuit. A 6 K www |= P =…

A: We need to find out current and power for given circuit

Q: For an op-amp circuit in Figure 2(a), prove that V, -(1+2)()(10v, +V₂) ST. 10R Figure 2(a)

A: given here a op amp based circuit and asked to prove the output.

Q: A LED which bright one color when forward and another color on reverse is called Dimensional LED O…

A: Answer:option-4  Multicolored LED.

Q: Write down the equation for 12 R₂ R₁ www I₁ 13 1/joc V₂ joLi -0000 jout 12 elle jwL2

A: In this question We need to write the equation for current I2   In this circuit,   Mutual inductance…

Q: The optoisolator couple a signal from its output couple a signal from its input couple a signal from…

A: For the above given circuit diagram we need to calculate the value of collector voltage.

Q: the secondary electrical current for the transformer shown in Figure with resultant flux in the core…

A:

Q: a. Consider a system described by the block diagram in Fig. 3. (i) Determine the system's transfer…

A:

Q: he logic function realized by the circuit below is X= テー DI T cont AK B 3-5 X

A:

Q: The circuit in Figure Q2 is operating in the sinusoidal st

A:

Q: Using the following characteristics, find the value of Ic if VBE = 0.75 V and VCE = 12,5V* (Satation…

A: We have,

Q: The line-to-line voltages in an unbalanced three-phase

A:

Q: In the given circuit below, what will be the value of current flowing through 2 ohm resistance? 202…

A: Given circuit,

Q: 2- نماز (0,625+ تعا) (1 - 3.753 - 2 - ) = (ساز)b) X)

A:

Q: For the circuit shown, ICQ value is * input ! C₁ 10μF O 3.02mA O 4.02mA O 2.02mA O 5.02mA Vcc=14V Ra…

A: We need to find out the collector current for given circuit

Q: SID & SOD pins are used w O Flag register О PC O Accumulator ALU O all other options are wro O…

A: In this question we will write about SID and SOD pins...

Q: The Fourier Transform

A:

Q: 5. Determine the mesh current i, and is in the following circuit. 2 Ω 12 V V www 4Ω 12 Ω 9 Ω www 12…

A: Given circuit,

Q: The capacitor in a clamper circuit is in parallel with the voltage source O None True False For the…

A:

Q: The H Parar is

A:

Q: distance traveled by the sound produced by the particle's vibration when it completes 30) is:

A:

Q: the steady state behaviour a control system, for different types of input, with the help. of static…

A: static error constant Kp=lims→0G(s) H(s)Kv=lim s→0 s G(s) H(s)Kv=lim s→0 s2G(s) H(s)

Q: نقطتان ( 6V * a The Thevenin resistance(Rth) in the circuit shown in the figure and external from…

A:

Q: (b) X (jw) = 2- نماز (-²-3.75 ju-1) (jw+0.625) Hand written plz only 'b' part

A:

Q: Calculate i(t) for 1>0 in the network of Fig. 16.51. using mesh 2e" w(1) V

A: Convert the circuit into s domain before applying mesh analysis. We have to use super mesh concept…

Q: The total inductance for the following three coupled coils is 13 10 12 O 11 m 7H 4 H 2 H m 8 H 5 H…

A: When current enter or exist at the same polarity Leq=L1+L2+2M When current enter or exist at the…

Q: The Final value of the voltage of capacitor for t>O is t = 0 50V 1 O 25V O 20V O 30V O 50V +1 1 + 2…

A:

Q: In the parallel connection of the following two port network, which of the following is correct I₂₁…

A: Note - as per guidelines we can solve one problem at a time , request you to please post remaining…

Q: b) Implement the logical function Y = AB (CD + ABC) using CMOS (Complementary Metal Oxide…

A: Implement the given logic function by using CMOS logic Family : Y=ABCD+A.B.C   CMOS logic circuit…

Q: +30V 15 ΚΩ www I₁ + VD Figure (a) + ID 25 ΚΩ ww 1₂ = 0.12 mA ID (MA) 2 m = 1.25 5 Figure (b) VD (V)…

A: For the above given electrical circuit we need to design it by calculating unknown values such as…

Q: In a two port network, when 12=0, V2=4 V, 11= 3 A and V1 = 3 V. C is equal to O 1.333 Siemens O 0.75…

A: We need to find out value of C for given parameters

Q: Why transient steady in electric circuits is important ?

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: Draw and design an operational amplifier circuit that has an input V₁, output V, and transfer…

A: Features of Op=amp High input impedance Low output impedance High CMRR High Gain....etc

Q: Adding a capacitor in parallel with the load in the rectifier will the ripple same increase reduce…

A: In this question,  We need to choose the correct option What is effect in ripple if capacitor is…

Q: Determine the inverse Laplace transform f

A:

Q: The convolution [u(t)- u(t-1)] Ⓒe-at 8(t)

A:

Q: m²/s, and 8(0)-105 cm³. The on [cm³] at x=75 um is....

A: Given Data: P-Type silicon Temp, T= 300K Na = 5 x 1016 cm-3 τn0 = 5 x 10-7 s Dn = 30 cm2 /s δn(0) =…

Q: QA 20 KW, 200 volts D.C shunt generator has armature resistance = 1 ohm and field resistance =50…

A: Types of DC Machine separately excited  Shunt DC Machine Series DC Machine cumulative long shunt…

Q: 29. Determine the rate of change of the output voltage of the circuit when a 2.5v step voltage is…

A: Given amplifier circuit, Where, Input voltage, Vin=2.5 V

Q: For the op-amp shown below: I₁ = → h₂= Vx=_ and Vo=

A:

Q: Q. What are the types of CMKs in AWS KMS?

A: It is asked about the types of CMKs in AWS KMS.

Q: The transient response of a circuit can be determined using the following methods O Differential…

A: The transient response of a circuit can be determined using the following methods...

Q: For the following circuit if the secondary voltage of the transformer is 20V max, the output voltage…

A: given here a electrical circuit and asked to find the output voltage.

Q: transformer with a nameplate rating of 30kVA, 4160/230V, 1 phase, 60hz, with p.u. impedance of…

A: Short circuit test is performed to calculate copper losses of transformer at rated load. Rated…

Q: Find: Ib, Ic, Vce, Vb, Vc, Vrb Vre, & Vrc Note: show your solutions no solution means wrong answers.…

A: For the given common emitter amplifier circuit we need to calculate all the DC parameters by using…

Antenna Characteristics

The antenna is an important concept in the domain of electronics and communication engineering. An antenna forms an integral part of many commonly used devices such as wireless modems, routers, game controllers, mobile phones, bluetooth devices, and so on. In simple terms, any wireless communication makes use of antennas to serve the purpose. An antenna, also known by the term 'arial', is an electrical device that converts electrical signals into electromagnetic waves or electromagnetic waves into electrical signals. An antenna contains a transmission line usually made up of co-axial cable, it then receives the signals and converts them into electromagnetic waves, which are then transmitted via space into their required destination. A communication system essentially makes use of two antennas, a transmission antenna, which converts electrical signals into electromagnetic waves, and a receiving antenna, which receives the electromagnetic waves and converts them back into electrical signals.