A 25.0-mL aliquot of an aqueous quinine solution was diluted to 50.0 mL and found to have an absorbance of 0.636 at 3.48 nm when measured in a 2.50-cm cell. A second 25.0 -mL aliquot was mixed with 10.00mL of a solution containing 23.1 ppm of quinine; after dilution to 50.0mL, This solution had an absobance of 0.903(2.50-cm cell). Calculate the concentration of quinine in parts per million in the sample.

Q: A 32.5% solution of MgSO4 at 120°F (48.9°C), without appreciable evaporation, to 70°F (21.1°C) in a ...

A:

Q: Q.5 Consider one such alloy that initially has a uniform carbon concentration of 1. 22 wt% and is to...

A: In this system the surface composition is constant. The diffusion in this system is non steady state...

Q: In a hot flame, the emission intensities of the sodium lines at 589.0 and 589.6 nm are greater in a ...

A: Flame emission spectrum is based on metallic elements emitting light if sufficient energy is provide...

Q: 4. For a capillary glass tube of 1 mm diameter, compute the rise of water above the water surface if...

A: Since there is no effect of oil on capillarity hence, rise of water is only due to surface tension o...

Q: tracer concentration as shown below. Calculate the mean residence time. 20 C (mol/m³) 10 20 t (min) ...

A:

Q: You are an engineer in a certain manufacturing plant. The plant manager suddenly gave you a task to ...

A: Given data: Change in entropy = 300 J/k Specific heat of water = 4.183 J/g.K T1 = 25 0C T2 = 80 0C

Q: a. Explain briefly the concept of colligative properties b. As you boil a relatively concentrated sa...

A: To  a. Briefly explain colligative properties b. As you boil a relatively concentrated saline (i.e. ...

Q: The diffusion coefficient DAB for the interdiffusion of two gases A and B may be estimated using the...

A: Given- Diffusivity of gas A in B is given by following relation Where, DAB = diffusivity of A in B...

Q: The ff. data was collected while performing an analysis for chloride using an ISE: Standards E, mV l...

A: Given data of E and log A Log A E, mV -0.53 95 -1.05 188 -1.54 295 -2.1 378 -2.59 483

Q: P23: Variation of activity coefficient of n-butanol with mole fraction in the the water (1) – n-buta...

A:

Q: 200 g of water (Cp = 4.183 J/kg-K) was heated at constant pressure as stated in the following proces...

A: Given Data Mass of water (g) = 200 g  The heat capacity of water (Cp) = 4.183 J/gK The process descr...

Q: Calculate the power to move a load of 850 tons/h of a granular material on a conveyor belt, 1 m wide...

A: Given data: Flow rate of granular load = 850 tons/h Width of conveyor belt = 1 m Length of conveyer ...

Q: Q4/ Answer (3 only): a. What are the effects of the presence for sulfur compounds in crude oil? b. E...

A: a) Sulfur is considered to be the biggest culprit to the environment because its presence in crude o...

Q: In a gas mixture there are 0.0083 lb mol of water vapor per lb mol of dry CH, at a temperature of 80...

A: The vapor pressure is obtained from steam tables for different temperatures. The total pressure is o...

Q: The pressure of an ideal mixture of o-xylene and m-xylene is 247.5 mmHg at 373 K. The mole fraction ...

A: This problem can be solved by using raoults law for ideal solution.

Q: The vapor pressure of a pure liquid A is 23 kPa at 20 °C and its Henry's law constant in liquid B is...

A:

Q: Explain the effect of Oxygen amount on fuel burning

A:

Q: Which anodes are better suitable for highly conductive environments such as seawater? Explain the re...

A: Aluminum anodes are extra active, guard higher and remaining longer than zinc anodes in saltwater (Z...

Q: 9. How many moles of gas is present if at 400K, its pressure is 1Mpa(1000kpa), and its volume is 5m3...

A: The general gas equation involves pressure, temperature, moles and volume. This is called as ideal g...

Q: Methane and oxygen react in the presence of a catalyst to form formaldehyde. In a parallel reaction ...

A: Given reactions are:   CH4 + O2→ HCHO + H2O CH4 + 2O2→ CO2 + 2H2O   Basis mol feed = 300 mol/s CH4=1...

Q: f(t) Select the correct response: es – s 1 s2 none of these e-s – 1 – s? s2 e-s + 1 1 s2 s3 e-8 – 1 ...

A: At first we will try to find the equation of the line 

Q: 2- Venturi scale The area of the fluid entry section in which 0.5 m 2, and the area of the choke sec...

A: Given that A1  = 0.5 m2A2  = 0.1 m2density = 0.9 g/cm3△P= 2 Pa

Q: A fuel composed entirely of methane (CH4) and nitrogen (N2) is burned with excess air. The flue gase...

A: Given that: Fuel contains, methane (CH4)  and nitrogen (N2) which burns with excess air. Basis fuel ...

Q: A simultaneous determination for cobalt and nickel can be based on absorption by their respective 8-...

A: Beer Lambert's law is a relationship between the physical properties of the solution and the absorba...

Q: From the proton NMR spectrum in Figure 19-44, deduce the structure of this hydrocarbon.

A: Proton NMR is proton nuclear magnetic resonance. This is used to determine the molecule structure. T...

Q: A conical flask with a porous stopper is used to cultivate broth containing 8.1 g of moist microorga...

A: The temperature is converted from Celsius to Kelvin. This system is diffusing A through non diffusin...

Q: Q3/ Estimate the Watson characterization factor K, molecular weight, Aniline point, carbon to hydrog...

A: Given data: Mean average boiling point = 99 0C API gravity = 52

Q: What is the “glass transition temperature” of a polymer? (a) How can it be measured? (b) What molecu...

A:

Q: Hanewenc! Vaper pressure these.ccondrtions to OF methy cholersde 60°C13.76 mokr volens equatons. ber...

A: Write the Redlich-Kwong equation as follows: P = RTVm-b - aTVmVm+b   .......1   Given, The temperatu...

Q: HoW Amnania gas (NH was in a tank at pressure 292-Pig valume 20.813 Temf-125F and You thin K thet 12...

A: Given Tank volume, V=120ft3 Pressure, P=292Psig Temperature T=125℉ m=125lb According to Boss Spec...

Q: A mixture of 96% ethyl alcohol + 4% water by weight creates an azeotropic mixture. It is not possibl...

A: Basis: 100 kg of pure alcohol produced Refer to the below diagram for the given information about th...

Q: (2s+1) 4. Write in partial fraction (s-1)(s+2)² form.

A:

Q: A flue gas analyzed to contain 80.0% nitrogen, 7.00% oxygen, and 13.0% carbon dioxide is sent to a d...

A: Given, Initial pressure, P1 = 95 kPa Initial temperature, T1 = 500 K Initial volume, V1 = 100 m3   F...

Q: The intensity of a line for atomic Li is much lower in a natural gas flame which operates at 1800.C,...

A: The vaporous unmistakable piece of fire is flame. This occurs in thin zone caused by a exothermic re...

Q: Calculate the saturation concentration of oxygen (0,) and carbon dioxide (CO,) in a freshwater lake ...

A: Daltons law is relation between partial pressure, mole fraction and total pressure. The concentratio...

Q: s+5 The initial value and final value of the unit step response for the transfer function 2s+8 are: ...

A:

Q: Solve for the Laplace transform of the function below: , 0<t< T f(t) lo, [0, Select the correct resp...

A: Given Function is Find The Laplace transform of given function

Q: Calculate the entropy change when 1.00 mol of water at 0°C freezes to form (ce./For water, A fusHo =...

A:

Q: Heat Transfer subject A nuclear reactor can be modelled as the plane wall shown in figure below. Th...

A:

Q: Employing the Kammerlingh Onnes equation of state, find the compressibility factors of CO at -500C a...

A: Given that  CO substance  T =-50 C  We have to find Z at different pressure 

Q: For diffusivity range of 0.05x10^(-4)<D_AB<1.0x10^(-4) m/s, the system is more likely to be a O A. G...

A: Given that :Diffusivity range is given we have to identify the system is more likely to be          ...

Q: At 1 atm and 0 ° C , the densities of water and ice are 1.00g / cm-3 and 0.924g / cm-3 , respectivel...

A: Given data: T1= 00C P1 = 1 atm Density of water = 1 g/cm3 Density of ice = 0.924 g/cm3 Latent heat o...

Q: The voltage between two points is 19 V. The required power to move 67 x10^16 electrons from one poin...

A: Since we are entitled to answer only 1 question, we will answer the first one as it is not mentioned...

Q: 3.24 How many kg of potassium nitrate will crystallize from 250 kg of a solution saturated at 60°C, ...

A: Disclaimer: Since you have asked multiple question, we will solve the first question for you. If you...

Q: Absorption of sulfur dioxide is carried out in a packed tower. Gas containing 14.8% of sulfur dioxid...

A: Concentration of the component is ratio of moles of that component and volume of the fluid. Volume i...

Q: A Calculate the theoretical (adiabatic) flame temperature for CO, bumed at constant pressure with 10...

A: given: CO+1/2O2→CO2 100% excess air is given ∑nCP,mix=R(∑niAi+(∑niBi)Tmix+∑niDiT1T2∆HP0=(∑niCP,mix)(...

Q: Bacterial cell mass is reported to have the following empirical formula: CsH;O2N. Determine the carb...

A: Given that: Empirical formula of bacterial cell mass = C5H7O2N Molecular mass of the cell= 113 g/mol...

Q: 2. A cylinder compresses helium (R=0.4968 Btu/lbm-R) isothermally from 14.7 psia and 68F and the com...

A: write the expression for the work done by the gas isothermally as follows: W = -RTlnV2V1    ......1 ...

Q: Calculate the Gibbs energy, entropy, and enthalpy of mixing when 0.50mol C6H14 (hexane) is mixed wit...

A: Given that, The number of moles of C6H14 n1 = 0.5 mol The number of moles of C7H16 n2 = 2 mol Temper...

Q: . An ideal solution of two homologous liquid alkane compounds have an overall vapor pressure of 550 ...

A: