A 2.9 kg lump of aluminum is heated to 96°C and then dropped into 10.0 kg of water at 5.2°C. Assuming that the lump-water system is thermally isolated, what is the system's equilibrium temperature? Assume the specific heats of water and aluminum are 4186 and 900 J/kg-K, respectively. Number Units the tolerance is +/-2%
Q: My teacher did not explain well, need help
A: Answer:- E field vector due to a charge at point A EA1 and EA2 are: ...
Q: A Square of side 's' has farticles of masses 3 m, Im m,2 2m at its Vertices. Show that the principal...
A: Given data, s - side of square 12m, m, 32m, 2m - masses at its vertices Let Moment of inertia be d...
Q: Are you relatively safe from lightning inside an automobile? Give two reasons.
A: The metal of the car acts as a medium to carry away lighting.
Q: Can u be fast please?
A: The situation is modelled below, here x represents the length of bar at which mass m in contact wit...
Q: of side "S" has A Square particles Im, m,3m 2. vextices Show that moment of inestia Squate ms², mass...
A: Since the four masses are located at the corners Ir=∑miri2 Since r is the distance from the center ...
Q: Analyze the DC circuit below. Find all circuit variables. Do not ignore the base current in any of t...
A: First, we need to find the voltage across RBB ...
Q: A sufficiently long platform of mass m rests on frictionless ground. A cy!inder of mass m and radius...
A: Here the frictional force will be responsible for a torque in the counterclockwise direction that wi...
Q: 4. Consider the two circuits below. Use your understanding of voltage, resistance, and current to an...
A: A) When the switches will be turned off, as a circuit will get completed and connected it will resul...
Q: 23. I| Three charges are at the cor- ners of an isosceles triangle as shown in Figure 17.45. The ±5....
A: Given: The Three charges are at the corners of an isosceles triangle having the values of +5.00 μC 2...
Q: Advanced Physics Question
A:
Q: A system has 2.00 µC charges at (50 cm, 0) and (−50 cm, 0) and a −1.00 µC charge at (0, 70 cm), with...
A: C
Q: The switch S has been open for a long time and is suddenly closed. Neither the battery nor the induc...
A: For a long time when the switch S is open, the current through all the resistors will be zero. No cu...
Q: (a) On a particular day, it takes 9.60×103 J of electric energy to start a truck’s engine. Calculate...
A:
Q: in of side s has particles of al A squase messer m m,im,2n at its vertices show inetia that at cente...
A: Given data, s is the side of the square 12m, m, 32m, 2m are the masses at the vertices of the squar...
Q: Unstable traffic flow occurs when drivers accelerate and break too often unstable traffic flows wast...
A: Given: Time(p.m) 4 4.10 4.20 4.30 4.40 4.50 5 speed(km/h) 30 20 50 70 20 70 20 What is mean ...
Q: An object starts at the origin (0,0). It moves for 3 seconds with a constant velocity of vo1 = 2£ + ...
A: Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the question and s...
Q: What is the energy (in Wh) of a wind blowing with speed 6 m/s in 2 hours in a 1m? cross- section are...
A: Given : Area = 1m2 ∆t = 2 hours Air density ρ = 1.225 kg/m3 ...
Q: (A) Show that the center of mass of a rod of mass M and length L lies midway between its ends, assum...
A: Lets assume a small element of mass, dmthickness dxand at a distance x from one endCentre of mass= ∫...
Q: A transverse wave is traveling left to right. Which of the following is correct about the motion of ...
A: In case of transverse wave, vibration of particles of the medium must be perpendicular to the direct...
Q: Take a square configuration of point charges, two positive and two negative, all of the same magnitu...
A: Solution: A figure is shown in an initial configuration as, Here, the two positive charges are repr...
Q: Write about the Goldman–Hodgkin–Katz flux equation
A: Introduction: The cell membrane, also known as the plasma membrane, is a double layer of lipids and ...
Q: Let fosces Fi- -itj , Fej, Fgz-21 -4s and F: 2i BlO-2) and C(B2) respectidy. Find. O Torque of axe a...
A: Here The torque due to all the forces about point O is to be evaluated. O being the origin (0,0). Th...
Q: Given that the distance between the center of the earth and the moon is D, if the mass of the earth ...
A:
Q: On planet Tehar, the free- fall acceleration is the same as that on the Earth, but there is also a s...
A: a) Given that gravitational acceleration is same as that of earth i.e. g=9.8m/s2. After having bee...
Q: by High Voltages
A: Given: The dielectric constant of of the solid specimen is k=4. Thickness of the internal void is d1...
Q: At time t = 0 s, a wheel is spinning at 84 rad/s counterclockwise. It begins accelerating countercl...
A: The formula to calculate the final angular speed of the wheel when it rotates counterclockwise is ω=...
Q: A particle is moving at a constant velocity in a circular orbit of radius R = 0.5 (m). As shown in t...
A: Given, Radius = 0.5m Angular velocity relative to point A, ωA=0.4 rad/s (anti-clock wise) Accordi...
Q: Find the average rate of change of the car's position on the interval [68,104]. Include units on you...
A: Velocity The velocity of an object is defined as the rate of change of displacement of an object wit...
Q: Find the electric flux through the plane surface shown in the figure below if 0
A: Given: Electric field E=384 N/C Distance d=4.85cm=0.0485m Angle θ=54.00
Q: The position of an object undergoing simple harmonic motion isgiven by x = A cos1Bt2. Explain the ph...
A: The position of an object undergoing simple harmonic motion is given by: x==AcosBt ............. (1)...
Q: A slightly deranged Arctic inventor surrounded by ice thinks it would be much less mechanically comp...
A: Given: 80% of the energy in 1 gal of gasoline is converted into waste heat The number of kilograms o...
Q: (a) What happens to IC if the supply voltage is low? (b) What voltage VCE would occur if the transis...
A: a) BJT is a high impedance device, if the voltage is low, there no current in base arm, since the co...
Q: An ultracentrifuge accelerates from rest to 9.97×10^5 rpm in 1.51 min. What is its angular accelerat...
A: Given information: The initial angular velocity, ωi=0 The final angular velocity, ωf=9.97×105 rpm=9....
Q: Two point charges lie on the x axis. A charge of +6.2 mC is at theorigin, and a charge of -9.5 mC is...
A: Part-a Given: The first charge q1 = 6.2 mC. The second charge q2 = -9.5 mC. The position of the fir...
Q: Tortilla chips are manufactured by submergingbaked and partially cooled masa at 41 °C into corn oil ...
A: Part-a The mass of the masa m = 0.454 kg. The temperature of the masa Ti = 41 oC. The temperature o...
Q: Three point charges are situated at the vertices of a rect- angle with a top-to-bottom length l righ...
A: To determine,The electric potential V at the unoccupied vertex.given,q1=q2=+3 nC=3×10-9 Cq3=-4C=-4×1...
Q: A 12,000-N car is raised using a hydraulic lift, which consists of a U-tube with arms of unequal are...
A: Given : Car weight = 12,000N Density ρ = 800 kg/m3 Wider arm radius...
Q: 4-
A:
Q: Sea breezes occur along coastlines, and consist of cool air moving toward the shore from the ocean. ...
A: Introduction: Heat is the form of energy transferred between two materials that are at different tem...
Q: You have a credit card with a balance of $7000and an APR of 15.99%. The minimum monthly payment is $...
A: Given: The balance amount P is given as $7000 APR (r) is 15.99% , i=15.991200 The monthly payment is...
Q: The data listed in the following table gives hourly measurements of heat flux q (W/m²) at the surfac...
A: The total heat absorbed h is given by, h=eab∫0tqAdteab=0.45 absorption coefficientA=4 m2 Area of th...
Q: I need the solution on the paper please
A: Given : m = 0.85kgM = 1.2 kgd = 5.6 cm = 0.056mω = 0.30rad/sec
Q: it is moving. The speed at which an object of mass M will have height h/3 Find the statement that gi...
A: Conservation of Mechanical Energy According to the law of conservation of mechanical energy, the tot...
Q: 8. A 0.450 kg mass oscillates at the end of a spring with a stiffness of k = 250 N/m. A. The damping...
A: According to question mass, m = 0.45kg spring constant, k =250N/m damping force, fd = -av where a ...
Q: Each propeller of the twin-screw ship develops a full-speed thrust of F = 210 kN. In maneuvering the...
A: For the tug given there to counteract the turning , we have the thrust exerted by tugs must create a...
Q: 5. A student is studying how sound travels through a solid medium by timing the movement of sound th...
A: The speed of sound on the boulder is defined as 560 m.s-1. Let v be defined as the speed of sound. T...
Q: Why can a squirrel jump from a tree branch to the ground and run away undamaged, while a human could...
A: For a squirrel, the surface area exposed to air is large. Drag force due to air exerted by the air o...
Q: This is defined as the transfer of energy across the boundary of a system due to a temperature diffe...
A: In the system and the surroundings, the transfer of energy is heat. It can able to change the system...
Q: The “steam” above a freshly made cup of instant coffee is really water vapor droplets condensing aft...
A: Given: The mass of the coffee M = 250 g. The mass of the evaporated coffee m = 2 g. The initial tem...
Q: *1-4. Determine the resultant internal normal and shear force in the member at (a) section a-a and (...
A: Given Applied force = 500 lb Angle = 30°
pls I need it right now. Follow the decimal tolerance
Step by step
Solved in 2 steps