A 1140-N uniform beam is attached to a vertical wall at one end and is supported by a cable at the other end. A 1960-N crate hangs from the far end of the beam. Using the data shown in the figure, find (a) the magnitude of the tension in the wire and the magnitudes of the (b) horizontal and (c) vertical components of the force that the wall exerts on the left end of the beam. 50.0% 30.0 Beam 1960 N

A 1140-N uniform beam is attached to a vertical wall at one end and is supported by a cable at the other end. A 1960-N crate hangs from the far end of the beam. Using the data shown in the figure, find (a) the magnitude of the tension in the wire and the magnitudes of the (b) horizontal and (c) vertical components of the force that the wall exerts on the left end of the beam. 50.0% 30.0 Beam 1960 N

Glencoe Physics: Principles and Problems, Student Edition

1st Edition

ISBN:9780078807213

Author:Paul W. Zitzewitz

Publisher:Paul W. Zitzewitz

Chapter8: Rotational Motion

Section: Chapter Questions

Problem 90A

See similar textbooks

Similar questions

A wooden door 2.1 m high and 0.90 m wide is hung by two hinges 1.8 m apart. The lower hinge is 15 cm above the bottom of the door. The center of mass of the door is at its geometric center, and the weight of the door is 260 N, which is supported equally by both hinges. Find the horizontal force exerted by each hinge on the door.
Check Your Understanding A 400.0-N sign hangs from the end of a uniform strut. The strut is 4.0 m long and weighs 600.0 N. The strut is supported by a hinge at the wall and by a cable whose other end is tied to the wall at a point 3.0 m above the left end of the strut. Find the tension in the supporting cable and the force of the hinge on the strut.
In Figure 9.21, the cg of the pole held by the pole vaulter is 2.00 m from the left hand, and the hands are 0.700 m apart. Calculate the force exerted by (a) his right hand and (b) his left hand. (c) If each hand supports half the weight of the pole in Figure 9.19, show that the second condition for equilibrium (net =0 ) is satisfied for a pivot other than the one located at the center of gravity of the pole. Explicitly show how you follow the steps in the Problem-Solving Strategy for static equilibrium described above. Figure 9.21 A pole vaulter is holding a pole horizontally with both hands. The center of gravity is to the left side of the vaulter.
In Example 14.3, we found that one of the steel cables supporting an airplane at the Udvar-Hazy Center was under a tension of 9.30 103 N. Assume the cable has a diameter of 2.30 era and an initial length of 8.00 m before the plane is suspended on the cable. How much longer is the cable when the plane is suspended on it?
A 1200-N uniform beam is attached to a vertical wall at one end and is supported by a cable at the other end. A 1960-N crate hangs from the far end of the beam. Using the data shown in the figure, find (a) the magnitude of the tension in the wire and the magnitudes of the (b) horizontal and (c) vertical components of the force that the wall exerts on the left end of the beam. 50.0 Beam 30.0 1960 N (a) Number Units (b) Number Units (c) Number Units
A 1460-N uniform beam is attached to a vertical wall at one end and is supported by a cable at the other end. A 1960-N crate hangs from the far end of the beam. Using the data shown in the figure, find (a) the magnitude of the tension in the wire and the magnitudes of the (b) horizontal and (c) vertical components of the force that the wall exerts on the left end of the beam. 50.0 30.0% Beam 1960 N
A 1260 N uniform beam is attached to a vertical wall at one end and supported by a cable on th other end. A 1960 N crate hangs from the far end of the beam. Using the info on the diagram find the following: a) Magnitude of the tensiossnj on the cable b) the horizontal components of the varce that the wallexerts on the beam c) the vertical components of the force that the wall exerts on th eleft end of the bean
A 1220N uniform boom is supported by a cable perpendicular to the boom, as seen in the figure below. The boom is hinged at the bottom, and an m=2120N weight hangs from its top. Assume the angles to be a=60.7deg and 0=(90.0°- a). Ꮎ Ө ja m Find the tension in the supporting cable. Submit Answer Tries 0/10 Find the x-components of the reaction force exerted on the boom by the hinge (choose to the right as positive). Submit Answer Tries 0/10 Find the y-components of the reaction force exerted on the boom by the hinge (choose upwards as positive). Submit Answer Tries 0/10
A 1220-N uniform beam is attached to a vertical wall at one end and is supported by a cable at the other end. A 1960-N crate hangs from the far end of the beam. Using the data shown in the drawing find the following: What is the magnitude of the tension in the wire? Number N 50.0/ Вeam What is the magnitude of the horizontal component of the force that the wall exerts on the left end of the beam? 30.0° 1960 N Number N What is the magnitude of the vertical component of the force that the wall exerts on the left end of the beam? Number N
A 1204-N uniform beam is attached to a vertical wall at one end and is supported by a cable at the other end A 1515-N crate hangs from the far end of the beam. Find the magnitude of the tension in the wire. The angle theta (9) is 29 degrees and the angle phi () is 53 degrees. The length of the beamis L Вeam ROUND OFF FINAL ANSWER TO THE NEAREST WHOLE NUMBER. INPUT THE SYMBOL OF THE UNIT. NO SPACE BETWEEN THE NUMBER AND THE UNIT.
A uniform drawbridge must be held at a 38o angle above the horizontal to allow ships to pass underneath. The drawbridge weights 55000 N and is 15.0 m long. A cable is connected 3.5 m from the hinge where the bridge pivots (measured along the bridge) and pulls horizontally on the bridge to hold it in place. What is the tension in the cable? Find the magnitude and direction of the force the hinge exerts on the bridge. If the cable suddenly breaks, what is the magnitude of the angular acceleration of the drawbridge just after the cable breaks? What is the angular speed of the drawbridge as it becomes horizontal? What is the velocity of the drawbridge, just before it “hits” (i.e. goes horizontal)?
A 350 N uniform boom is supported by a perpendicular cable attached at 0.7 its length from the boom’s hinge on the floor and makes a angle of 60° with the horizontal floor. At the top end of the boom is attached a 1050 N weight. What is the tension in the supporting cable?