8. A cohesionless (c' = 0 kPa) soil specimen was subjected to a consolidated-undrained triaxial test. The total stress path, the deviator stress, and the pwp are shown in the figures below. No scale is intended in the figure of the stress path. a. Determine o'₁ and 0's at failure. [o'₁ = 345 kPa, o's = 140 kPa] b. Determine the effective friction angle (') of the soil. [$' = 25°] C. Determine the 'A' pore water pressure parameter at failure. [A+ = 0.29] 250 -Deviator Stress q (kPa), 200 150 100 50 200 p (kPa) Deviator stress or PW/P (kPa) 5 10 Vertical strain (%) ---PWP 15 20

8. A cohesionless (c' = 0 kPa) soil specimen was subjected to a consolidated-undrained triaxial test. The total stress path, the deviator stress, and the pwp are shown in the figures below. No scale is intended in the figure of the stress path. a. Determine o'₁ and 0's at failure. [o'₁ = 345 kPa, o's = 140 kPa] b. Determine the effective friction angle (') of the soil. [$' = 25°] C. Determine the 'A' pore water pressure parameter at failure. [A+ = 0.29] 250 -Deviator Stress q (kPa), 200 150 100 50 200 p (kPa) Deviator stress or PW/P (kPa) 5 10 Vertical strain (%) ---PWP 15 20

Principles of Geotechnical Engineering (MindTap Course List)

9th Edition

ISBN:9781305970939

Author:Braja M. Das, Khaled Sobhan

Publisher:Braja M. Das, Khaled Sobhan

Chapter12: Shear Strength Of Soil

Section: Chapter Questions

Problem 12.18P

See similar textbooks

Similar questions

A specimen is subjected to a tri-axial test. The soil specimen is cohesionless. If the shear stress that cause failure is 3oo kPa and the normal stress at failure is only 475 kPa. 1. Determine the angle of shearing resistance. 2.Determine the angle that the failure plane measured from the major principal plane 3.Determine the maximum principal stress at which failure is expected to occur
3. In a drained tri-axial test, a specimen is confined under pressure and axially loaded until failure. The failure conditions of the specimen are analyzed for shear strength. What is the value of the minor principle stress? Half the value of the major principle stress Twice the value of the major principle stress . The same as the confining pressure The same as the cohesion value ● ● ●
A series of unconsolidated undrained (UU) triaxial compression tests have been performed on two "identical" clay specimens. The test results are as follows: Test Number Confining Pressure (kPa)| Deviator Stress at Failure (kPa) 102 96 (i) (ii) 1 2 50 100 Plot the total stress Mohr circles for both specimens at failure (indicate the major and minor principal stresses on the plot). Draw the total stress Mohr-Coulomb failure envelop (i.e., the "p=0" envelop). Estimate the undrained shear strength.
Triaxial tests performed on samples of aeolin sand. The failure conditions in terms of effective stress are (ov, 0h) = (515, 100), (1250, 200), (3500, 400), and (5325, 800) kPa. Using (s, t) space, determine the cohesion and friction angle. What is the orientation of the major principal stress with respect to the failure plane? Determine this graphically.
Assume that both a triaxial shear test and a direct shear test are to be performed on a sample of dry sand. When the triaxial shear test is performed, the specimen fails when the major and minor principal stresses are 80 and 20 lbs/in^2, respectively. When the direct shear test is performed, what shear strength can be expected if the normal stress is 4000 lbs/ft^2? Show all work.
2. A series of consolidated, undrained triaxial tests were carried out on specimens of a saturated clay under no backpressure. The test data at failure are summarized: Confining Pressure (kPa) Deviator Stress (kPa) Pore Water Pressure (kPa) 150 192 80 300 341 154 450 504 222 a. Draw the Mohr circles and find the cohesion and friction angles in terms of effective stresses. b. Compute Skempton’s A-parameter at failure for all three specimens. c. Is the soil normally consolidated or overconsolidated? Why? d. Another specimen of the same clay that was consolidated under a cell pressure of 250 kPa was subjected to a consolidated, drained triaxial test. What would be the deviator stress at failure?
Assume that both a triaxial shear test and a direct shear test are to be performed on a sample of dry sand. When the triaxial shear test is performed, the specimen fails when the major and minor principal stresses are 80 and 20 lbs/in^2, respectively. When the direct shear test is performed, what shear strength can be expected if the normal stress is 4000 lbs/ft^2?
2- A three-axis compression test has been performed on the clay sample, which has been comprehensively and normally strengthened to a stress of 300 kPa and a specific volume of 200. The values of q and volumetric strain are measured at axial strain of 0, 2 and percent (rupture). The value of N is equal to 300 and Landa is equal to 0.2. Draw a diagram of all- round stress on the initial all-round stress in terms of slicing on the initial all-round stress:.
Assume that both a triaxial shear test and a direct shear test are to be performed on a sample of dry sand. When the triaxial shear test is performed, the specimen fails when the major and minor principal stresses are 80 and 20lb/in2, respectively. When the direct shear test is performed, what shear strength can be expected if the normal stress is 4000 lb/ft2? Kindly get right answer with explaination steps
A CID TXC test was performed on a sample of sand. At the end of consolidation, the back pressure was 140 kPa, and the cell pressure was 340 kPa. At failure, the deviator stress was (ơ1 – 03)f = 200 kPa. a. What was the total pore water pressure, u, at failure? b. Calculate the principle effective stresses, ơi' and os', at failure. c. Calculate the friction angle, d', for this soil.
20. A cohesionless sand sample was subjected to a triaxial shear test. Failure occurred when the normal stress is 400 KPa and the shear stress is 250 KPa. a. What is major principal stress? b. What is the minor principal stress
A sand sample is subjected to direct shear testing. Two tests areperformed. For test 1, The sample shears at a stress of 2500 psf whenthe normal stress is 4000 psf.Test 2, The sample shears at a stress of 3500 psf when the normalstress is 6000 psf. Determine the following:a) Angle of Internal frictionb) Value of cohesionc) Compute the shear stress at a depth of 12 ft. if the unit weight ofthe soil is 150 pcf